Under certain axis ratio bandwidth, the circular polarization axis ratio of the optimized cross dipole antenna can reach 1.
在一定轴比带宽条件下，优化后的十字振子天线正交方向上圆极化轴比可以达到1。
Heat transfer characteristics and flow behaviors of elliptic cylinders with different axis ratio kin crossflow are investigated experimentally.
对横掠不同长径比的椭圆管的换热和流动特性进行了研究。
The effects of packing structure, azimuth factor, shape factor, orientating factor, axis ratio and size uniformity on the packing fraction have been also evaluated.
讨论了堆积结构、方位因子、形状因子、取向因子、轴比和粒度均匀性对堆积系数的影响。
In this paper, a control method of axis ratio and grain distribution of hexagonal ferrite is introduced, and improvement of sintered magnet orientation is discussed.
介绍了一种六角晶系铁氧体轴比及晶粒均匀性的控制方法，并对烧结磁体取向度的提高作了讨论。
This paper brings out feasibility and applicability to make change drive of double step sliding gear by moving one gear width along axis under conditions of Corresponding ratio of gear.
本文阐述了双联滑移齿轮在适当传动出情况下，轴向移动一个齿轮宽度就可以进行变速的可行性及适用场合。
The analysis indicates: the load amenity index ratio curve is very stable in all axis range, this indicates amenity index can better reflect the change of power load relative to temperature.
分析表明：负荷-舒适度指数比值曲线在整个坐标轴范围内比值很稳定，说明舒适度指数相对于温度能更好地反映电力负荷的变化。
In connection with its self properties, we make an inquiry into the major parameters, such as ratio of height and span, equation of arch axis, geometry size of section and so on.
针对该桥自身的特点，对拱肋矢跨比，轴线方程，截面的几何尺寸等主要技术参数做了探讨。
The ratio of the transverse plane width to the least axis of pedicle was largest at L5.
在L5椎弓根最小轴的横断面宽度比例最大。
When the distance of two nozzles was fixed, the offset of impinging stagnation point on the axis increased with the ratio of velocity and the nozzle diameter.
当喷嘴间距一定时，轴线撞击面驻点偏移量随气速比和喷嘴直径的增大而增大。
The amplitude ratio anomaly and the velocity ratio anomaly in HBC area can be usually seen at anticlinal axis areas and small noses.
在HBC地区的纵、横波振幅比异常和速度比异常多分布于构造的轴部和小鼻褶上。
According to this formula, the time of changing wheel is obtained, thus the ratio of warp velocity of base and crepe axis may be controlled during the whole weaving process.
利用公式可制订调换变换牙的时间表，从而能控制整个织造过程中泡、地经纱的送经比。
The PCF region and core diameter given are the average of three measurements along each axis, and the ellipticity is the ratio of the maximum to the minimum measurement.
有关地域的中心，给出了均匀直径三轴，沿着每个尺寸的椭圆率是最大的比例最小计量。
A structure of the switch is given, which has an ideal extinction ratio and is characterized by its easy alignment and no strict confinement of the length along Z-axis.
介绍了这类开关的一种结构，它有理想的消光比，并具有校准方便，对沿Z轴长度无严格限制等特点。
The influence of solidity and aspect ratio on power coefficient of H-type vertical axis wind turbine, and the change of attack Angle with tip speed ratio were analyzed.
采用多流管模型分析了H型垂直风力机展弦比和实度对其功率系数的影响，并对叶片旋转过程中攻角随尖速比的变化进行了分析。
It is shown that Although the deformation curve under the pressure of axis is well consistent between micro-concrete and normal-concrete, the elastic ratio and strength are different.
试验表明，虽然微粒混凝土和原型混凝土的轴心受压变形曲线是大体“相似”，但两者的弹模和强度存在差异。
It is shown that Although the deformation curve under the pressure of axis is well consistent between micro-concrete and normal-concrete, the elastic ratio and strength are different.
试验表明，虽然微粒混凝土和原型混凝土的轴心受压变形曲线是大体“相似”，但两者的弹模和强度存在差异。
应用推荐