Plastication torque, balance torque and processing energy consumption at the condition of single-screw processing are larger than those of double-screw processing condition.
单螺杆挤出材料的塑化转矩、平衡转矩和加工能耗均较双螺杆的略大。
Lifting operation hydraulic system should be no-load operation, adjust the lifting sleeve frame roller and the mast section clearance, hoisting torque and balance torque balance;
顶升作业时液压系统应进行空载运转,调整顶升套架滚轮与塔身标准节的间隙,使起重力矩与平衡力矩保持平衡;
Balance weight block installation position is not accurate, will cause the boom and the balance arm balance torque deviation is too large, easily lead to instability of the tower crane.
平衡重块安装位置不准确,会造成起重臂与平衡臂平衡力矩偏差过大,轻易造成塔吊失稳。
For more information on Balance and Torque, refer to the links under "Job management" in Resources.
要获得更多关于Balance和Torque的资料,请参阅参考资料中“作业管理”部分的链接。
Based on the single DC motor model, the mathematic model of dual-motors was established to analyze the problem of output torque balance of dual-motors.
这一特殊结构使得正反转电机的驱动问题尤其是输出转矩平衡问题显得尤为突出。
The methods of load balance of moment limiting and speed softening mode under torque control model and velocity mode are put forward.
提出了在转矩模式、速度模式下力矩限幅和速度软化方式的负荷平衡方法。
In view that large top torque and negative torque are produced when crank balance (primary balance) is adopted, we present the secondary balance of beam pumping unit.
针对游梁式抽油机在采用曲柄平衡(又称一次平衡)时存在的峰值转矩较大、负转矩严重等现象,提出了有关抽油机的二次平衡问题。
Cone air lock valve can realize to discharge dust with the help of torque balance.
锥形锁风阀利用力矩平衡的方法实现卸灰。
The characteristic of the torque and power loses are analyzed under the performance of unbalance operation, a current balance control method is brought forward and the experimental results are given.
分析了该电机工作在各种不平衡状态下的转矩与功率损耗的特性,提出了一种电流均衡控制方法,并且给出了试验结果。
But net torque curve of crankshaft exists negative . The compound balance beam pumping units is put forward.
但净扭矩曲线存在负值,建议增加曲柄二次平衡,设计成复合平衡型抽油机。
Because of this torque balance, ensure the valve opening and the corresponding relationship between the input signal accurately to achieve the correct positioning of the spool.
水力控制阀由于这种力矩平衡,保证了调节阀开度与输人信号之间对应关系准确,实现了阀芯正确定位。
The torque tube unbalance of turboshaft power turbine rotor is investigated and a test method for estimating the unbalance is introduced with high speed dynamic balance test.
对涡轴发动机动力涡轮转子测扭基准轴的不平衡量进行了研究,提出了一种通过高速动平衡试验估算出测扭基准轴不平衡量的试验方法。
The results have shown that the torque tube unbalance is not a key factor in high speed dynamic balance, but effects the power shaft.
结果表明:测扭基准轴的不平衡量虽然不是转子高速动平衡的决定性因素,但影响到传动轴的动平衡。
Fx and the role of fluid in the plunger on the pressure balance, Fy occurred while rotating cylinder to generate torque, rotating drive shaft 5.
Fx与作用在柱塞上的液压力平衡,Fy则产生使缸体发生旋转的转矩,带动轴5转动。
In order to search a new way for torque measurement and investigate propeller performance accurately, the special balance has been designed for propeller testing.
为了探索新的扭矩测量方法,准确研究螺旋桨的性能,设计了螺旋桨实验专用天平。
The RX350 has adopted a full-time 4-wheel Drive system that constantly distributes torque to balance the front and rear axles. High levels of driving stability and drivability has been realized.
RX350装备的全时4轮驱动能够将扭矩以更均衡的比例分配至前、后轴,实现了更高的驾驶稳定性和操控灵活性。
The method of establishing a balance between the gimbal rate and the output-torque error is discussed, and a new steering law is designed.
讨论了在框架角速度和输出力矩误差之间建立平衡的方法,并设计了一种新的操纵律。
The method of establishing a balance between the gimbal rate and the output-torque error is discussed, and a new steering law is designed.
讨论了在框架角速度和输出力矩误差之间建立平衡的方法,并设计了一种新的操纵律。
应用推荐