It ray lightly on the surface of the snow, while the dogs plowed through by main strength.
它在雪面上跑起来倒轻松，可狗却要破雪前进很费劲。
The complicated strength computation of its spare parts can be completed by amending the main parameters of squeeze tube.
在挤压机各零部件的强度计算中，可通过对挤压筒几个主要设计参数的修订，来完成其复杂的计算。
The main factories which influence the strength of pavers and the best mix ratio of paves have been found by orthogonal experiments.
通过正交试验确定出影响路面砖强度的主要因素及路面砖的最佳配比。
It is indicated by analysis that the main causes of difficulty of drawing high strength thick galvanized steel wire are thicker ZnFe alloy coat and higher carbon and manganese contents.
分析大直径高强度镀锌钢丝拉拔困难的主要原因在于锌-铁合金层较厚、钢丝中碳含量和锰含量较高。
The structural strength and flexural rigidity of the fuselage main frame are computed and verified by CAE system software and the results are analyzed.
应用CAE系统软件计算承力密封框的刚度和强度，并分析了计算结果。
The agent is gel with higher strength and elasticity by the common action of polyacrylamide and acrylamide, whose monomers were taken as main agent, and other chemical coagulant aid.
该调剖剂以聚丙烯酰胺和丙烯酰胺单体为主剂，在其他化学助剂共同作用下形成具有较高强度和弹性的凝胶体。
The main effect of water on brittle plastic transition of mafic rocks is embodied by both the change of strength and temperature of brittle ductile transition and brittle plastic transition.
水对基性岩脆塑性转化的影响体现在岩石的强度和脆延性与脆塑性的转化温度两方面。
The stability of inclusion complex was influenced by the strength between cyclodextrins and guest molecule. Hydrophobic bond was main impetus of inclusion process.
在环糊精和客体分子之间的作用力中，疏水键是包合过程的主要作用力。
It is considered that special structure of the dislocation and damage accumulation induced by rolled were main factors to make the fatigue strength of the welded joint reduced after rolled prestrain.
分析认为，辊压后材料中位错的特殊结构和材料内部所形成的损伤累积是疲劳性能下降的主要原因。
Through the strength analysis of the main body, it verifies that blocking-wheel cylinder can bear impact loads by the gyral kilns.
通过对缸体结构的强度分析，验证了挡轮液压缸能够承受回转窑冲击载荷的作用。
The optimum mix and the main effect factor is determined by the strength at 28 days and verified by the regression strength at 90 days.
由28天强度确定了最佳配比和主要影响因素，用回归90 天的强度进行了验证。
The finite element model of steel plate shear wall with silts in frame is established and by which the effect of main silt parameters on its strength and stiffness is analyzed.
建立了带框架的开缝钢板剪力墙有限元模型，分析了主要开缝参数对其强度和弹性刚度等性能的影响。
By means of calculating the shafting torsional strength, a decision of replacing the main shaft by new one, whose bearing diameter is increased, was made reasonably and duly.
通过对轮系扭振强度计算，科学及时地作出了更换主轴的决定，并适当加大了新主轴轴颈直径。
Since the main failure reason of the steel rope is the fatigue of the metal, the fatigue reliability design of the crane steel rope can be executed by means of stress-strength interference model.
根据起重机钢丝绳失效主要是金属疲劳的原理，采用应力-强度干涉模型，对起重机钢丝绳进行了疲劳可靠性设计。
The structure of high web is often adopted in the overhead launching gantrys main girder that are connected by the high-strength bolts.
造桥机主梁一般采用高腹板箱梁结构，主梁之间通过高强螺栓群相互连接。
Under high temperature structure thermal stress caused by different minerals in composition of ore is the main cause to damage micro structure and results in the strength of ore decreasing obviously.
在高温条件下，由于矿石中矿物成分不同所引起的结构热应力，是造成两种矿石微结构损伤的主要原因，由此而形成的微裂隙导致矿石强度明显下降。
The results show that the fracture failure is the insufficient strength caused by pearlite graphitization. Material selection inappropriate is the main reason of pearlite graphitization.
结果表明，弹簧断裂的主要原因为珠光体石墨化导致强度不足，选材不当是发生珠光体石墨化的主要原因。
It can perform straight side stretches. Straight stretch: to strength trainee's action accurate by fixing coax and foot. Main for the dynamics and force training.
它分直向和侧拉两个部分，在直向拉伸部分：以固定髋关节和脚型来加强训练者的动作准确性和着重于力度的训练及强迫性训练。
This paper gives main functions of a general purpose program called SAPFEM for static strength analysis of structure by the finite element method.
本文介绍了作者研制的709机结构有限元静力分析通用程序SAPFEM的主要功能。
This paper gives main functions of a general purpose program called SAPFEM for static strength analysis of structure by the finite element method.
本文介绍了作者研制的709机结构有限元静力分析通用程序SAPFEM的主要功能。
应用推荐