The particles are adsorbed by interaction of static electricity, Thus settling on the cathode surface.
颗粒受静电作用被吸附而停留在阴极表面上；
If bubbles of hydrogen gas adhere to the cathode surface, plating is prevented around the bubble and a pit in the coating results.
如果氢气泡粘附到阴极表面上，气泡周围的镀覆就会停止，于是形成一个麻点。
With the increase of the magnetic field on the cathode surface, wave amplitude and equilibrium radius of the electron beam increase;
随着阴极表面磁场的增大，电子注注腰半径增大，电子注波动增大；
It was found that the uniformity of the extracted electron beam is satisfactory in spite of individual plasma jets on the cathode surface.
结果发现，所提取的电子束均匀性等离子体射流在个别尽管令人满意的阴极表面。
The forces applied on the molten pool at the cathode surface under the action of an external magnetic field during vacuum arc coating are analyzed.
分析了在外加磁场作用下，真空电弧镀膜中阴极靶面液池的受力情况，导出了液滴喷溅特性受磁场影响的关系式。
Cathode surface, led to the decrease of the internal resistance increases, activity, make Germany sunshine greatly shorten the service life of battery.
阴极表面，导致内阻增大、活性下降，使德国阳光蓄电池的使用寿命大大缩短。
The effects of the cathode surface electric-field and electron initial velocity on the electrode shape and characteristics of electron beam are calculated and analysed.
计算分析了阴极表面电场与电子初(？)对电极形状和电子注特性的影响。
The SEI film formed on cathode surface and the interaction between electrodes based on aqueous binding materials and electrolyte solution would be the hotspot in the fut…
指出在今后的研究中 ，正极表面与电解液间的界面膜 ，以及引入水溶性粘合剂体系后正负极表面与电解液间的相互作用将成为人们关注的热点。
Based on the adsorption of harmful gases on the cathode surface, an equation about the relationship between the cathode lifetime and the pressure was deduced theoretically.
基于杂质气体在阴极表面的吸附，理论推导并得到了阴极寿命与真空度的关系。
The results show that the long electrode gap leads to the positive column which is caused by the climbing voltage on the cathode surface due to the accumulation of positive ions.
结果表明，放电单元采用大电极间距可获得正柱区放电，正柱区的形成是正离子在阴极鞘层区不断积累将电位抬高所致。
During the electroforming, the current density distribution on the cathode surface is decided by the anode profile and its position, which will influence the uniformity of the deposit finally.
在电铸过程中，电铸阳极的轮廓和位置决定了阴极表面电流密度的分布，并最终影响电铸层的均匀性。
Because the height of micro tips on cathode surface can be eroded by the negative current, surface finishing is better in the micro-electroforming by periodic reverse pulse current than pulse current.
由于负向电流可以腐蚀削减铸层表面微观突起的生长高度，因此周期换向脉冲电流微电铸与单向正脉冲电流微电铸相比更易获得较好的铸层均匀性。
The key of cathode surface treatment is the component of glue liquid and the uniform degree of daubing glue, especially whether the carbon grains are transferred into diaphragm and electrolyte or not.
对负极片进行表面处理的关键是浸胶胶液配方及涂抹胶液的均匀程度，特别是负极片表面的碳颗粒是否会迁移到隔膜和电解液中。
This method not only shortens the time of designing complex surface of contour cathode, but also provides a convenience to modify the shape of the cathode later on.
本方法不但缩短了复杂型面成型阴极的设计时间，还能为以后阴极形状的修改提供便利。
This process continues until a continuous and even film coats the entire surface of the cathode.
这个过程一直持续到整个阴极表面被连续，均匀的涂膜所覆盖。
Electric lift oil: containing alkali solution in to parts used as an anode or the cathode, in the current function, remove the process of surface oil parts.
电解除油：在含碱溶液中，以制件作为阳极或阴极，在电流作用下，清除制件表面油污的过程。
The metal products do for plating coating metal cation cathode, formed in the metal surface coating reduction.
待镀的金属制品做阴极，镀层金属的阳离子在金属表面被还原形成镀层。
During the course of the testing, active electron-emission substances from the cathode were deposited continuously onto the surface of the grid.
在测试过程中活性的电子发射物质源源不断地从阴极沉积到阴极表面。
The cathode at the left is raised to a high temperature by the heater, and electrons evaporate from its surface.
左边的阴极被灯丝加热到高温，同时电子从阴极表面蒸发出来。
Surface morphology and composition analysis of the failure emitter of hollow cathode were characterized by using FESEM and EDS.
利用场发射扫描电镜(FESEM)及其附带能谱仪研究了失效空心阴极发射体的表面形貌、元素组成。
The results indicate that it has visible effect on restraining arc discharge and hollow cathode discharge as well as ion nitriding on high-chrome steel material surface.
结果表明，交流脉冲放电在抑制弧光放电和空心阴极效应方面是非常有效的，对于高铬钢材料表面的离子渗氮作用是明显的。
In the condition of big current and high concentration of carbon particles, masses of curled MWCNTs were obtained on the surface of the cathode deposition.
在电弧电流较大，碳粒子浓度较高的情况下，可以在阴极表面生成大量弯曲的多壁碳纳米管。
Lead into reduction reaction steps before, deposition of metal ions in the cathode near the surface or on the surface transformed.
前置转化步骤还原反应前，沉积金属离子在阴极表面附近或表面上发生转化。
Adsorption of thiourea on the copper electrode surface and the effects of thiourea on the cathode electrodeposition were studied by electrochemical method and X ray diffraction.
采用电化学及X射线衍射法研究了硫脲在铜电极表面的吸附作用及其对铜沉积织构的影响。
The evaluating method of sputtering cleanout effect on metal target surface by volt-ampere characteristic of target cathode has been given, which provides effective approach to eliminate...
给出了金属靶阴极表面溅射清洗效果的伏安特性评价法，为克服“靶中毒”提供了有效的技术途径。
The effect of electrolytic temperature, current density and concentration of copper-ion on the surface quality of copper on cathode was investigated.
研究电解温度，电流密度，铜离子浓度等对阴极铜质量的影响，通过目测和金相显微观察的方法对影响效果进行评价。
The insulating resistance on the coating surface of buried pipelines is a very important parameter which is directly concerned with the cathode protection effect.
地下管道涂层表面绝缘电阻是直接关系到阴极保护效果的一项重要参数。
The influence of porosity and active catalyst surface area on the performance of cathode is analyzed as well.
同时分析了孔隙率和催化剂表面积对催化剂层性能的影响。
It runs normally and stably since putting into production, burr on side and bottom edges of cathode copper disappears completely, and the surface physical specifications is the first rate.
投入生产运行以来一直正常稳定，生产出的铜阳极板，荡边及飞边毛刺彻底消失，表面物理规格达全优。
It runs normally and stably since putting into production, burr on side and bottom edges of cathode copper disappears completely, and the surface physical specifications is the first rate.
投入生产运行以来一直正常稳定，生产出的铜阳极板，荡边及飞边毛刺彻底消失，表面物理规格达全优。
应用推荐