The dynamic highway vehicle automatic weighing instrument needs to verify vehicle gross weight demonstration and vehicle axis load demonstration.
动态公路车辆自动衡器的检定需要对车辆总重量示值和车辆轴载荷示值分别检定。
Axis Definition - This is used to load information by rows and columns.
Axis定义—用于按行和列加载信息。
The number of users starts at some base value increasing along the X-axis where the load levels are doubled, tripled, etc. on up to 6x the original number of users.
用户数量以一定的基数随x轴增加时负载水平成两倍或三倍等一直到随初始用户数量的6倍增长。
When using universal finite element software to analyze PMSM, the relative position of stator and rotor axis is unknown, which is the precondition for load field calculation.
当采用通用有限元软件对永磁同步电动机进行分析时，存在着电机定转子轴线相对位置未知的问题，而确定这个相对位置是进行电机负载磁场计算的前提。
Axis line deflection and asymmetric load distribution of the rotary kiln induce the cracking of supporting shaft frequently.
回转窑运行中由于轴线偏移，支承载荷分配不均导致托轮轴疲劳断裂。
No beat or squeeze when connect load to the outer axis of gear speed reducer so that not to arise deformation and dislocation, bad noise or locked dead.
齿轮减速器的出轴与负载连接时不能重力敲打、挤压，以免造成内部变形走位，产生严重噪声或卡死现象。
This study successively and systematically investigated the hormone level of HPG axis during progressive increasing load volume exercise and recovery process.
对递增负荷运动过程中及恢复期大鼠hpg轴功能激素水平进行了连续、系统的动态观察。
The analysis indicates: the load amenity index ratio curve is very stable in all axis range, this indicates amenity index can better reflect the change of power load relative to temperature.
分析表明：负荷-舒适度指数比值曲线在整个坐标轴范围内比值很稳定，说明舒适度指数相对于温度能更好地反映电力负荷的变化。
The effects of generator parameters, quadrature axis stability winding and load on operation stability of the system are studied in detail.
详细讨论了发电机参数、交轴稳定绕组及负载对系统运行稳定性的影响。
The results showed that HPG axis function were fully inhibited and hormone levels decreased under the influence of long duration and heavy load.
对递增负荷运动过程中及恢复期大鼠HPG轴功能激素水平进行了连续、系统的动态观察。
If this load centroid is behind the elastic axis of the wing structure, then a nose-down twist of the main wing surface results.
如果该载荷重心在机翼结构弹性轴之后，则引起主机翼表面前端向下的扭转。
V-shaped notch blasting is that cutting slots with certain depth along axis -direction of the hole is determined according to the blast-crazing, and then load uncoupled charge and detonation.
形刻槽爆破是指在炮孔孔壁上按爆破开裂方向，切出一定深度的轴向对称V形槽，采用不耦合装药结构进行的一种断裂控制爆破。
Because of axis line deflection and asymmetric load distribution of rotary kiln, the support parts may break, spall, or erode due to the induced overlarge contact stresses.
回转窑运行中由于轴线偏差，支承载荷分配严重不均，导致支承部件因接触应力过大而产生压溃、剥落和点蚀等现象。
The reasons causing the fracture in view of the load on the manipulator and the structure of the floating axis are analyzed and precautions for preventing fractures are stated out.
从揭盖机所承受的载荷及其运行机构浮动轴的结构两方面分析了浮动轴断裂的原因，并找出预防其断裂的措施。
Portable axle load meter is by weighing is detected each axis (or group of axles) the weight of the vehicle, after accumulation and vehicle total weight.
便携式轴重仪是通过称量被检测车辆的每一轴(或轴组)的重量，经过累加，得到车辆的总重量。
Acting on the bearing axis line parallel to the direction of the load.
作用于平行轴承轴心线方向的负荷。
Acting on the vertical axis line direction of load bearing...
作用于垂直轴承轴心线方向的负荷。
When a belt pulley is adopted to transmit. the axis central line of motor should be parallel to load central line and be vertical with belt central line.
采用皮带传动时，电动轴中心线与负载轴中心线增行且要求皮带中心线与轴中心垂直。
The abnormal deformation or local damage of steel structure can be reflected by the load-deflection curve and the deflection curve of the longitudinal axis.
钢结构的异常变形或局部损坏可通过荷载—挠度曲线以及纵轴线的挠度曲线反映出来。
The three-member load frame has a plural of derivative types, such as axis partial parallelism, arc column type, arc beam type, and their composite type.
三杆承载机架有许多派生型：如轴线局部平行型、弧线柱型、弧线梁型以及它们的复合型。
The MIMS uses 4 multi-axis piezoelectric load cells to measure the forces and moments in the sill clamps.
MIMS使用4个多轴压电式力传感器测量在门槛夹紧器中的力和扭矩。
The experimental results of short concrete-filled steel tubular under axis-compression load show that the mechanical properties of SCC-filled steel tubular are similar to the normal concrete (NC).
自密实钢管混凝土与普通泵送钢管混凝土的轴心受压对比试验表明，两者的力学性能相近。
On the basis of studying the factors to affect the running condition of rotary kiln, the linear relation is set up between kiln load distribution and axis deviation;
在研究回转窑运行状态影响因素的基础上，建立了回转窑载荷分配与轴线变化的线性关系式；
Too much lip-axis will increase the load-side contacts, while the shaft is too small it will end lip of the seal contact surface pressure enough.
过大的轴会增加唇端的接触载荷，而过小的轴则会使唇端接触面上的密封压力不够。
Too much lip-axis will increase the load-side contacts, while the shaft is too small it will end lip of the seal contact surface pressure enough.
过大的轴会增加唇端的接触载荷，而过小的轴则会使唇端接触面上的密封压力不够。
应用推荐