To facilitate the theoretical analysis, "Two-way bridge arm" new concept is presented.
为便于理论分析，提出了“双向桥臂”概念。
The single bridge arm has advantages of light weight, simple and reliable structure and less space.
该单桥臂具有重量轻、结构简单可靠，占用空间少等优点。
A new current detection method is introduced aimed at lower bridge arm modulation when motor is operating at six states.
针对三相六拍两两导通且下桥臂开关管调制方式提出了新型电流检测方案。
Voltage waves are deduces on lower bridge arm PWM modulation and theory of rotor position detection based on EMF is introduced.
分析了下桥臂调制方式下绕组端电压波形，并基于此介绍了反电势法检测转子位置原理。
This paper gives the best method in configuring the bridge arm to improve the sensibility of the AC bridge by way of theoretical deduction and experiment.
通过理论和实验证明，阐述了提高交流电桥灵敏度的桥臂最佳配置方法。
This method can reduce monitoring points, get more concise criterions of fault types and has many other advantages when it is used to on-line monitor and diagnose SSFCL bridge arm fault.
该方法用于在线监测、诊断桥式固态限流器整流桥桥臂故障，具有监测量更少、得到的故障判据更简洁等诸多优点。
Theoretically analyzed the cause of the non-conduction phase current with the PWM method of upper and lower bridge arm chopping by turns, and made some experiments to verify its validity.
结合上下桥臂轮流斩波PWM调制方式，从理论上分析了不导通相电流产生的原因，并进行了实验研究，表明不导通相电流的大小与不导通相的反电势大小有关。
Compared with single bridge, the relationship between the arm resistance of double bridge and its sensitivity can be determined. Therefore, the rule for selecting arm resistance is obtained.
通过与单电桥相比，得出双电桥桥臂电阻与电桥灵敏度的关系，从而确定了双电桥桥臂电阻选择的原则。
In order to restrict the rising rate of fault current caused by short circuit on one arm of bridge of inverter, a kind of device named current loop protection circuit can be adopted.
为了限制逆变器桥臂直通短路时故障电流的上升率，可以在装置的直流侧安装一种称为“环流保护电路”的附加电路。
Compared with single bridge, the relationship between the arm resistance of double bridge and its sensitivity can be determined.
通过与单电桥相比，得出双电桥桥臂电阻与电桥灵敏度的关系，从而确定了双电桥桥臂电阻选择的原。
An oblique arm supporting rigid frame timbering based on the built bridge columns better to solve the difficult deep water timbering problem.
以已成桥柱为基础的斜臂支撑的刚构支护结构，较好地解决了深水支护的困难。
The sensitivity of the self-organized bridge using resistance box as arm resistance and the uncertainty of the measuring result are analysed. The selecting principles are given.
本文分析了用电阻箱作桥臂电阻自组电桥的灵敏度及测量结果不确定度，给出桥臂电阻的选择原则。
"Bridge Techniques" is a special hand posture used in Nan Quan (Southern Style Boxing), which formed by straight or bow arm, to fold, coil, cut, such methods for attack and defend.
“桥法”是南拳特有的手法，即直臂或屈臂成“桥”形进行圈、盘、切等攻防手法。
The two-arm bridge measuring low resistance circuit of MCU control, multivibrator measuring electric capacity, auxiliary leveling bridge circuit, output display circuit are designed.
设计了单片机控制双臂电桥测量低电阻电路、多谐振荡测量电容电路、辅助调平电桥电路、输出显示等电路。
The anchor-arm static-pressure pile can be used not only in buildings' foundation engineering but also in the reinforcement construction of large bridge pile foundation.
锚杆静压桩不仅能在建筑基础工程中应用，而且能在大型桥梁桩基加固补强施工中应用。
A transformer-ratio arm bridge with three terminals is adopted as its measuring circuit to eliminate the influence of electrode edges and exterior interference.
相应地，它的测量电路采用具有三个输入端的变压器电桥，从而免除了电极边缘和外界干扰的影响。
The scraper of full-bridge type adopts automatic hinged arm structure, which can automatically adjust the inclination of tank caused by the accumulation or the uneven settling of the sludge.
全桥式刮臂采用铰支式可自动抬臂的新颖结构形式，对污泥堆积过厚或沉淀池不均匀沉降造成的池子倾斜有自动调节、逐层刮泥功能。
A shell hit the Jervis Bay's bridge, shattering Fegen's right arm, but he continued the hopeless fight for three hours, and eventually went down with his ship.
一枚炮弹打中杰维斯贝号驶驾台，把费根的右臂也炸得骨肉碎裂，但他还是知不能战而战，继续打了三小时，终于和杰维·斯贝号一起沉下海底。
This paper introduces the arm-changing measurement for the double-arm bridge. The method can reduce the systematic error and increase the precision of the measurement.
本文介绍了双臂电桥的换臂测量方法，从而减小了系统误差，提高了测量准确度。
This paper introduces the arm-changing measurement for the double-arm bridge. The method can reduce the systematic error and increase the precision of the measurement.
本文介绍了双臂电桥的换臂测量方法，从而减小了系统误差，提高了测量准确度。
应用推荐