The next page will discuss the Bootstrap Protocol (BOOTP).
下一页将讨论开机启动协定(BOOTP)。
A. Configure all of the routers to route BOOTP broadcast frames.
配置所有的路由器来转发BOOTP广播帧。
The BOOTP protocol is used for booting (starting) computers from the network.
BOOTP协议的作用是通过网络来重起（启动）计算机。
Filename specifies the Linux kernel to be loaded when servicing a BOOTP request.
filename指定响应BOOTP请求时需要装载的Linux内核。
(If you will need this option later, define the third boot device as Network BOOTP).
(如果您以后还需要这个选项，那么将第三引导设备定义为Network BOOTP)。
The BootP server must assign a new IP address to the Bus Coupler at the next cold start.
BOOTP服务器必须在下次冷启动分配一个新的IP地址总线耦合器。
The DHCP/ BootP service is a program or device that will act as a host with a unique IP address.
DHCP/BootP服务可以是程序或设备，但必须在拥有唯一IP地址的主机上运行。
The IP address assigned by the BootP server is only valid until the Bus Coupler is switched off.
由BOOTP服务器分配的IP地址是唯一有效的，直到总线耦合器处于关闭状态。
This is used during the BOOTP phase of the installation to associate the LPAR with this host entry.
使用这个选项在安装的BOOTP阶段将LPAR和host条目关联起来。
DHCP is a more flexible, backwards-compatible extension of BOOTP, and some of the latest systems can only boot using DHCP.
DHCP是更灵活的向后兼容的BOOTP扩展，一些最新的系统可能只使用DHCP进行引导。
DHCP is a more flexible, backwards-compatible extension of BOOTP, and some of the latest systems can only boot using DHCP.
DHCP是更灵活的向后兼容的BOOTP扩展，一些最新的系统可能只使用DHCP进行引导。
应用推荐