Also propose some rational and effective calculation methods about cross beam calculation, and expound the problem of prestress reserve.
其中针对横隔梁的计算提出了几种合理有效的计算方法，同时着重阐述了横隔梁的预应力储备问题。
The principle and method of the wall beam calculation in the new norm is explained fully in this paper through calculation of some work example.
本文通过某工程实例的计算，充分表达了新规范中墙梁计算的原理与方法。
This article describes three types of rib beam calculation of internal force, and compare the three calculation methods to guide the practical work.
本文介绍了三种肋梁内力计算的方法，对三种计算方法作了比较，以供实际工程中选用。
Finally, several design points were emphasized such as transverse anti-overturning stability calculation, vertical stiffener layout, beam calculation, manhole and steel structure coating, etc.
最后着重介绍的设计要点有：横向抗倾覆稳定计算、纵向加劲肋设置、横梁计算、人孔设置、钢结构涂装等。
Your calculation is way off beam.
你的计算完全错误。
Through a calculation of the strength of normal section of extra-reinforced cantilever beam for an actual project, the conception of normal section of extra-reinforced cantilever beam is analyzed.
通过一工程实例中悬挑梁的正截面配筋计算，对钢筋混凝土悬挑梁正截面超筋的概念进行了分析和探讨。
Especially, analyze qualitatively the effect that the cathode magnetic field Angle contributes to beam ratio and prove it by calculation.
特别的是，文章中定性分析了阴极磁场角对电子注速度比的影响，并通过计算获得证明。
Calculation method of kinematic parameters for the unusual shape beam pumping unit.
异形游梁式抽油机运动参数的求解方法。
The article have expounded the load acting on PC single track beam, and the calculation of curved PC single track beam including force, prestress and the stress etc.
阐述了作用于PC轨道梁桥结构上的荷载，曲线pc轨道梁的内力计算，预应力计算，应力计算及组合。
The theoretical design and calculation of the circular-section I-shaped beam shearing force sensor have been emphasized in this paper.
本文着重论述了圆截面工字梁剪力传感器的理论设计与计算。
According to the results of numerical calculation, the proximate formula of estimating radius of the beam was developed.
根据数值计算结果，提出一个计算束半径的近似公式。
Through a large amount of calculation, the stress distribution Pattern of beam axle is obtained for some main load cases.
通过大量计算，对应于几种主要的载荷工况，得到了车桥横梁的应力分布规律。
This paper presents the principle of conjugate beam method which can be applied to the calculation of deformation.
本文介绍了用于梁变形计算的共轭梁法的原理，并举例说明了该方法的应用。
Calculation results indicate that the vibration acceleration of beam and pier can be more effectively reduced with steel spring bearing.
计算结果显示，钢弹簧支座能更有效地降低梁体与桥墩的振动加速度。
Research purposes: This paper analyzes the effect of the lateral prestressing tendon in top deck on the lateral calculation result of box beam.
研究目的：研究顶板横向预应力钢束对箱梁横向计算结果的影响，给箱梁结构设计提供借鉴和帮助。
A method based on the transverse particle motion equation is described for the calculation of beam acceptance for RFQ accelerators.
基于RF Q加速器中束流横向运动方程描述了一种计算其入口处束流接受度的方法。
Based on fracture mechanics and theory of reliability, this paper offers the reliability calculation method for welded box beam having fracture.
根据断裂力学及可靠性理论，提出了一种起重机焊接箱形梁存在裂纹缺陷的可靠度计算方法。
Use the LEADS software to simulate the calculation of beam transfer, and show the envelope curve of beam transfer.
运用LEADS软件，进行了束流传输的模拟计算，并显示了束流传输包络曲线。
The nonlinear equation of the guyed mast is presented based on calculation models of space cable and beam elements.
将桅杆结构离散为空间纤绳单元和梁单元计算模型，建立了桅杆结构非线性平衡方程。
Started from the analysis of connection form between prop end and pit on top beam and quantified calculation to analyze the cause of prop end deformation, points out the defect for design.
从分析立柱柱头与顶梁柱窝的结构形式入手，采取定量计算的方法分析了引起桩头变形的原因，指出了设计上存在的缺陷。
The mechanics mechanism of lop beam is discussed by the mcthod of comparing and analyzing the results of calculation.
通过对计算结果的比较和分析，对桩顶圈梁作用的力学机理进行了深入探讨；
In this paper, a new method, which USES only one phase aperture to obtain uniform distribution from Gaussian beam, is proposed, the calculation results are given.
本文提出只用一个简单的相位光阑实现高斯光束强度均匀化的新方法，给出了计算结果。
The paper then compares the calculation results of the two beam models and reaches a beneficial conclusion.
将两种梁模型的计算结果进行了比较，得出了有益的结论。
For the calculation of the crane box-style beam, which is generally very complicated, not only waste much time but also very easily make mistakes.
对于起重机箱形梁的计算一般比较复杂，用人工计算不仅耗时比较长，而且很容易出现错误。
In this way, the calculation of the elastic foundation beam is further unified, which is very convenient to practical use.
这样，就进一步把弹性地基梁的计算问题统一起来，为实际应用提供方便。
The bottom structure is supported by every longitudinal beam in orientation calculation, and then the orientation force and elasticity supporting force is obtained.
计算时，底部弹性支承在各纵梁上，可求得结构的横向受力与弹性支承反力。
Based on discussion of attached plate and analysis of beam elements calculation results, a experience formula is deduced for the calculation of a beam elements inertial moment.
基于对梁元带板问题的讨论及对大量梁元的实际计算结果分析，推导出梁元惯性矩计算的经验公式。
Objective To study the method for dose calculation and beam weight optimization of intensity-modulated radiation therapy (IMRT).
目的研究调强放射治疗(IMRT)剂量计算与射野权重优化方法。
Objective To study the method for dose calculation and beam weight optimization of intensity-modulated radiation therapy (IMRT).
目的研究调强放射治疗(IMRT)剂量计算与射野权重优化方法。
应用推荐