Philips applied to a series of IIS Bus chip.
适用于飞利浦系列IIS总线芯片。
This is because process execution now needs to be coordinated across the bus, which operates at half the clock frequency of the chip.
这是因为进程执行现在需要跨总线协调，以一半的芯片时钟频率进行处理。
Another architecture, that JW sees coming in the next 10 years is the one where "the network connecting enterprise resources to the cloud is a bus on a single chip."
JW认为下一个十年将会兴起的另一个架构是，连接企业资源到云的网络是一个单芯片上的总线。
This paper focuses on performance estimation of the embedded microprocessor based on the on-chip bus, including on-chip bus modeling, high-level simulation environment building and their combination.
本论文的主要工作即着重于系统芯片中片上总线结构的性能评价研究，包括总线结构的建模、系统仿真环境的建立以及性能评价的方法。
The code below show address assignment for devices attached to the external bus with the chip select number encoded into the address.
下面的代码展示了设备连接至外部总线并将其片选号编码进地址的地址分配。
Introduces how to connect the DSP to PCI Bus in brief and choose the means of using special PCI Bus interface chip to achieve it.
介绍DSP芯片如何桥接到PCI总线，并选择利用专用接口芯片的方法来实现。
With SPI serial bus to carry out the serial correspondence between MCU and voice chip.
使用SPI串行总线可以达到MCU与语音芯片串行通信的目的。
Based on the USB bus interface chip CH375, we design the locomotive signals data recording system, and detail the design of communication interface of CH375 and TMS320F2812.
基于USB总线接口芯片CH375，设计了机车信号记录仪数据记录系统，并详细阐述了CH375与TMS320F 2812之间的接口设计。
The selection principle of bus interface chip and solution of bus conflict are introduced, together with its concrete hardware circuits and software block chart are given.
分析了总线接口芯片选择原则和总线冲突解决方案，给出了系统实现的硬件接口电路和软件实现详细框图。
SPC3 is a intelligence interface chip which is used in the open field bus PROFIBUS-DP.
SPC 3是一种用于PROFIBUS - DP开放式工业现场总线智能化接口芯片。
In this article, to carry the 6-axis motion controller out, a method of using PCI special interface chip PCI9052 to be a interface bridge of PCI bus and DSP (TMS320LF2407), was introduced.
文章介绍了一种采用PCI专用接口芯片pci9052作为PCI总线与DSP (TMS320 LF 2407)的接口桥接器，实现6轴运动控制卡的硬件设计方法。
Then taking DSP chip TMS320LF2407 embedded in CAN controller and CAN232 intelligent CAN adapter card as examples, it illustrates the engineering method of their communicating with CAN bus.
然后分别以内嵌CAN控制器的DSP芯片TMS320 LF 2407和CAN 232智能CAN接口卡为例说明了它们与CAN总线通信的工程实现方法。
This paper introduces a design of a CAN bus adapter system based on a new type of USB chip CH372 for the communication of the CAN bus and the computer.
介绍了一种基于新型USB接口芯片CH372的CAN总线网络适配器系统的设计，提出了一种使用USB接口实现CAN总线网络与计算机连接的方案。
FPGA as controller initialize video decode chip SAA7111A through I2C bus.
FPGA作为控制器，经I2C总线对视频解码芯片SAA7111 A进行初始化。
The DC servo motors are controlled with motion controller LM629 and motor drive chip LMD18200 based on PC104 bus.
在PC 104总线控制下，应用运动控制芯片LM 629和电动机驱动芯片LMD18200实现了直流伺服电动机的控制。
This algorithm is of reference value in the design of industry bus arbiter chip, so does in other systems.
动静态混合算法不仅在总线仲裁器模块设计中具有指导意义，而且在其它控制类芯片中也具有很好的参考价值。
The research and practice of this dissertation complete the design of a bus bridge module which between the on-chip system bus and the peripheral bus.
本论文的研究与实践工作完成了一个片上系统总线和外设总线之间的总线桥模块设计。
The other module is PCI bus interface circuit. PI7C8150B chip of PERICOM Corporation is used to finish transmission of the image data.
另一个是PCI总线接口电路，本设计中采用PERICOM公司的PCI桥接芯片PI7C8150B实现图像数据的传输。
CAN-BUS interface adopts protocol control chip SJA1000 plus receiving and sending chip 82c250. Ethernet interface adopts Ethernet controller RTL8019AS as physical transmission media.
CAN总线接口采用协议控制芯片SJA1000，配以收发器82c250。以太网接口采用以太网控制器rtl 8019as作为物理层传输媒介。
The VHDL program embedded in the FPGA chip includes: interface combine ISA bus and FPGA, serial asynchronous communication module for transmitting and receiving.
该接口卡FPGA芯片内部VHDL程序含：ISA总线与FPGA接口、串行异步通信发送及接收模块。
The essay introduces multi-chip calculator communication system based on RS-485 bus, especially MAX-487 chip and the components of the communication system and gives the flow diagram.
介绍了基于RS-485总线的单片机多机通信系统，重点介绍了MAX-487芯片和通信系统的组成，并给出了流程图。
Therefore, it will have a bright future to develop VLSI chip based on a PCI bus and related a communication protocol.
因此研究开发基于PCI总线接口和通信协议的超大规模集成电路芯片是具有应用前景和市场价值的。
This article presents the design of an evaporator system for use with winding plating equipment based on CAN bus, including its hardware structure chip choice and the design of software.
介绍了基于CAN总线的卷绕式镀膜机蒸镀系统的设计方法，阐述了系统设计的硬件及其芯片选用并介绍了软件设计方法。
We complete the design of crossbar switch with 6 ports and 32 bits data bus on one chip of FPGA.
我们在单片FPGA中完成了6个端口、32位数据总线宽度交叉开关的设计。
A design was proposed, which drives PCI bus nic by adopting single chip microcomputer to realize the connection between serial communication equipments and Internet.
给出了一种采用单片机驱动pci总线网卡以实现串行设备与以太网连接的设计方案。
This paper presents an all-purpose design for an intelligent measurement and control unit based on a CAN bus, and describes its hardware structure and chip functions.
文中介绍了一种具有通用性的基于CAN总线的智能测控单元的设计方法，阐述了系统各部分的硬件结构及相应的芯片功能。
This system with the control core of 80c552 single chip processor adopts bus isolation technique, realizing the time-sharing processing of high-speed data collecting and data processing.
该系统以80c552单片机为控制核心，采用总线隔离技术，实现高速数据采集与数据处理分时进行。
This system with the control core of 80c552 single chip processor adopts bus isolation technique, realizing the time-sharing processing of high-speed data collecting and data processing.
该系统以80c552单片机为控制核心，采用总线隔离技术，实现高速数据采集与数据处理分时进行。
应用推荐