You can view these statistics to help determine how your cache is performing, and whether the size of your cache is appropriate.
可以通过查看这些统计来帮助确定您的缓存是如何执行的，以及您的缓存大小是否恰当。
Data source statement cache size specifies the number of prepared JDBC statements that can be cached per connection.
数据源语句缓存大小指定每次连接可以缓存的经过准备的jdbc语句的数量。
Thus, performance is best if the cache size is set to the maximum number of active instances expected during a typical workload.
因此，在典型的工作负载过程中，如果将缓存大小设置为预期的最大活动实例数，则性能是最佳的。
The data source statement cache size can be tuned using a few different methods.
可以使用一些不同的方法来调优数据库语句缓存大小。
This is also an in-process cache, thus limited in size.
这也是一个进程内缓存，因此大小有限。
Due to low memory conditions or administrative modification of the cache size via the admin console, the cache might (temporarily) be configured such that it never caches data at all.
由于低内存条件和通过管理控制台进行了缓存大小的管理修改，因此可能将缓存配置(暂时)为完全不缓存数据。
The other option is to iteratively increase the cache size and run the application under peak steady state load until the PMI metrics report no more cache discards.
其一种方法是迭代式的增加缓存大小并在峰值稳定状态负载下运行应用程序，直到PMI指标不再报告任何缓存丢弃操作。
This example USES a fixed size cache, such as 1 MB of storage or 100 cached items.
这个示例使用了一个固定大小的高速缓存，如1MB的存储器或100个高速缓存项。
Therefore, when tuning the cache size for your environment, allocate sufficient in-memory and disk space for the cache entries.
因此，在为您的环境优化缓存大小时，请为缓存项分配足够的内存和磁盘空间。
文档缓存大小。
Once you've set the initial options and configured the directory and cache size you want, there's no need to change anything.
一旦设置了初始化选项并配置了期望的目录和高速缓存大小，就不需要再做任何改动。
In the current release it's possible to define a maximum cache size but many times it's difficult to define an appropriate number because it depends on the application.
在当前的发布中，可以定义一个最大缓存大小，但是很多时候很难定义一个合适大小的缓存，因为这依赖于应用。
You should specify a cache size of about 50mb to ensure that there is enough space for all the classes.
应该将缓存的大小指定为大约50MB，从而确保能够存储所有的类。
The size you specify for the statement cache size should be relatively large. Typically, this is in the range of 100-200.
您为语句缓存指定的大小应当相对较大，一般在100到200之间。
The size you specify for the statement cache size should be relatively large. Typically this is in the range of 100-200.
您为语句缓存指定的大小应当相对较大，一般在100到200之间。
Statistics such as the cache size, used entries, cache hits and misses, and many more provide a good overview of their usage patterns.
诸如缓存大小、已使用的条目、缓存命中率和未命中率之类的统计数据以及更多的数据可以很好地概述缓存的使用模式。
Check that the cache size is sufficiently large and that the cache hit ratio is high for each of the dynamic SQL statements being executed.
对于每个被执行的动态sql语句，请检查高速缓存是否足够大且高速缓存的命中率是否较高。
The hit ratio is a function of the cache size, the amount of underlying data, and the data access pattern.
命中率与缓存大小、底层数据的数量和数据访问模式有关。
Benchmark tests are not perfect, but are a better indicator of microprocessor speed than clock rate or cache size specifications.
对双核内存测评结果不是很好，但是微处理器处理速度和时钟频率或是缓存空间相比要很好的多。
The cache size specifies the maximum number of entries that the cache can hold.
缓存大小指定缓存可以容纳的最大条目数。
For example, an administrator can figure out what is the maximum number of database connections or optimum number for prepared statement cache size that should be used to handle a real world load.
例如，管理员可以决定数据库连接的最大数量，以及处理实际工作负荷应该所用的预备状态缓存空间的最优数量。
It specifies the interval at which the container attempts to remove unused items from the cache in order to reduce the total number of items in the cache to the value of the cache size.
它指定容器每隔多长时间尝试将不使用的项从缓存中删除以将总项数减少到缓存大小。
The value is not a number of resulting entries, but more of an indicator of how big the cache size for the results should be.
此值不是所得到的条目数，而是指示结果缓存大小的值。
The non-computational file cache size in MB
非计算文件缓存大小，以 MB 为单位
Looking back at the chart in Figure 11, before tuning the data source statement cache size, the number of statements discarded was over 1.7 million.
回过头来看图9中的表，在调优数据源语句缓存大小之前，被丢弃的语句的数量超过170万条。
Note that if this variable is set too large, the Lotus Quickr server spends more resources to handle the larger cache size.
注意，如果变量设置太大，LotusQuickr服务器需要消费更多资源才能处理更大的缓存大小。
The percentage of file cache size against the true memory size
文件缓存大小占实际内存大小的百分比
The statement cache size can be configured by navigating to Resources => JDBC => Data sources => data_source => WebSphere Application Server data source properties.
要配置语句缓存大小，可以导航到Resources =>JDBC =>Datasources => data_source =>WebSphereApplicationServerdatasourceproperties。
There's an algorithm you can use to tune the EJB cache size of the container that calculates the average EJB cache requirements based on the different kinds of beans.
有一个算法可以用来调整容器的EJB缓存大小，它根据不同类型的bean来计算平均eJB缓存需求。
You specify cache size using the parameter -Xscmx[k|m|g]; this parameter only applies if a new cache is created by the JVM.
使用参数-Xscmx[k|m|g]指定缓存的大小；这个参数只应用于JVM创建新缓存的情况。
应用推荐