So no lens bending error. The sensor Pixel is always the same and it is in the centre.
如果不存在透镜的曲率误差，那么图象总是显示的屏幕中心的同一个位置。
One source of error is refraction, the bending of light beams as they pass through air layers of different temperature and pressure.
误差的一个来源是折射，即光束通过不同温度和压力的空气层时发生的弯曲现象。
This paper analyzes the error of torque sensor of strain-resistor which derives from the influences of bending moment on elastic axis, and discusses the Eliminating techniques.
本文对在应用应变式扭矩传感器时由于在弹性轴上的弯矩而引起的误差进行了力学分析，并提出了消除的方法。
Bending one's waist and legs, lowering the body and laying open the hands may express apology and acknowledge of one's error.
腿腰弯曲，把身子放低，摊开双掌，表示道歉和承认错误。
It is shown that bending deformation and the machining error in conditions of reversed turning is much less than that in normal turning.
算例表明：逆向车削时轴的弯曲变形以及加工误差远小于同等条件下正向车削的变形和误差。
Deformation mode is adjusted according to forming limit diagram (FLD) and maximum springback error, so the optimized one can be found, which in turn optimizes the stretch bending trajectory.
根据成形极限图和规定最大回弹超差量来调整变形模式，找到优化的变形模式和拉弯轨迹。
At the same time, the machining error caused by the gravity bending of the ball screw is...
同时简要分析了在加工精密工件时，由于自重原因引起丝杠弯曲导致的加工工件的误差。
At the same time the processing error of the workpiece caused by the bending of the ball screw for the gravity force was analyzed when the workpiece is...
同时在加工精密工件时，就自重原因引起丝杠弯曲导致的加工工件的误差进行了分析。
This paper also analyses the bending stiffness of arch, points out that the thrust of the neglect of axial compression deformation, can lead to thrust calculation error 30%.
本文还分析了压弯刚度对拱推力的影响，指出忽略拱的轴向压缩变形的影响，可导致推力的计算误差达到30%。
Regulatory axis error correction function of size, saving the operator time to correct machine. With a bending power reference value of pressure.
规轴误差尺寸校正功能，节省操作人员校正机床的时间。具有折曲压力参考值功。
Regulatory axis error correction function of size, saving the operator time to correct machine. With a bending power reference value of pressure.
规轴误差尺寸校正功能，节省操作人员校正机床的时间。具有折曲压力参考值功。
应用推荐