Reasonable operation parameters were used based on experimental data of cold model.
对试验物料的流态化冷态测试，选择了合理的操作参数。
Based on experimental data, a series of regression expressions have been obtained by computer.
对大量试验结果用计算机处理得到了定量计算的系列表达式。
Based on experimental data, empirical correlation on filling ratio was obtained via regression.
根据试验数据拟合出合理充液率的经验关系式。
We find a suitable control method based on experimental data. The kicking velocity is under control.
根据实验获得的数据找到合适的控制方法，使得击球的速度可控。
Machine Learning based on experimental data has become the focus of currently study in many industries.
基于数据的机器学习问题已经成为目前许多行业应用于研究的重点。
This method is also proved to be reasonable based on experimental data of fatigue short crack at notch.
本文对采用喷丸处理改善结构钢的短裂纹断裂性能进行了探讨。
Expressions of streamwise deformation of open channel flood streams are obtained based on experimental data.
从试验资料的分析得到了明渠流洪水波沿程变形的表达式。
The goal of finish machining is achieved and surface roughness is reduced 3 ~ 5 grades based on experimental data.
根据实验得到的优选数据进行加工，有效地降低了表面粗糙度3 ~5级，达到了光整加工目的。
Fitting functions based on experimental data wasn 't used often before, because the calculation is very difficult.
根据实验数据进行复杂函数的拟合，由于计算量大，拟合往往停留在理论阶段。
Analysis of factors of oxygen pickup in molten steel and corresponding measures based on experimental data are presented.
依据实验数据计算结果，对钢液增氧的因素及其采取的相应措施进行了分析与探讨。
We found a new phenomenological model based on experimental data. Then identify the unknown parameters in virtue of the results.
根据磁流变阻尼器的实验结果，建立了一种新的磁流变阻尼器的唯象模型，通过实验数据对模型中的未知参数进行辨识。
Based on experimental data, the micro carbon pillar with an aspect ratio of over 500 was fabricated through focus moving method.
根据实验数据，使用焦距移动方法，生成长径比超过500的微碳柱。
Based on experimental data, the functional relationship between displacement pressure of mudstone and vitrinite reflectance is set up.
本文在大量实验数据的基础上，建立了泥岩排替压力与镜质体反射率之间的函数关系。
Based on experimental data, water saving and temperature raising effects of micro irrigation with plastic film mulch are analyzed and discussed.
在实验基础上，分析论述了微灌地膜的节水效果和增温保墒效应。
Based on experimental data in (4), the statistical characteristics for the tensile strength of rac with RCA from different origins were determined.
基于(4)中立方体试块的试验结果，研究了不同来源再生混凝土抗拉强度的统计特征。
Based on experimental data and numerical simulation results, effects of ambient pressure and base bleed on aerospike nozzle base behaviour are investigated.
基于实验数据和数值模拟结果，研究了外界反压和底部二次流对塞式喷管底部的影响。
Based on experimental data and finite element analysis results, a low-cycle fatigue life model is proposed for the powder metallurgy superalloys under multiaxial stress states.
在详细分析试验和有限元计算结果的基础上，提出了复杂应力状态下的低周疲劳寿命模型。
Based on experimental data, adhesive length, the number of layers and sticking technology, and the effects of the parameters are discussed, and the bond mechanism is described.
探讨了碳纤维布的粘接长度、层数、宽度比以及粘贴工艺等不同粘接参数对复合构件粘接性能的影响，初步描述了碳纤维布与钢构件的粘接机理。
Based on experimental data of (2) and (4), results of the statistical analysis for the relationship between compressive strength and splitting tensile strength of RAC was given.
基于(2)和(4)中抗压强度与劈裂抗拉强度的试验结果，对再生混凝土抗压强度与劈裂抗拉强度之间的关系进行统计分析。
Based on experimental data, puts forward a series of compound factors influencing ventilation effectiveness, and develops empirical formulas for predicting the ventilation efficiency.
根据大量的实验资料，分析提出了影响通风效率的若干复合因素，得出了预测置换通风效率的经验式。
Based on experimental data, through dimensional analysis of the influence factors of channelling flow, put forward the computative formula for velocities along axis after channelling.
依据试验资料，通过对挖槽水流影响因素的因次分析，提出挖槽后轴线处的流速计算式。
Based on experimental data, theoretical calculation and comparison, the resolution is recommended and proved by practice. The author also points out the issues to be observed for similar projects.
依据实测数据和理论计算及比较，提出解决办法，并得到实践验证，同时指出类似的工程设计应注意的问题。
Based on experimental data of engine, torque and oil consumption model of engine are established by method of spline interpolation. The optimum economy and power operation line of engine is obtained.
在实验数据基础上，利用三次样条插值构造了发动机转矩和油耗数学模型，确定了最佳经济性与最佳动力性工作线。
Based on experimental data, the authors have studied such factors as channel structure, pitch, particle concentration and particle diameter, etc, which may have an influence on separation efficiency.
作者在实验的基础上对影响分离效率的槽型结构、节距、颗粒浓度、颗粒直径等因素进行了研究。
Based on the experimental data and analysis results, a prediction system for spontaneous combustion was designed.
根据实验数据和分析结果，建立了煤自然发火的预报系统。
An optimized cooling process of TRIP steel was put forward based on analysis of experimental data.
在分析实验数据的基础上，提出了TRIP钢轧后最佳冷却工艺。
The experimental results are analyzed based on the gained data.
基于所得的数据，分析了实验结果。
The experimental results are analyzed based on the gained data.
基于所得的数据，分析了实验结果。
应用推荐