The top part of one inner bolt which matches the blank hole channel of the outer hollow screw is also conical. The rear is provided with a thread and a tetragonal body for holding.
一与外空心螺钉的盲孔道相匹配的内螺栓，内螺栓的尖端部位亦为锥形，尾部设有螺纹和供握持用的四方体。
The blank design principle and method for rolling ring with stepped hole is developed based on the volume flow law and the comparison to the ring rolling experiment is done.
基于阶梯孔环件轧制体积流动规律，提出了阶梯孔环件轧制用毛坯设计原理和方法，并进行了轧制实验验证。
Decentraction of the conn-rod small end hole center with the excircle center of the conn-rod small end hole blank, which causes the hole wall of one side getting thin with the strength dropping.
连杆小头孔中心与连杆小头孔毛坯外圆中心不同心，使一边孔壁变薄，强度下降。
Angle flange Standard. Flat flange: Specify hole pat-tern. If no drawing provided, flange will be blank.
角法兰标准。平板法兰：指定孔模。如果没有提供的图纸，法兰将为空白。
Drill a hole in the centre of the blank PCB so that the copper pipe is a tight fit in the hole.
在空白电路板的中间钻一个小孔，使得铜管正好紧紧地固定在中间。
The blank design principle and method for rolling ring with stepped hole is developed based on the volume flow law and the comparison to the rin…
基于阶梯孔环件轧制体积流动规律，提出了阶梯孔环件轧制用毛坯设计原理和方法，并进行了轧制实验验证。
The blank design principle and method for rolling ring with stepped hole is developed based on the volume flow law and the comparison to the ring rolling experiment is …
基于阶梯孔环件轧制体积流动规律，提出了阶梯孔环件轧制用毛坯设计原理和方法，并进行了轧制实验验证。
The function of the blank holder force (BHF) as well as its influence on the forming performance and forming accuracy of combined stepped-hole were analyzed.
分析了压边力的作用及其大小对这种复合台阶孔成形性能和成形质量的影响。
The main cause of too small flanged hole end diameter on parts of the Audi car has been found by analysis to be thinning of blank material and rebound.
对奥迪轿车零件翻孔端部直径偏小的分析结果表明，其主要原因是材料变薄及回弹所致。
The main cause of too small flanged hole end diameter on parts of the Audi car has been found by analysis to be thinning of blank material and rebound.
对奥迪轿车零件翻孔端部直径偏小的分析结果表明，其主要原因是材料变薄及回弹所致。
应用推荐