This paper presents the main calculating results and analysis of the revamp.
文中给出了对此项改造的主要计算结果及分析。
Analysis the causes and results of the phenomenon that calculating of frictional resistance in industrial pipe-line design is not accurate enough.
分析了目前工业管道设计中存在沿程阻力计算不够准确这一现象的原因及由此产生的后果。
Based on the existing results, this problem is studied deeply in the paper by means of wavelet analysis, simulation, and practical data calculating.
本文在充分吸收已有研究成果的基础上，利用小波分析、模型模拟分析和实际数据计算，从多个方面对这一问题进行了深入研究。
Moreover, an experimental method of touch pin measurement to analysis solder joint shapes was put forward, the results show the calculating results and the experimental results were identical well.
提出了一种用触针测量法研究焊点三维形态的实验方法，并对计算结果和实验结果进行了比较，结果表明，计算结果与实验结果吻合良好。
The paper presents a kind of analysis of frequence- time relation according to characteristic of dopller signal and gives calculating results of a practical signal.
本文根据多卜勒信号的特点，提出一种分析频率—时间关系的方法，并给出一实际信号的计算结果。
Based on the analysis of the experimental data and the research results reported in references, the practical calculating equation of the ultimate stress in unbonded post tensioning is proposed.
在分析国内外大量试验数据和文献研究的基础上，建立了无粘结预应力筋极限应力实用计算方法。
In the analysis of fluid FEA, mapped mesh method is helpful to reduce the calculating error, avoid divergence and obtain more accurate results.
在流体有限元分析中，采用映射网格不仅有助于减少由于网格划分带来的计算误差，还能防止运算发散，有利于获得更精确的结果。
The formulas of calculating range and bearing for circular array are derived, and ranging performance are analysed theoretically. The simulation results show that the theoretical analysis is correct.
文中给出了圆周阵的测距、测向公式，并从理论上分析了测距性能，计算机仿真结果验证了理论分析的正确性。
At last, some cases are analyzed to check the theoretical schemes and calculating programs. The results of 3d fracture network seepage are applied to the block system for progressive failure analysis.
最后，采用算例对理论分析过程和计算程序进行检验，并将三维结构面网络渗流分析结果应用到块体系统渐进失稳分析中。
Based on the improved-source-analysis technique, the method calculating the contribution value of suspension dust on the receptor was amended and the results were tested and verified.
在二重源解析技术基础上，改进了扬尘对受体贡献值的计算方法，并对结果进行了验证。
The experiment results were tested by calculating the number of tubules in microscopic obversation and computer image-analysis.
采用光镜下记数管腔数及计算机图象分析对结果进行测定；
In calculating on the basis of the results painted a screw expansion of the expansion process of pressure, temperature changes in relations with the corner of the map and a detailed analysis.
在计算结果的基础上描绘了螺杆膨胀机膨胀过程内工质压力、温度随转角的变化关系图，并进行了详细的分析。
In calculating on the basis of the results painted a screw expansion of the expansion process of pressure, temperature changes in relations with the corner of the map and a detailed analysis.
在计算结果的基础上描绘了螺杆膨胀机膨胀过程内工质压力、温度随转角的变化关系图，并进行了详细的分析。
应用推荐