The main function creates a Glib event loop, gets a connection to the session bus, and integrates the D-BUS event handling into the Glib event loop.
main函数创建一个Glib事件循环，获得会话总线的一个连接，并将D -BUS事件处理集成到Glib事件循环之中。
It is expected that GNOME will create wrappers around D-BUS using GObject (indeed these partially exist, integrating D-BUS into their event loop), and that KDE will create similar wrappers using Qt.
预期，GNOME将使用GObject创建包装d -BUS的包装器(实际上这些已经部分存在了，将D - BUS集成入它们的事件循环)，KDE将使用Qt创建类似的包装器。
We then loop, rescanning the SCSI bus (by echoing a command to a special file in the /proc pseudo-filesystem and calling devfsd) until the root device (/dev/sda1 in my case) is present.
然后我们进行循环，重新扫描SCSI总线（通过将命令回送到 /procpseudo-filesystem中的特殊文件，并调用devfsd ），直到出现根设备（我的例子中为 /dev/sda1）。
The troop's stoop on the loop became the top topic at the bus stop.
队伍正在环行道上的服从正在雄共汽车站成了头号话题。
The configuration program of incoming loop, bus coupler circuit, feeder circuit, motor circuit, reactive power compensation and the control power in switchgear was described.
阐述了开关柜中受电回路、母联回路、馈电回路、电动机回路、无功补偿和控制电源的配置方案。
Three soft start-up technique for voltage loop are compared with each other, which are the reference of DC bus voltage gradually increasing, constant charging current and different PI modulation.
电流环软启动通过输出电流指令递增实现，电压环软启动则比较了直流侧电压指令逐步升高法、恒定电流充电法、变PI参数调节法三种策略。
CAN-bus for the control scheme and a node control loop are proposed. TMS320LF2407 DSP is used as the node controller.
采用TMS320 LF 2407 DSP作为节点控制器，设计了CAN总线结构中的节点控制回路。
However, the change of communication architecture from point-to-point to this common-bus approach introduces different forms of time-delay uncertainty in the closed-loop system dynamics.
然而，从点对点到使用公用的通信总线，这种通信方式的改变在控制系统中引入了不同形式的时延。
However, the change of communication architecture from point-to-point to this common-bus approach introduces different forms of time-delay uncertainty in the closed-loop system dynamics.
然而，从点对点到使用公用的通信总线，这种通信方式的改变在控制系统中引入了不同形式的时延。
应用推荐