The calculation method introduced in this paper is usually used as the sub-procedure of a boiler system thermal design calculation.
算法通常用作锅炉系统热力设计计算的子过程。
The significance of energy saving for boiler heat user is described in this paper, the thermal calculation and analysis for an example are also emphasized.
本文阐述了锅炉用热设备节能的意义，并通过某实例进行了热力计算和分析。
This paper analysed the principle of water-gas producer and its calculation of thermal value, explained the feasibility of the boiler burning water-gas.
分析了水煤气发生炉的原理及其热值计算，论述了锅炉燃用水煤气的可行性。
The heat calculation would be different because of dissimilar thermal calculation in the turbo-compressor when the boiler load was changed.
由于涡轮增压机组在不同负荷下的热力计算不同而造成增压锅炉在不同负荷下的热平衡计算的不同；
Online calculation of heat to power output efficiency of thermal generator set is important for the load coordination control in the CFB boiler thermal generator set.
为解决循环流化床锅炉发电机组负荷变化时的机炉协调控制问题，需要对发电机组的热功效率进行在线计算。
On the basis of the basic theory of boiler thermal balance and combustion theory set up is an online monitored parameters based fly ash concentration calculation model.
根据锅炉热平衡基本原理和燃烧理论，建立了基于在线监测参数的飞灰浓度计算模型，模型的计算值与实测值比较接近。
The thermal calculation of W flame boiler is exploited in this paper.
着重探讨了W型火焰锅炉炉膛的传热计算问题。
Use several kinds of thermal calculation methods of boiler's furnace, and calculate the outlet flue gas temperature of a low load of some supercharged boiler.
运用几种热力计算方法，对某型船用增压锅炉低负荷工况的炉膛出口烟气温度进行了计算。
The heat transfer and hydrodynamic calculation results of the waste heat boiler show that water circulation is stagnant when the thermal load is very low.
高温取热炉传热计算和水动力计算结果表明热负荷较低时，水循环容易发生停滞。水循环回路结构复杂容易导致并联管内的流量分配不均匀性较大。
Defects in thermal calculation method on which boiler design is based were analyzed. Such defects caused the calculated value of gas temp. at furnace outlet and convection Pass being lower.
论文分析了该锅炉设计所依据的热力方法的缺陷，使炉膛出口和对流烟道烟温的计算值严重偏低；
Defects in thermal calculation method on which boiler design is based were analyzed. Such defects caused the calculated value of gas temp. at furnace outlet and convection Pass being lower.
论文分析了该锅炉设计所依据的热力方法的缺陷，使炉膛出口和对流烟道烟温的计算值严重偏低；
应用推荐