The program in single chip computer is C51 program, using the interrupt that UART receive end and the interrupt that UART send end.
单片机端通信程序采用C51编程，使用UART接收结束中断、UART发送结束中断。
Presents the internal configuration of LCD module MSC-G12864 and its operation method. On these, discuss the interface with MCU and gives out programming method and some C51 program.
以应用广泛的MSC -G12 864液晶显示模块为例，在简单介绍内部结构与操作方法的基础上，讨论了其与单片机的接口以及相应的C5 1编程方法和程序。
C51 program has been set the schedule of reading and writing status for controller. It can work out some operations of writing instruction code, writing data code, clear screen and roll screen.
用C51程序设置对于控制器的读、写状态的时序，从而实现对于控制器的写指令代码、写数据代码、清屏幕、屏幕滚动功能的操作。
The software designs adopt assembly language, C51 language to compile data sampling program and programs on protocol processing and data transfer conducted to USB interfacing chip.
软件设计中采用汇编语言、C51语言编写数据采集程序和对usb接口芯片进行协议处理及数据交换的程序。
During the use of C51 language, the problems of the configuration of the file, edit program, compile program, link program are analyzed and the methods of which are given.
在C51语言应用过程中，对配置文件设置、编写应用程序、编译应用程序、连接应用程序时容易出现的问题进行分析，并提出解决的方法。
The hardware interface between the X5045 chip and the single-chip microcomputer AT89C52 and its corresponding software program using C51 are described.
给出了X5045芯片与AT89C52单片机的硬件接口电路，用C51语言编写了其软件接口程序。
The hardware interface between the X5045 chip and the single-chip microcomputer AT89C52 and its corresponding software program using C51 are described.
给出了X5045芯片与AT89C52单片机的硬件接口电路，用C51语言编写了其软件接口程序。
应用推荐