The results indicate: a bit carbon was removed, and weak interphase joint exist still and did not build up the boundary strength.
结果农明，碳没有被除尽，弱的碳界面层依然存在，没有增强界面结合强度。
Then we define the boundary strength function and the feature boundary of each patch, to construct a deformation contour on the patch's boundary.
然后定义分割片的特征边界和边界强度函数，用以表示各预分割区域边界上的形变模型；
There are two conclusions, first, the greater the mesh count, the worse the mixture of water temperature and the Rubber asphalt synchronization crushed stone sealing course boundary strength.
得出下面两个结论，一是目数越大，混合料水稳定性越差，同步碎石封层的界面强度越差。
The optimal mathematical model of the double universal spindle must satisfy the constraints of strength, rigidity, vibration condition, stability and boundary condition.
双万向轴的优化数学模型必须满足强度、刚度、振动条件、稳定性及边界条件的约束。
The stress concentration analysis was done by the finite element method and boundary element method. The fatigue strength and the strength under the static load were calculated.
对螺纹槽管进行了疲劳强度计算，并采用边界元和有限元法对螺纹槽管的应力集中进行了数值分析及静载强度计算。
And the strength check have been proceed toward the thinnest boundary.
并对边界最薄处进行了强度校核。
This paper introduces the boundary element method currently used in engineering. Emphasis is placed on summary of references closely related to strength of aeronautical structures.
本文介绍在工程应用中流行的边界元法，侧重综述与航空结构强度关系比较密切的文献资料。
For an incident shock wave, the strength of reflected shock waves from the boundary of different materials are calculated theoretically.
从理论上计算了同一强度的入射冲击波在不同材料界面上产生的反射冲击波强度。
High nitrogen and low nickel stainless steels exhibit attractive properties as high strength and ductility, good corrosion resistance and reduced tendency to grain boundary sensitization.
高氮低镍不锈钢具有良好的强度、延展性及耐腐蚀性能，且可以降低晶界的腐蚀敏感性。
The min. weight target function is computed under the boundary conditions of strength, distortion and limit of dimensions.
在强度、变形和尺寸限制的约束下寻求最小的重量目标函数。
In the present paper, both the process and new grain boundary of austenite recrystallized of 300m ultra high strength steel have been Oserved in-situ by means of high-temperature metalloscope and tem.
运用高温金相和TEM方法，对超高强度钢300m的奥氏体相变再结晶过程和新晶界进行了定位观察。
The strength and position of vortical cores and lines can iteratively be got by satisfying boundary conditions.
选择初值迭代求解自由涡线、涡核的强度和位置。
The network could predict the effects of the temperature on the boundary film strength. the network trained with the L-M rule were quick in convergence and small in error.
该模型可用于准确地预测温度对边界膜强度的影响。并采用L - M规则进行神经网络学习训练可使网络收敛快，误差小。
The source strength are obtained by satisfying all the boundary conditions on each side, and the wave-making resistance is gained consequently.
然后通过在各个边界面满足相应的边界条件来求出源强，进而得到所求的兴波阻力。
A computation program has been developed, using a two dimension boundary element method, for calculation of stress strength factor at the welding crackle tip.
反映裂纹尖端附近区域应力场强度的物理量称为应力强度因子。它和裂纹大小、形状以及外应力有关。
The relative amount of IAF and the morphology of grain boundary ferrite in HAZ were the decisive factors affecting the strength and toughness of HAZ.
HAZ组织中IAF相对数量及晶界铁素体的形态是影响HAZ强韧性的决定性因素。
It is found that the alloying elements segregation in grains and the grain boundary cleanliness control the yield stress value and the tough-strength properties of this material respectively.
发现材料的晶内偏析和奥氏体晶界洁净度分析控制钢的屈服强度和韧度。从而改变了此钢按细化晶粒度控制强韧性的工艺指导思想。
It is found that the alloying elements segregation in grains and the grain boundary cleanliness control the yield stress value and the tough-strength properties of this material respectively.
发现材料的晶内偏析和奥氏体晶界洁净度分析控制钢的屈服强度和韧度。从而改变了此钢按细化晶粒度控制强韧性的工艺指导思想。
应用推荐