In this paper, the problem of fail-safe technology in the microcomputer count axle set is discussed.
本文讨论了微机计轴装置中的故障一安全技术问题。
You should only set a vertical or horizontal axle and the software will do the rest.
你只需要设置水平和垂直坐标轴，然后软件就会完成剩下的工作。
The track rod length is set so that its connection to the track arm falls on an imaginary line taken from the king pin to a point on the vehicle center line just in front of the rear axle.
转向横拉杆长度的设置要保证转向横拉杆与转向节臂的连接点位于主销到后桥前端汽车中心线上的点所形成的假想连线上。
The track rod length is set so that its connection to the track arm falls on an imaginary line taken from the king pin to a point on the vehicle center line just in front of the rear axle.
转向横拉杆长度的设置要保证转向横拉杆与梯形臂的连接点位于主销到后桥前端汽车中心线上的点所形成的假想连线上。
The bond graph models of wheel-rail creep forces, of free wheel set, and of two-axle vehicle are developed with associated numerical calculations.
文中建立了轮轨蠕滑力、自由轮对和两轴车的键图模型，并给出了部分数值计算的结果。
On the basis of accurate theory, using laser emitter and photosensitive diode as testing sensor, a set of laser equipment for automobile axle depth of parallelism test is designed and produced.
利用激光发射器和光敏接收器作为检测传感器，基于准确的检测理论，设计出了激光检测法检测汽车前、后轴平行度的检测装置。
By applying the theory of reliability to the analysis of the life distribution and operating cost of car axle, the model of economical policy decision about repair cycle of car axle is set up.
通过对车轴寿命分布及其运用成本的分析，运用可靠性理论建立了车轴检修周期经济决策模型。
Speed sensors are set up on the central axle of pedals unit, roller axle of running unit and bearing point of paddles unit.
在自行车健身器中轴、跑步器的滚筒轴上及划船器的摇臂支点端还设有测速传感器；
When the shade is set to the folding status, the shade is folded adjacent to the standing post at one side (or two sides) of the playard via a rotary axle or other type of folding mechanism.
当遮光帘设置于收折状态时，遮光帘利用转轴或其他可行的收折方式收折在一侧（或两侧）的立柱旁。
The wire length quantity and number of lots can be set, and cut deep and strip length can be adjusted with 8 axle center.
采用伺服马达控制，且能自动调整搭配定寸送线、切断、剥皮、压着端子、沾锡等相关动作。
The wire length quantity and number of lots can be set, and cut deep and strip length can be adjusted with 8 axle center.
采用伺服马达控制，且能自动调整搭配定寸送线、切断、剥皮、压着端子、沾锡等相关动作。
应用推荐