By the use of a finite element method the authors have calculated the stress and rigidity of a main reduction gear box case body for a certain type of cement mill.
应用有限元法对某型水泥磨机主减速齿轮箱箱体的应力和刚度进行了计算。
With three dimensional finite element method, the author analysed and calculated the stress of the dam section with erecting bay in the Zuojiang water resources pivotal project.
利用三维有限元法分析计算了左江水利枢纽安装间坝段的应力。
Methods Loads were on the superior surface of the sacrum of the TDFEM and supporting on the ischial tubercle to imitate the SSS and calculated the stress on the surface of sacroiliac joint.
方法建立骶髂关节与骨盆三维有限元模型，且骶骨上面加载，双侧坐骨结节为支撑点，分析骶髂关节面的应力分布特点。
The researchers figured out water stress with a computer model that calculated how much water trees were getting in comparison with how much they needed.
研究人员通过一个计算机模型计算出了水分胁迫情况，该模型将之与树木所需水分进行比较，计算出树木实际获得的水分。
Under the condition of three kinds of nonlinearity the stress and strain distribution of the road wheel is calculated with finite element analysis software ANSYS.
建立了负重轮的三种三维有限元力学模型，在考虑三重非线性的情况下，用ANSYS有限元分析软件计算了负重轮的应力应变分布。
Then, the response of the SCS to Typhoon Imbudo is examined using POM model, which is driven by the wind stress calculated above by the wave model.
其次，采用上述计算的海面风应力作为POM模式的驱动，研究了南海流场和温度对于台风的响应。
The thermal stress distribution of the stainless steel lined composite steel pipe prepared by centrifugal-SHS process was calculated by the finite element method under thermoelastic assumption.
用有限元方法计算了铝热离心法制备不锈钢内衬复合钢管过程中的残余热应力分布。
The stress and deformation of crankshaft are calculated by finite element method with six load boundary conditions and three displacement boundary conditions.
分别采用六种载荷边界条件和三种位移边界条件对曲轴应力和变形进行了有限元分析；
With the welding spot fatigue lifetime pre-estimation method, by combination of the finite element analysis and stress calculation, the welding spot fatigue damage under actual load can be calculated.
采用焊点疲劳寿命预估方法，通过有限元分析并结合应力计算，即可计算出实际载荷工况下的焊点疲劳损伤。
Through analysis of the calculated results, some suggestions are proposed from the viewpoint of basic temperature difference and temperature stress.
通过对计算结果的分析，从基础温差和温度应力的角度，提出了认识和建议。
The calculated results indicate that the above two theories conform to reality better than the classical theory, the radial stress and the longitudinal internal force are more reasonable.
计算结果表明，上述两种理论比经典理论更加符合实际，径向分布应力和纵向分布内力更加合理。
The laws of casing stress changes caused by inner casing pressure changes are calculated by simulation.
模拟计算了套管内压变化引起套管应力变化的规律。
Secondly, the global coordinates and stress values of the points are calculated by using standard isoparametric interpolations, the node coordinates and the known node stresses.
第二，用单元的结点坐标、结点应力以及等参插值函数，插值计算这些点的总体坐标及应力。
The calculated results of stress distribution and displacement distribution indicate that the deformation of the small intestine is small and acceptable.
小肠肠道弹性变形分布和应力分布的计算结果表明，该驱动方式对人体是无损伤的。
The paper calculated, designed and checked the stress of each part of fixture, which has reached the scope of the needs.
文章计算、设计并校核了卡具各部分的应力，均达到了需用范围。
The calculated results of stress and displacement are approximately consistent with the measured results.
应力和位移的计算结果和测量结果基本一致。
Main conclusions: the wave-proof plate is safe when the permissible stress of the selected material is greater than the maximum calculated stress's 3.5 times of it.
主要结论：所选材料的许用应力大于通过该种方式计算得到的该防浪板的最大应力的3.5倍时，该防浪板是安全的。
The field transfer matrix and point matrix are derived, and the inner force, stress and deflection of thin-walled box girder are recursivly calculated.
提出一种薄壁箱梁剪力滞后分析的传递矩阵法，实现了连续箱梁桥位移、应力及内力的一维递推求解，给出了相应的场矩阵和点矩阵。
By setting up finite element model, the load stress and the warping stress of the two materials pavement are calculated and compared.
建立有限元模型，计算配置两种材料道面的荷载应力与翘曲应力并进行比较。
With the way to solve the distortion effect problem by the flexible foundation method, the distortion stress was calculated after solving the cross-section distortion Angle.
分析畸变效应时采用了弹性地基梁法的求解思路，在求出截面畸变角后，计算畸变应力。
It have proved the horizontal crustal stress far strong the vertical crustal stress in underground tunnel by a calculated example (that tallies completely with reality conditions).
通过计算实例证明了地下隧道水平地应力远大于其竖向地应力(这一点与实际情况是完全吻合的)。
The image force acting on the piezoelectric screw dislocation and the generalized stress on the surface of rigid line are calculated.
导出了作用在位错上的像力和刚性线夹杂表面剪应力和电位移的解析表达式。
Thus, the velocity of stress wave can be calculated.
从而可以得到应力波的传播速率。
Displacement response to aerodynamic excitation is calculated based on the modal parameters and stress response is obtained by finite differencing of the displacement.
然后根据模态参数计算叶片对气动激励的位移响应，并通过对位移响应的有限差分计算应力响应。
According to the calculation results, the fatigue life of gears is calculated by limited life design theory and the contact stress and fatigue life are obtained.
根据计算结果，应用齿轮有限寿命设计理论对齿轮疲劳寿命进行计算，得到齿轮的接触应力和疲劳寿命。
According to the engineering plastic theory the thermal stress on the cylinder are calculated and analyzed from the measured results.
本文就调峰机组汽缸壳体热应力测试结果，根据工程塑性理论，进行了分析处理。
The thermal stress distribution can be obtained from the calculated result of temperature field in the packaging.
然后，根据温度场的分布结果计算出模块内部热应力场的分布状态。
The thermal stress distribution can be obtained from the calculated result of temperature field in the packaging.
然后，根据温度场的分布结果计算出模块内部热应力场的分布状态。
应用推荐