This paper presents a computer simulation model of the cardiovascular circulation system, which describes the blood flow dynamic law in the cardiovascular system by the state equation.
建立一种心血管循环系统的计算机仿真模型，即描述心血管循环系统内血流动力学变量变化规律的状态方程。
The engine mathematical model in the simulation system is obtained by approximation of testing data of an actual engine with a series of small deviation and linearized models.
仿真系统中的发动机数学模型是用一系列小偏差线化模型去逼进某一实际发动机的试车数据而得到的。
According to BLDC mathematical model and the movement principle, a simulation model of BLDCM control system by the SIMULINK and PSB block of software MATLAB is built in this paper.
根据无刷直流电机的数学模型和运行原理，通过MATLAB软件的SIMULINK和PS B模块，搭建了电机及整个控制系统的仿真模型。
For linear model, this paper proposes a linear path based backbone algorithm. Simulation results shows system lifetime of this algorithm is improved by 12% of algorithm of plane model.
对于线性模型，本文提出了一种基于线性路径的骨干网算法，仿真实验表明该算法的系统生命期比平面模型的算法提高了12%左右。
The system optimization model is built by methods of unit process simulation, process system simulation and system optimization.
采用“单元模化—系统模化—系统优化”构造出该冶金系统的优化工序模型。
Effectiveness of the method in networks training speed, anti-interfering ability and identifying veracity of sensor faults are proved by simulation and model test of conditioning system.
通过仿真和空调系统模型试验证明了该方法在网络训练速度，抗干扰能力及各种传感器故障识别准确率等方面的有效性。
Some references and bases for the room air-conditioner refrigeration system simulation and component optimization design were provided by the capillary's model in this paper.
利用本文的毛细管模型，可为房间空调器制冷系统的仿真及部件结构优化设计提供参考和依据。
The dynamic simulation model based on the multi-rigid-body theory of the passenger restraint system for side impact of a car is created, and its validity is verified by tests.
针对某轿车建立了基于多刚体理论的侧面碰撞乘员约束系统动态仿真模型，并依据试验结果进行了模型的有效性验证。
Finally, the feasibility of model predictive control can forecast reasonable inventory level and control dynamic and uncertainty supply chain system are shown by the simulation results.
最后，仿真结果表明，模型预测控制技术在预测合理库存水平以及控制动态、不确定的供应链系统是可行的。
This paper established a simulation model of guided system based on vehicle dynamics, with the effect of all main factors on guided performance investigated by simulation.
根据车辆动力学建立了引导系统的仿真模型，通过仿真研究了各主要因素对引导性能的影响。
With ASPEN PLUS software, the paper simulates the quench system by neural networks, constructs the NN model to complete the simple simulation and calculation of the quench system.
以aspenPLUS软件为平台，用神经网络对急冷系统进行了严格模拟，建立了神经网络模型，可用于急冷系统简单的模拟计算。
A static relations curve of the main movement parameter is given by means of computer simulation and by an established mathematical model, and the system dynamic characteristic analyzed.
利用所建立的数学模型，采用计算机模拟的方法，得到了主要参数间的静态关系曲线，并分析了系统动态特性。
This paper studies the dynamic mathematical model of the dual fuel servo system in gas turbines by the methods of the theoretical modelling and digital simulation.
采用理论建模和数字仿真方法，对燃气轮机双燃料伺服系统的动态数学模型进行研究。
Based on systematic analysis of integrated disease management system of rubber powdery mildew, a control decision model was established by using computer simulation.
根据综合治理系统的系统分析，用电算模拟的方法建立了橡胶白粉病防治决策模拟模型。
The analysis model of image gathering system is proposed. The relationship of system end-to-end information rate with target statistical characteristics is examined by computer simulation.
建立了图像采集系统分析模型，计算机仿真分析图像采集系统端到端信息率与采样目标统计特性的关系。
An optimal control model of an automotive seat vibration system is set up and an experimental analysis of the control system is carried out by electronic circuit simulation.
建立了汽车座椅振动系统的最优控制模型，并利用电模拟方法对控制系统进行了实验分析。
A heat transfer model of the radiant floor heating system is established in this paper, and the temperature field in the floor is obtained by means of numerical simulation.
建立了低温地板辐射供暖系统传热过程的数学模型，通过数值模拟，用有限差分法计算了地板内的温度场。
The simulation model is developed by using the simulation technology of system analysis and taking the Weishan Lake and Luoma Lake water resources system as an example.
以微山湖、骆马湖水资源系统为例，应用系统分析中的模拟技术建立模拟模型。
Then, the whole system mathematical model was established. The system can meet the required property indicators by demonstration of theoretical analysis and simulation.
然后对整个系统建立数学模型，通过理论分析和仿真验证，证明该系统能够满足所要求的性能指标。
By analysing the state transfer of Guangzhou-Shenzhen railway operation system and using expert system technology, a intelligent simulation model for this complicate hybrid system is presented.
通过对广深铁路运营这一复杂系统的分析，采用传统的状态转移与专家系统技术相结合的方法，建立了广深铁路运营仿真平台软件。
The performance evaluation of TV tracker by the scene simulation is studied. An evaluation model and an index system for quantitative evaluation are established.
利用计算机视景仿真技术，对电视跟踪器跟踪性能的检测和评估做了较深入的研究，建立了电视跟踪器跟踪性能评估模型和定量评估指标体系。
Credibility estimation of weapon system simulation model is the key procedure of system analysis, forecast and aided decision reasonably and scientifically by using weapon system simulation model.
武器系统仿真模型的可信性验证是合理地、科学地运用武器系统仿真模型进行系统分析、预测以及辅助决策的关键环节。
So the whole display system, which built with an ordered data structure model by processing the data from MEMS technical simulation with Object Oriented Programming(OOP), is presented.
最后，以面向对象的思想处理MEMS仿真数据，建立了便于管理和操作的数据结构模型；
Through the analysis of the working process of this linkage system, this paper execute the dynamic simulation and optimization of this model by using multi-body system dynamics software ADAMS.
通过对肘杆系统工作过程的分析并利用多体系统动力学软件（ ADAMS）对模型进行了动力学模拟和优化设计。
The ADAMS software is used to build the front suspension and steering system model, and simulation analysis on the model is done by means of wheel flouncing.
本文应用汽车动力学分析软件ADAMS建立了汽车前悬架—转向系统的仿真模型，并采用单轮激振方式对模型的动力学特性进行了仿真分析。
The operation of the simulation model showed that it is completely feasible to study the dynamic behavior of the pneumatic flap gate system of dry docks by using the described model.
通过对仿真模型的运行表明：用所述的仿真模型研究干船坞气控卧倒坞门系统的动态特性是完全可行的。
Then, by integrating the Kriging system and fracture simulation system and using structure and imaging logging data, we constructed an multi-field Kriging estimation model.
然后，采用克里金模型和断裂力学模拟系统，综合构造和成像测井裂缝解释资料，构建多场趋势克里金估计模拟模型。
In this paper, the concept about the applied model of submarine battery is introduced in accordance with the need for its simulation, and possibility of its realization by expert system is discussed.
本文根据潜艇蓄电池仿真的需要，提出了使用模型的概念，并讨论了用专家系统来实现它的可能性。
The simulation results show that by the new model, the actual system capacity can be greatly improved compared with the results by the model with the reverse link only.
仿真结果表明，利用本文的方法，系统的实际容量比单独考虑反向信道时有显著的提高。
The simulation results show that by the new model, the actual system capacity can be greatly improved compared with the results by the model with the reverse link only.
仿真结果表明，利用本文的方法，系统的实际容量比单独考虑反向信道时有显著的提高。
应用推荐