The three dimensional characteristic of cutter feed motion is considered in the formulation of undeformed radial chip thickness.
在径向未变形切屑厚度公式的推导中,考虑了刀具进给运动的三维特点。
It is found that the surface roughness influenced by wheel speed and grinding depth can be attributed to the changing of undeformed chip thickness.
研究发现:砂轮速度和磨削深度对表面粗糙度的影响都可归结为未变形切屑厚度的改变。
The feed point location of the SIS chip has little effect on the embedding impedance, while the chip thickness obviously does. These results will benefit the development of waveguide SIS mixers.
SIS结芯片馈点的位置对嵌入阻抗没有太大的影响,但芯片厚度的影响非常明显。这些结果对超导SIS混频器的研制有很好的指导意义。
This paper sets up an instantaneous cutting force model for a spiral cylinder cutter by analyzing the linear relationship between micro-unit milling force and instantaneous uncut chip thickness.
应用微分几何理论,给出了圆锥螺旋铣刀几何特性,据此导出了三维非线性铣削力模型,继而采用非线性规划识别切削力系数。
The influence of depth of grinding, feed rate and circular linear speed of the grinding wheel on the grinding forces with respect to the maximum chip thickness of a single active diamond was analyzed.
从单颗金刚石最大切削厚度的角度,分析了磨削深度、进给速度和砂轮线速度对磨削力的影响。
The influence of depth of grinding, feed rate and circular linear speed of the grinding wheel on the grinding forces with respect to the maximum chip thickness of a single active diamond was analyzed.
从单颗金刚石最大切削厚度的角度,分析了磨削深度、进给速度和砂轮线速度对磨削力的影响。
应用推荐