Experimental results indicate that the micro-hardness of electroformed nickel shaped charge liner decreases obviously as the annealing temperature rising and the grains show equiaxed in shape.
试验结果表明，随着退火温度的升高电铸镍药型罩的显微硬度明显降低，内部晶粒呈现等轴晶形态。
The Cu-Al bimetallic liner used in perforating shape charge is studied theoretically and experimentally.
文中对铜铝复合罩在射孔弹上的应用进行了理论及试验上的研究。
It shows that with the increasing of curvature radius, liner thickness, the length-to-diameter ratio of the charge, and decreasing of shell thickness, the velocity of EFP increase.
结果表明：随着药型罩曲率半径、装药长径比、壳体厚度的增大以及药型罩壁厚减少，EFP的速度增大。
It was shown from experimental results that the performance of copper liner shaped charge jets are strongly dependent on the grain size of a initial liner.
研究结果表明，药型罩材料的晶粒度对射流动态延伸特性有重要影响。
Take the big hole perforating charge as example, studied are the parameters of liner by tests.
以大孔径射孔弹为例，用试验的方法对药型罩的各个参数做了初步研究。
This work is of significance and guidance for the design and application of shaped charge with porous liner in the future.
本文的研究工作为多孔材料药型罩聚能装药的设计及其应用提供了新的指导思想。
When carry out simulation of shaped charge penetration that based on ANSYS/LS-DYNA, many kinds of material model of the liner can be used, but the difference between them need to be studied.
基于ANSYS/LS-DYNA的聚能装药侵彻仿真时，药型罩材料模型的选择有多种，但仿真结果之间的差别多大，有待研究。
W type liner that can form annular jet is adopted as the forward charge and the wide Angle shaped charge is adopted as the follow through one.
设计了一种第一级能够形成环形射流的W型聚能装药，第二级采用大锥角聚能装药的串联战斗部，并且通过试验研究了该种战斗部对靶板的毁伤效果。
W type liner that can form annular jet is adopted as the forward charge and the wide Angle shaped charge is adopted as the follow through one.
设计了一种第一级能够形成环形射流的W型聚能装药，第二级采用大锥角聚能装药的串联战斗部，并且通过试验研究了该种战斗部对靶板的毁伤效果。
应用推荐