Testing based on stuck-at fault model is insufficient for high performance ICs, especially for CMOS circuits.
基于固定型故障模型的测试方法已不能满足高性能集成电路，尤其是对CMOS电路的测试要求。
The electric locomotive bang-bang circuit is converted into an equivalent digitalcombinational logic circuit for setting up its stuck-at fault model.
本文将机车继电器控制电路等效为数字组合逻辑电路，建立了它的固定故障等效模型。
Aiming at fault model of sensors failure with state feedback control system, a new method of controller reconfiguration with system stability is proposed.
针对状态反馈控制系统传感器失效故障模型，提出了基于系统稳定性设计的控制器重构新方法。
But, because of the weakness of the fault model used and being not able to run at-speed, voltage based testing, generally speaking, is only good at verifying IC's functions.
但是，由于电压测试所使用的故障模型存在局限性，而且测试常常不能全速进行，因此一般来说，电压测试只善于验证电路的功能。
The model calculation results indicate that shear fracture energy of a fault generally increases with depth; at a certain depth it reached a peak value, then turns gradually attenuated.
模型计算结果表明，断裂的剪切破裂能随深度增加通常呈现先上升，在某一深度上达到峰值后逐渐衰减的形态。
Traditional fault analysis methods for transmission line mostly adopt lumped parameter model, so the distributed parameter characteristic of real transmission line can't be reflected at all.
传统的故障分析法多采用集中参数模型，无法反映真实线路的分布参数特性。
At present, two main stochastic models, point-source model and finite-fault model, are adopted to simulate ground motions.
随机法模拟地震动目前主要采用点源模型和有限断层模型两种方法。
In addition to considering the uncertainties of load forecasting at each node, the fault occurrence location and the fault-clearing time, the uncertainty of load model is also taken into account.
其中除计及了节点注入功率不确定性、沿线事故发生地点的不确定性以及事故清除时间的不确定性外，还计及了负荷模型的不确定性。
In addition to considering the uncertainties of load forecasting at each node, the fault occurrence location and the fault-clearing time, the uncertainty of load model is also taken into account.
其中除计及了节点注入功率不确定性、沿线事故发生地点的不确定性以及事故清除时间的不确定性外，还计及了负荷模型的不确定性。
应用推荐