A multi circuit calculation method is suggested for calculation of the current of the damping winding bar and a method of data transfering is offered to monitor damping winding.
同时针对阻尼绕组提出了用多回路法计算阻尼条电流的方法，并提出一种数据传递方式实施对阻尼绕组的监测。
According to the feature of distribution network structure, a practical short circuit calculation method based on fault current compensation and actual phase sequence presentation is put forward.
根据配电网的结构特点，提出了一种基于故障补偿方法与实际相序表示方法相结合的配电网短路电流实用计算方法。
Based upon the analysis of an equivalent circuit for distribution transformer with three windings, an engineering calculation method for the reactance and parameters of this transformer is introduced.
在分析研究三绕组配电变压器等效电路的基础上，介绍了三绕组配电变压器阻抗及等效电路参数的工程计算方法。
This article presents a digital type electromagnetic radiation measurement system along with its schematic circuit diagram, high speed discrete data sampling method and FFT calculation methods.
本文详细介绍电磁辐射数字化测量系统，给出了电路原理图，离散化数据高速采样方法及FFT计算方法。
Expertly using node voltage method and mesh current method is the key of flexibly mastering circuit parameter calculation method and technique.
熟练运用节点电压法与网孔电流法是灵活掌握电路参数计算方法与技巧的关键。
Analyzes the method of auto balance, parameter calculation, hardware circuit and software flow chart of electric bridge of NDP in the non -destructive testing of EED.
分析了NDP在电火工品无损检测中电桥自动调平衡的方法、参数计算及硬件电路和软件流程图。
This method is able to make the analysis and calculation of the transistor amplifier circuit tend to be simplified.
使用这种方法，可以使晶体管放大电路的分析和计算趋于简单化。
Because the calculation method is accomplished by MATLAB Tool, it is in favor of realizing design and simulation of high-frequency chain switch power supply circuit.
由于该计算方法是在MATLAB环境下进行，有利于进一步实现高频链开关电源电路的设计和仿真。
The current calculation to the voltage plateau width of RF-SQUID tank circuit volt-ampere curve has been discussed in the paper. A proper calculating method is suggested.
本文讨论了通常RF - SQUID谐振电路伏安曲线上电压平台宽度计算中的问题，并提出了一种比较合理的计算方法。
Method of calculation for the non-contact IC card chip coupling power supply and the read and write distance were analyzed, and the relative low-voltage circuit designs were introduced.
分析了非接触式IC卡芯片耦台电源及读写距离的计算方法，并简要介绍了相关低压电路的设计技术。
A practical calculation method is given. With the parameters of the impulse circuit the wave front and tail and the voltage efficiency can be calculated.
文中给出实用计算法，以便根据冲击回路参数估算操作波的波头、波尾和电压效率。
The method of fluid circuit calculation was available according to the fluid network of water system.
对水系统建立整体模型，根据水系统的流体网络图形，得出一种流体回路计算方法。
Analysis the character of hydrodynamic calculation for natural circulation of industrial boiler and give the recommendation of calculation method for simple and complex circulation circuit.
分析工业锅炉自然循环的水动力计算特点，对简单及复杂循环回路的计算方法提出建议。
The proposed method doesn't need hardware synchronization circuit and can perform the calculation of fundamental positive sequence component of the supply voltage in real time.
这种方法不需要硬件同步电路，能实时地计算电源电压中的基波正序分量。
This paper presents that short circuit current calculation based on calculation curve method can. be accomplished by digital computer, and describes the programming for practical application.
本文将运算曲线法计算短路电流由手算改为计算机完成，并介绍了实际应用时程序设计的方法。
A matrix perturbation method for the calculation of errors in precision electro-magnetic measuring circuits caused by small variation of circuit parameters is described in this paper.
本文提出用矩阵微扰法计算精密电磁测量线路的参数发生微小变化时引起的误差。
Iintroduce basic calculation idea of ventilation network nodes analysis method and numerical solution on circuit wind flux method.
简要介绍了网络节点法求解的基本思想和回路风量法的数值解法。
The calculation time of cascade circuit was reduced by using of the chase after method of tridiagonal equations.
对互联电路的计算，可利用三对角线方程组的追赶法，减小了计算量，提高了计算速度。
The solve of the loop power networks can be got directly through circuit current method, but the complex calculation are also needed.
环式电网的求解一般可直接采用回路电流法，但需要进行繁琐的运算。
The current calculation to the voltage plateau width of RF-SQUID tank circuit volt - ampere curve has been discussed in the paper. A proper calculating method is suggested.
本文讨论了通常RF - SQUID谐振电路伏安曲线上电压平台宽度计算中的问题，并提出了一种比较合理的计算方法。
By means of circuit topology theory and loop current method, simulation and calculation are performed on the 12-phase power winding of an induction generator with rectifier load system.
为了对异步发电机十二相功率绕组带整流负载系统进行仿真计算，采用了基于电路拓扑理论的回路电流法。
This paper introduces the concrete steps to short-circuit current calculation method and calculation.
本文主要介绍了短路电流计算的具体步骤和计算方法。
This article explains power selection, adjustment and protection of control transformer and calculation method on secondary short circuit current.
阐述了控制变压器功率选择、校验、保护及二次短路电流的计算方法。
The short circuit current calculation is required for choosing equipment and current carrying conductor, setting of the rely and automation, confirmation of the short circuit current limiting method.
电气设备和载流导体的选择、继电保护、自动装置的整定、限制短路电流措施的确定都需进行短路电流的计算。
The accuracy of equivalent circuit method can be effectively improved if the calculation of PM leakage permeance is accurate.
准确计算永磁漏磁导可以有效提高等效磁路法计算精度。
After the analyses of circuit theory of analogue voltage-to-frequency ratio converter, the design requirement of component parameters and the calculation method are presented.
分析了模拟电压一频率比变换电路原理，给出了元件参数的设计要求及其计算方法。
After the analyses of circuit theory of analogue voltage-to-frequency ratio converter, the design requirement of component parameters and the calculation method are presented.
分析了模拟电压一频率比变换电路原理，给出了元件参数的设计要求及其计算方法。
应用推荐