This paper presents a chopper adapting principle of rotor's resistance of induction motor, develops a two loops speed governing system, and gives computer simulation results.
本文提出了绕线式感应电机转子回路电阻的斩波调节原理，设计了双环调速系统，并进行了计算机辅助设计和仿真研究。
A method of stepping motor driver circuit was given, composed by a chopper type current mode switch regulator and a monolithic stepping motor driver TA8435H.
提出采用斩波式电流型开关电源结合单片式步进电机驱动器TA8435H，构成一种电机驱动电路的方案。
Described in this article is the working principle of chopper speed control system for wound rotor motor.
介绍了一种转子绕线式电动机斩波调速系统的工作原理。
The fuzzy logic controller designed in this study determines the required angular used in the DC chopper control based on motor speed error and its change.
设计的模糊控制器以电机的转速偏差及转速偏差率为输入，输出量用于控制斩波调速时的导通角。
In addition, the integrated proportional-integral controller, RFI filter, and brake chopper and extensive motor-protection functions ensure reliability and provide significant energy savings.
另外，整体的比例积分控制器、RFI过滤器，制动斩波器和各种电动机保护功能确保其可靠性，并有效节省能量。
The hardware circuit is simple, software programming is short. The satisfactory results are obtained through controlling Chopper for a DC motor.
该调制器硬件电路简单，软件编程方便，对直流电动机实行斩波控制取得了满意的效果。
When designing the step motor drive circuit of 5 phase 10 pat, 89c2051 is adopted as the Loop allotter. The VMOS is adopted in power elements. It is designed as chopper-type constant current circuit.
设计五相十拍步进电动机驱动电路时选择了89c 2051作为环形分配器，而功率器件选用电压型的VMOS管。
When designing the step motor drive circuit of 5 phase 10 pat, 89c2051 is adopted as the Loop allotter. The VMOS is adopted in power elements. It is designed as chopper-type constant current circuit.
设计五相十拍步进电动机驱动电路时选择了89c 2051作为环形分配器，而功率器件选用电压型的VMOS管。
应用推荐