At last, the paper describes the way of anti-noise when the voltage bus signals ar...
最后叙述了延伸总线信号时的抗干扰措施。
At last, the paper describes the way of anti-noise when the voltage bus signals are extended.
最后叙述了延伸总线信号时的抗干扰措施。
For bus architecture, power consumption decrease effectively by reducing turnover rate of bus signals.
对于总线来说，减少总线上的翻转次数，就是降低总线上的功耗。
However, it will also receive bus management signals from the bus itself.
不过，它也将会收到来自总线本身的总线管理信号。
The signals indicate that the spacecraft bus is functioning normally and ready to begin orbital maneuvers and operational testing.
此信号表明，该卫星运转良好且准备好开始轨道演习和操作测试。
The paper introduces the property of PCI Bus, describes the signals and commands of PCI Bus, and focuses on the transfer protocol of PCI Bus.
本文介绍了PCI总线的特点，描述了PCI总线的信号与命令，着重叙述了PCI总线的传输协议。
HART field-bus protocol is used in output of system pressure or differential pressure transmitter, digital signals is transmitted with MODBUS via RS485.
系统压力或差压变送器信号输出采用HART现场总线协议，数字信号传输通过RS485进行MODBUS通讯。
Traditional analysis tools only cover the single low speed bus and test signals in physical layer and data layer respectively.
传统方法只能分析系统中的单一低速总线，分别观测物理层信号和数据层数据进行分析。
Based on the USB bus interface chip CH375, we design the locomotive signals data recording system, and detail the design of communication interface of CH375 and TMS320F2812.
基于USB总线接口芯片CH375，设计了机车信号记录仪数据记录系统，并详细阐述了CH375与TMS320F 2812之间的接口设计。
We proposed a new method to distinguish the lightning strikes and common short-circuit faults on the basis of the characteristic of the bus voltage signals using S-transform.
基于行波特征区分雷电冲击与短路故障有一定局限性，提出一种利用母线电压信号特征识别雷击与短路故障的新方法。
ARINC429 data bus is widely used in avigation electronic system communication. The ARINC429 signals are needed for the repairs of avigation communicate equipments.
ARINC 429数据总线在航空电子系统通讯领域有着广泛应用，要对航空通讯设备进行维修，就一定需要产生ARINC 429信号。
The method of distributing synchronous signals, which delivers signals though CAN bus, is proposed. And the feasibility of this method is analyzed.
提出了一种通过CAN总线分配同步信号的方法，对该方法的可行性进行了深入分析。
Data acquisition signals are communicated with RS485 bus point to point. As a result, installation and disassembly of instruments become heavy loads, and instruments may be damaged easily.
数据信号传输采用一对一寻址的RS - 485总线传输，造成工程开工布线和工程完工后的拆卸工作繁重，甚至可能引起仪器损坏。
The bus and the processor core often run in different clock frequencies, so their interface signals belong to different clock domains.
总线时钟与处理器内核时钟频率不同，因此总线部件与处理器内核间的接口信号需要进行时钟域转换。
Using this feature extraction and classification algorithm, this article classifies the practical acoustic signals from the truck, car and bus.
将上述特征提取及分类算法对实测的卡车、轿车和中巴车三种车型的噪声信号样本进行分类。
Moreover the bus signal priority and the pre-signals are introduced and the bus priority network is planned by using the planning method of urban mass transit network.
对公交优先信号、公交预先信号进行了介绍；应用轨道交通线网规划的方法对公交优先通行网络进行规划；
The four synchronous signals of data collection CARDS are processed by DSP through PCI bus.
采集的四路同步信号经过PCI总线传到DSP处理。
The controller can realize not only the collection, processing and display of the signal, but also the transmission of signals between different nodes through can bus.
该控制器不仅可实现信号的采集、处理、显示，还可通过CAN总线实现不同节点间信号的传输。
According to the principle of power over Ethernet, the method of RS-485 bus power is applied to implement the transmission of 48 VDC and data signals via the same twisted-pair electric cable.
基于以太网供电原理，采用RS- 485总线供电方式，实现48V直流能量与数据沿同一线对的叠加传输。
According to the principle of power over Ethernet, the method of RS-485 bus power is applied to implement the transmission of 48 VDC and data signals via the same twisted-pair electric cable.
基于以太网供电原理，采用RS- 485总线供电方式，实现48V直流能量与数据沿同一线对的叠加传输。
应用推荐