The factors relating to shear wall discussed in this paper are seismic intensity, site soil condition, weight and height of building, and top displacement of structure etc.
本文论述了不同设防烈度及场地条件，建筑高度和自重，以及顶点相对位移限值等因素与抗震墙用量之间的关系。
However, the displacement and deformation of surface ground by underground mining have destroyed initial equilibrium between the building and the ground.
但是由于地下开采引起地表产生的移动和变形，破坏了建筑物与地基之间的初始平衡状态。
A planar quadrilateral is adopted as the basic loop in building up the displacement equations, and four basic types of solutions are given.
采用平面四边形为基本封闭形建立位移方程，给出了所有四个基本类型的解。
For the safety and normal usage of the city ground building, therefore it is extremely important to estimate the earth surface movement and displacement caused by tunnel construction.
为确保城市地面建筑的安全和正常使用，因此对隧道施工所产生的地表位移的预测极为重要。
The results show that the nuclear power station is sate, its horizontal displacement and settlement amount agree to the deformation law and are normal building deformation.
结果表明：核电站是安全的，其水平位移、沉降量符合客观规律，属正常形变，为今后解决核电站建筑物变形观测问题提供了可靠的依据。
According to the analysis, the displacement and velocity of the building structure can be chosen as the output feedback variables for the controller.
通过分析，大楼结构的位置和速度可选为控制器的输出反馈变量。
This paper studies the surface displacement and deformation induced by excavation through computing and analyzing, and the influence of which on the adjacent building.
本文主要从计算分析的角度研究了基坑开挖引起的自由场地和有建筑物场地的地表位移和变形规律，以及开挖对临近建筑物的影响规律。
When the finite-strip method is used for the analysis of tall building structures, the unknown quantities are not the values of displacement at the floor level but the parameters of displacement.
有限条法应用于高层建筑结构时，作为位移未知量的不是楼层处的位移值，而是位移曲线的幅值。
Hydraulic heavy boosters, the separate hydraulic jacks and UHP water pumping stations, for overweight handling of bulky items displacement, building a whole pan.
液压重物推进器、分离式液压千斤顶及超高压泵站，用于超重大件物品装卸位移，建筑物整体平移。
In this paper a method for prediction of seismic reliability of multi-storey building with a storey displacement criterion is proposed.
本文提出一个以房屋层间位移为控制指标的抗震可靠度计算方法。
In order to resist the structure's lateral load and reduce the lateral displacement efficiently in the tier or tall building structure, it is generally designed the joint as rigid joint earlier.
早期的多高层建筑钢结构设计，为了能有效地抵抗结构的侧向荷载和降低结构在侧向荷载作用下所产生的水平位移，一般把梁柱连接设计成刚性连接。
However, most of these commercial building are using positive displacement hot water supply equipments, and most of these equipments use electricity as their heat sourse.
然而这些商用建筑中目前普遍使用的基本上都是容积式的热水供应设备，许多是以电做为热源的。
The simulation results show that stratum vertical displacement has a sudden change near the high-rise building. Away from the building in an enough distance, the displacement curve becomes flat.
计算结果表明，模型的竖向位移等值线在建筑物附近有一定的突变现象，而在距离建筑物一定的距离范围外，位移等值线又逐渐过渡为平滑曲线。
During cantilever construction of CCTV main building, high frequency, high precision and multi-point dynamic monitoring is used in tower crane displacement installation and usage.
CCTV主楼悬臂施工阶段，对塔式起重机在移位安装至悬臂部位过程中和使用状态下进行高频次、高精度、多点位动态监测。
In the design of tall building structure, the engineers generally design the joint as so-called "rigid joint" to resist the structure's lateral load and reduce the lateral displacement efficiently.
高层建筑钢结构设计中，工程师们一般都将节点做成所谓的“刚节点”，以抵抗结构的侧向荷载和降低结构在侧向荷载作用下所产生的水平位移。
An example is given to compare the presented method and the methods in related literatures, which shows that the membrane can effectively control the side-displacement of building.
最后通过算例，将计算结果与参考结果相比较，充分验证了蒙皮效应在高层结构中可有效控制建筑物的侧移。
Floating links is adopted between roofing system and the main building body, which can fully absorb displacement of the main body.
屋面系统与主体采用浮动式连接，完全吸收主体变位。
As is known to all, with the increment of building height, the Lateral displacement is proportional to the height with the fourth power.
众所周知，随着建筑高度的增加，结构的侧向变形与高度的四次方成正比。
The roofing system and the main building body are connected by floating joints so as to fully absorb main body displacement.
屋面系统与主体采用浮动式连接，完全吸收主体变位。
The roofing system and the main building body are connected by floating joints so as to fully absorb main body displacement.
屋面系统与主体采用浮动式连接，完全吸收主体变位。
应用推荐