Indeed, a study in 2007 calculated the climate mitigation benefits of the ozone treaty as totalling the equivalent of 135bn tonnes of C02 since 1990, or a delay in global warming of seven-12 years.
事实上，2007年的一项研究曾计算出这项臭氧保护条约对减缓气候变化的利处：自1990年以来共减少了1350亿吨二氧化碳当量的排放，或者说，推迟全球变暖7 - 12年。
Think Time specifies the programmatically-calculated time delay that is observed for each user when this test is run with multiple virtual users.
ThinkTime指定当测试由多个虚拟用户运行时，对于每个用户观测的程序性计算的时间延迟。
In order to study adaptive traffic signal control method, intersection delay should be carefully analyzed and calculated.
为了研究交通信号的自适应控制方法，需要对交叉口延误进行定量的分析与计算。
The theory and characteristics of microwave optical fiber delay line are introduced, and its performance (sensitivity, dynamic range) is analyzed and calculated in detail.
介绍了微波光纤延迟线的原理和特点，并对微波光纤延迟线的性能(灵敏度、动态范围等)进行了详细的分析计算。
It is also recognized that the experimental values of overload delay effect zone size are considerably greater than the calculated values suggested by the above mentioned models.
并发现各模型计算中所假定的迟滞影响区，均比实测的超载迟滞影响区要小得多。
The alert temperature of gun tube was calculated by method of real-time temperature and method of delay-time temperature and the two methods were compared.
分别用延迟温度报警法和实时温度报警法计算了厚壁身管火炮的报警温度，并对这两种方法进行了比较。
The methods for measuring flight time and delay time under laboratory conditions are described and a comparison between measured and calculated values is made.
提出在实验室条件下测量飞行时间和滞后时间的方法；对它们的实测值和计算值作了比较。
The risetime of electrical pulse and the delay-time between the linear model and nonlinear model are calculated in this paper, and the results match the experimental measure.
论文中利用建立的物理模型对开关输出电脉冲的上时间，以及开关线性波形和非线性波形之间的延迟时间进行计算，结果与实验测量数据相吻合。
In order to optimize the coordinate signal control paraments, intersection delay should be carefully analyzed and calculated.
为了对干线交叉口信号协调控制参数进行优化，需要对交叉口延误进行定量分析。
With the correlation technique, direction and speed of the infrasound can be calculated by computing the time delay of each detector and by using geometric knowledge.
利用互相关技术，计算信号在不同传感器上的时间延迟，再由平面几何原理，得到波的方位和波速。
The phase delay can be calculated and the placement of the fast and slow axis of the wave plate can be marked after analyzing the curve.
分析实验曲线，可计算出波片的延迟量，同时也可确定波片快慢轴的方位。
The phase delay can be calculated and the placement of the fast and slow axis of the wave plate can be marked after analyzing the curve.
分析实验曲线，可计算出波片的延迟量，同时也可确定波片快慢轴的方位。
应用推荐