The fracture failure analysis of SA106C boiler header by cold straightening had been made.
对SA10 6c集箱焊后冷校正断裂失效的原因进行了分析，并对预防断裂提出防范措施。
The fracture failure analysis of SA106C boiler header by cold straightening had been made. The prevention methods had been put forward.
对SA10 6c集箱焊后冷校正断裂失效的原因进行了分析，并对预防断裂提出防范措施。
The uniform distribution of flow in a boiler header constitutes one of the key technological factors ensuring the safe design of boiler superheaters and reheaters.
锅炉集箱中的流体均匀分布是锅炉过热器，再热器安全设计的关键技术之一。
Output the class header, including import statements and boiler-plate comment.
输出类头，包括导入语句和注释。
When more than one boiler is connected to the main steam header, a stop check valve should be installed in the pipeline between each boiler and the header.
如果连接主蒸汽热水器的锅炉不止一个，则在每个锅炉与热水器之间的管路上都应该安装一个截止止回阀。
Second: to assist in cutting out a boiler, when ceasing to fire. In this case, the disc automatically closes and prevents header pressure from entering the boiler.
其次，有助于切断锅炉，当停火后，阀瓣自动关闭，防止热水器压力进入锅炉。
First: to act as an automatic non-return valve by preventing a backflow of steam from the main steam header to the boiler.
首先，能过作为一个自动逆止阀，防止蒸汽从主蒸汽加热器上倒流到锅炉里。
A detailed numerical simulation study was conducted of the flow distribution in the heating surface tubes of a boiler roof superheater featuring a distribution header with a bent inlet.
对一台锅炉中其分配集箱带弯头入口的顶棚管过热器受热面管流量分配做了较详细的数值模拟研究。
Though the improvement of manufacture technology of the modules welding between spire-wing tube and header for combined cycle heat recovery boiler, difficulty of the assembling was shortened.
通过对联合循环余热锅炉螺旋翅片管与集箱焊接的组件的制造工艺进行改进，降低了装配难度。
The operation of load distribution of boiler and turbine as well as the principle for coordinated control for thermal power generation unit with header are expounded.
论述了母管制热电机组锅炉、汽机的负荷分配运算和协调控制原理。
A multitude of ring-shaped cracks and three water leakage points were discovered in the right side lower header of a boiler together with a cave-in of the boiler roof water-cooled wall.
锅炉右下集箱产生了很多环状裂纹和三个渗水点，同时顶棚水冷壁管塌陷。
The paper gives a detailed introduction to the typical structure and manufacturing method of drum, waterwall, burner and waterwall header of the 300mw double arch furnace boiler produced by DBC.
文章以DBC制造的300MW“W”形火焰锅炉为例，详细地介绍了锅筒、水冷壁、燃烧器和水冷壁集箱的典型结构和制造方法。
The processing capacity of the holes in pipe is about 40% of the processing capacity of the boiler drum and collecting header in boiler fabrication.
工业锅炉制造中管孔加工量约占锅筒集箱工作量的40%，操作者失误即可能造成该锅筒报废。
The stress analysis and calculation for oval header of waste heat recovery boiler is carried out.
进行了双套管废热锅炉集流管的应力分析和计算。
For the production of various types of alloy structural parts and components, such as the power station boiler superheated header, large diameter tube plate Structure.
用于制作各类合金结构件及其零部件，如电站锅炉过热器集箱、大口径管板结构件。
The chemical composition, microstructure and phase ingredient of the sediment in the sub-header of WGZ410/9.8-15 boiler are measured.
对WGZ410/9.8 15锅炉下联箱的沉积块状物的化学成分、显微组织和物相组成进行了检测。
The chemical composition, microstructure and phase ingredient of the sediment in the sub-header of WGZ410/9.8-15 boiler are measured.
对WGZ410/9.8 15锅炉下联箱的沉积块状物的化学成分、显微组织和物相组成进行了检测。
应用推荐