The method of turbine regulation has to be considered in the design of steam boiler reheater.
中间过热器的设计与汽轮机的调节方法有关。
The article describes the critical and hard parts and technology measures of stainless steel membrane panel's manufacture, which be used in high temperature Reheater of large capacity CFB boiler.
大型循环流化床锅炉高温再热器中所采用的不锈钢膜式壁管屏的制造工艺要点和难点，以及解决的工艺措施。
The paper describes the test results of improvement effects on a licensed 300mw set's boiler and its reheater for the purpose of diminishing reheater's mass flow and temperature deviations.
该文介绍引进型300MW机组锅炉、再热器系统经改进，减少再热蒸汽流量偏差和温度偏差的实炉试验结果。
It also provides the basis for solving the bursting leakage by ultra high temperature of the secondary reheater due to the slagging on boiler water wall.
为解决锅炉水冷壁结焦所引发的二次再热器超温爆漏问题提供了依据。
The practical experience shows that in the light of steam purging for supercritical once-through boiler, the superheater and reheater disturbance coefficients can reach 1.0 and 1.6 respectively.
利用减温水控制过热器和再热器出口温度以防止超过材料温限。实践证明，对超临界直流锅炉采用投粉稳压冲管过热器、再热器冲管系数可达1.0和1.6以上，效果良好。
The deviation is a important reason causing reheater tube failure of 300MW and 600MW boiler. It is experienced that steam temperature is higher at right 1/4 area of reheater system.
MW锅炉的偏差温度是引起再热器爆管的一个重要原因，在再热器系统表现为沿炉宽方向右1/4区域汽温较高。
The causes for local overtemperature of high temperature reheater of 600 MW boiler in Beilun Power Plant and that bypass retrofit could not realize the expected effect are analyzed;
分析了北仑发电厂600M W锅炉再热器局部超温及旁路改造未能达到预期效果的原因；
The causes for local overtemperature of high temperature reheater of 600 MW boiler in Beilun Power Plant and that bypass retrofit could not realize the expected effect are analyzed;
分析了北仑发电厂600M W锅炉再热器局部超温及旁路改造未能达到预期效果的原因；
应用推荐