If you have added the XercesLib DSP to your workspace, remember to mark your own project as dependent upon the XercesLib project; otherwise, you will be greeted with link errors.
如果在工作空间中添加了XercesLibDSP，记得要将自己的项目标记为依赖于XercesLib项目，否则，就会得到链接错误。
This paper uses DSP as control chip, and has achieved double control for system.
该文采用了DSP作为控制芯片，实现了系统的双闭环控制。
This paper introduces a method of hardware constitution and software design of embedded system containing Ethernet interface and adopting DSP as its core processor.
介绍了以DSP为核心具有以太网接口的嵌入式系统的硬件电路组成和软件设计方法。
So, the thesis adopts a type of low loss DSP processor as main controller which composing the control and fault feeder detection system based on DSP in order to deal with the question.
因此论文采用了低功耗的数字信号处理器作为主控芯片，构成一种基于数字信号处理器的控制与选线系统。
In order to satisfy the quick operating speed, strong timeliness , the higher request precision , we have selected TI Corporation's DSP chip TMS320C5416 as the core carry on the system design.
为满足运算速度快、实时性强、精度要求高等要求，我们选用了TI工公司的DSP芯片TMS320C5416为核心进行系统设计。
And then, designed hardware circuit and software flow, realized a sample using TMS320F2812 DSP as kernel controller.
最后，设计了变换器的硬件电路和软件流程。实现了以TMS320F 2812DSP芯片为控制核心的样机。
Design a position control module which USES DSP as the main chip.
设计了以DSP芯片作为控制核心的位置控制模块。
A slip frequency control system of asynchronous motor used DSP as control center is presented, which apply to the electric tourist car.
介绍一种以dsp为控制核心的异步电动机转差频率控制系统在电动游览车中的应用。
How to choice parameters of PFC main circuit using DSP as control center is described, what is more, two methods to select parameters of PID adjuster are also discussed.
文中讨论了采用数字信号处理器(dsp)作为控制核心时PF C主电路参数的选择，并详细讨论了两种数字PID调节器参数的确定方法。
In view of the present situation, in this paper, a new moisture analyzer which combines infrared drying oven and electronic balance is proposed takes DSP as the information processing unit.
针对这一现状，本文提出了一种将红外干燥箱和电子天平相结合，利用DSP作为信息处理单元的水分测定仪；
In the system, we select TI company 's TMS320C6711 DSP chip as our encoding chip.
在该系统中，选择了TI公司性价比较高的一款芯片TMS320C 6711作为编码器件。
A novel design of spectrum signal processing system was presented, using TMS320C6713 DSP with CPLD as its key processor.
以TMS320C 6713DSP为核心处理器，用CPLD加以配合，提出了一种新的光谱信息处理系统的设计方案。
Taking the DSP processor as the key, the paper mainly discussed the working principle, hardware and software design of the system.
该系统以dsp处理器为核心，重点讨论该系统的工作原理、硬件结构、软件设计。
A speed sensorless direct torque control (DTC) system that USES TMS320LF2407A DSP as its core is designed in this paper.
本文实现了以TMS320 LF 2407ADSP为控制核心的无速度传感器直接转矩控制系统。
The practice experiment utilizes the TMS320F240 type DSP as the kernel control chip.
用TMS320F240型号的DSP作为核心控制芯片，完成实验。
In hardware, we take TMS320LF2407A DSP as the controller, and the digital interface and the simulation connection based on its EVM board are expanded.
在硬件方面，以TMS320 LF 2407 ADSP为控制器，基于其EVM板分别扩展数字接口和模拟接口。
Designed a position control module with DSP as core.
设计了以通用DSP芯片作为控制核心的位置控制模块。
And then it puts forward study on the high speed switch valve, using GMM as valve's core, adopting DSP as controller and designing bus communication interface.
在此基础上提出了以超磁致伸缩材料为阀芯，以DSP为控制器，带有总线型接口的高速开关阀的研究课题。
To realize real time closed loop control, high performance 16-bit DSP TMS320F240 is adopted as control kernel.
控制系统以16位数字信号处理器TMS320F 240为核心，对整个电源进行了实时的闭环控制。
The Railway Signal Process System which has a lot of advantages such as real time and anti- jamming consists of the core DSP chip TMS320C2812 and the external A/D converter TLC2574.
采用DSP芯片TMS320C2812为核心器件，结合外部A/D转换器TLC2574，组成机车信号处理系统，具有实时性和抗干扰性等优点。
According to the demand of the system control, the DSP - TMS320LF2407A is chosen as the control chip of the drive motor.
根据系统的控制要求，选用TMS320 LF 2407 A作为驱动电机的控制芯片。
The hardware prototype is composed of the whole processes from obtaining residual error to Macro-Block reconstruction, and it can be used as a co-processor of DSP to fulfill H. 264 real-timing CODEC.
该硬件原型包含了从残差形成到宏块重建的变换量化全过程，其可以构成DSP的协处理器，用于完成H。 264实时编解码。
According to the gyro-compass structure and the characteristic, this article introduced one kind methods of the ships repeater compass development based on DSP embedded as microprocessor.
本文根据电罗经的结构和特点，介绍了一种基于嵌入式DSP作为微控制器的船舶电罗经复示器的研制。
This design USES digital signal processor (TMS320LF2407 DSP) as a control chip, which helps the system to improve the real-time control capability and data processing capability.
设计采用数字信号处理器(TMS320 LF 2407dsp)作为主控芯片，能提高控制系统的实时性和数据处理能力。
Currently, in the practical application fields, we usually use specialized hardware, software or firmware to realize cryptosystems, such as ASIC, FPGA, DSP or smart CARDS.
在实际应用领域中，我们通常使用专用硬件、软件或固件来实现如asic、FPGA、DSP或智能卡等密码算法芯片。
A demonstration system with DSP as controller used for testing double-axis tracking control techniques is designed by using four-quadrant detector as position sensor.
采用四象限探测器作为位置传感器，设计出以dsp作为控制器的双轴跟踪控制试验演示系统。
The proposed DSP employs parallel processing techniques, such as SIMD, vector processing, DSP schemes and adopts low power features for wireless applications.
提出的DSP采用了并行处理技术，如SIMD、矢量处理和DSP结构，并且采用了无线电应用的低功耗特性。
The standout performance, the special architecture, powerful processing capability, as well as low power consumption, makes DSP most suitable for the future multimedia application.
DSP以其体系结构上的特殊性，强大的处理能力和相对较低的功耗水平，特别适合于多媒体领域的应用。
The standout performance, the special architecture, powerful processing capability, as well as low power consumption, makes DSP most suitable for the future multimedia application.
DSP以其体系结构上的特殊性，强大的处理能力和相对较低的功耗水平，特别适合于多媒体领域的应用。
应用推荐