After building the ground plate and boundary layer suction equipment, the a…
建造地面板和附面层吸除装置，证明该方案是很成功的。
A method to improve the efficiency of the turbine through-flow passage using the technique of boundary layer suction is introduced.
介绍采用边界层抽吸提高透平通流部分效率的方法。
This paper presents an investigation on the side wall effect in two -dimensional transonic wind tunnel with sidewall boundary layer suction around the model.
本文对模型周围的侧壁附面层抽吸，研究跨音速二元风洞的侧壁干扰。
At last, the low-reaction boundary layer suction compressor concept and its design method is proved by the comparison of the experiment data and numerical results.
通过对实验测量数据与数值结果的对比，验证了低反动度附面层抽吸式压气机概念及其设计方法的可行性。
The result showed that for the cascade with larger separation, perfect effects can be obtained by applying boundary layer suction on the end-wall near suction surface.
结果表明：对于大分离叶栅，在靠近吸力面的端壁上进行附面层抽吸可以获得最佳效果。
It has been confirmed by experiments that the boundary layer suction can efficiently eliminate the separation due to interaction of a reflected shock wave with the wall boundary layer.
实验证实了边界层抽吸可以有效地减小激波与壁面边界层相互作用所产生的分离现象。
By using of numerical simulation, the effect of applying boundary layer suction on end-wall to the aerodynamic performance for a van with a high-turning Angle and meridional divergence was discussed.
针对某大折转角子午扩张型导叶，通过数值模拟，讨论了端壁附面层抽吸对叶栅性能的影响。
Under high velocity flow conditions, cascade losses are mainly caused by radial drift of the boundary layer along the suction surface and by blade wakes.
在高速流动条件下，叶栅损失主要是吸力面边界层径向串流及其尾迹。
The result indicated that the interaction between the boundary layer on the suction surface of blade and on the endwall thicken the boundary layer on the suction surface.
实验结果表明，角区中端壁附面层和叶面附面层的堆积使得叶面附面层变厚；
Endwall transverse movement has greater influence on flow separation structure in corner region than separated suction side boundary layer.
端壁横向流动对角区流动分离结构的影响大于吸力面附面层的分离。
Endwall transverse movement has greater influence on flow separation structure in corner region than separated suction side boundary layer.
端壁横向流动对角区流动分离结构的影响大于吸力面附面层的分离。
应用推荐