In a special circulating system with high velocity flow, boundary shear stresses in clear water flow, aerated flow and sediment laden flow are measured.
在高速水流循环系统中，用自行研制的剪切力传感器分别量测了清水、掺气水流及挟沙水流壁面上的剪切力；
In this paper, the deformation of two-dimensional red blood cell in linear shear flow is simulated using the immersed boundary method to observe the tank-treading motion.
本研究采用浸入边界法模拟二维红细胞在线性剪切流中的形变，观测细胞的坦克履带式运动。
It is found that the initial slip length controls the slip behavior at small shear rate, but the critical shear rate controls the boundary slip at high shear rate.
研究发现初始滑移长度对低剪切率下的滑移行为起主要作用，而临界剪切率决定了高剪切率下的边界滑移程度。
Based on the first order shear deformation theory and Hamiltonian principle, the governing equations and boundary conditions of rotating multi-layer annular plate were derived.
基于一阶剪切变形理论和哈密顿原理，建立了旋转层合圆板动力学运动方程和相应的边界条件。
Series solutions were derived for the in-plane strain, deflection and bending strain that satisfy the simplified boundary conditions to calculate the shear lag coefficient.
根据简化的边界条件，得到了面内应变和弯曲应变的级数解，进而求得剪力滞后系数。
The contact problems are non-linear problems, which relate to stress concentration, local boundary nonlinear, no-reversibility of shear force, and so on.
接触问题是非线性问题，涉及到应力集中、局部边界非线性、切向力的不可逆性等一系列非线性问题。
The flaw on the boundary of rock can determine the distribution of the final shear band and reduce the rock UCS greatly.
边界上的缺陷不但能够决定岩石的最终剪切破坏带的分布，而且还极大地影响岩石的强度；
Thinking over the influence of box beams shear lag effect, making use of the governing different equations and related natural boundary conditions of bending vibration to box girder.
考虑箱形截面梁剪力滞后效应的影响，利用推导出的箱形截面梁的弯曲振动方程及其自然边界条件，并据此进一步推导出了多跨箱形截面梁的固有频率方程。
The finite deformation theory is applied to investigate the effects of boundary condition and loading speed on shear band localization of normally consolidated Fujinomori clay.
基于有限变形理论，研究了正常固结藤森黏土的边界约束效应和加载速度效应。
Triple junction is the intersection point among three plate boundaries. The boundary could be tensional, compressional or shear fault.
三条板块边界常相交于一点，这一个交点就叫做板块三联接合点（简称三联点，或称三节点）。
In this paper rapid distortion theory is used to predict the effect of anisotropy on the structure of shear free boundary layer and axisymmetric straining turbulence.
本文运用湍流快速畸变理论对各向异性条件对无切变边界层及轴对称应变湍流特性的影响进行了探讨。
But the theory about the flow regime of the wave boundary layer, the wave friction factor, the bed shear stress and the initiation of sediment motion has not developed very well.
而且波浪是海岸地区一个非常重要的海洋水动力因素，波浪作用下底部边界层的流态、底摩阻系数、床面剪应力和泥沙起动的理论还不成熟。
It is obvious that this ductile shear zone is the direct tectonic boundary of between Qiongzhong terrain and Sanya terrain.
这条韧性剪切带无疑是琼中地体与三亚地体对接带的直接构造记录。
By adopting the discrete layer displacement and introducing the compatible conditions of shear stresses at interfaces and on boundary surfaces, the modified displacement field is deduced.
采用分层位移模式，引入夹层板层间和表面剪应力协调条件，导出了位移场的修正形式。
In calculation, the bottom shear stress under the effect of waves and currents is supplied by the wave-current bottom boundary layer model.
计算中的底部剪切应力由波流边界层模型给出波—流共同作用下的形式。
The results show that under shear stresses there are a group of boundary layer solutions near the interface or the fixed boundary.
结果表明，在剪应力作用下，在界面附近和固定边界附近存在一组边界效应解。
The most important issue for the problem of uniform cross-section bar torsion is the calculation of shear stress on the boundary of cross-section, which is very difficult.
对等截面直杆扭转问题，横截面边界上的剪应力计算是件困难的事，也是很重要的研究课题。
From the view of fluid mechanics, the shear-free air water interface corresponds to a slip boundary condition in fluid and relatives to the concept of effective slip length.
从流体力学的角度来看，这个无剪切界面对应着流体中的滑移边界条件，而与此相关的概念是有效滑移长度。
Dissipative, Taylor, shear and integral scale are calculated, and the relationship between them and vertical locations in turbulent boundary layer are obtained.
同时计算了耗散尺度、泰勒尺度、剪切尺度和积分尺度等特征量，并给出它们沿平板湍流边界层法向位置的变化规律。
There exists the wind shear in the vertical distribution of the average wind speed in the convective boundary layer.
在对流边界层中平均风速垂直分布存在风切变现象。
Micro-shear stress sensor plays an important role in detecting separation point of the boundary layer due to small-scale structures and the desired spatial and temporal resolution.
微型剪应力传感器以尺寸小、时空分辨率高的特点在边界层分离点测量中表现出了突出的优势。
A 3d rigid-plastic FEM simulation coupled thermal model for TC4 titanium alloy by warm shear spinning is founded and the temperature boundary condition of heating by flame is applied.
针对TC 4钛合金锥形件建立了三维热力耦合有限元模型，在有限元模拟过程中叠加了火焰加热边界条件。
By introducing the boundary conditions of the circular plate, the flexure displacement, radial rotation Angle, radial bending moment and radial shear force on each nodal line of the plate were given.
引入圆板的边界条件，给出了该板每条节线上的挠度、径向转角、径向弯矩和径向剪力。
TSL Coordinates. Boundary Conditions. Shear Layer Categories.
薄剪力层座标，边界条件，剪力层种类。
The micro shear stress sensor which based on the smart skin for boundary-layer separation point detection of delta wing has been explored in this paper.
本文就以用于实现三角翼边界层分离点检测的面向灵巧蒙皮的微型剪应力传感器为对象展开研究。
The effects of boundary conditions, loading forms, shear directions and initial imp…
同时，还讨论了边界等件、加载方式、剪切力的方向及初始缺陷的影响。
The third is determining the type of gas reservoir and the boundary of gas field by combining shallow shear seism with contact wildcat well;
第三是浅层横波地震与触探井相结合，探明浅气藏类型和气田边界；
The third is determining the type of gas reservoir and the boundary of gas field by combining shallow shear seism with contact wildcat well;
第三是浅层横波地震与触探井相结合，探明浅气藏类型和气田边界；
应用推荐