It is shown theoretically that the fractional lower order array output power is bounded when the fractional lower order is less than half of the characteristic exponent of the noise.
理论上证明了当阶数小于噪声特征指数的一半时，分数低阶阵列输出功率有界。
Traditional Radioisotope micro Battery (RMB) with direct conversion device of single layer array does not meet the requirements of micro sensor devices for its lower output power.
传统同位素微电池的能量转换结构采用单层阵列形式，造成电池输出功率较小，不能满足微型传感器件的需求。
This paper analyzes the effect of channel mismatch on the performance of adaptive array. The relation between channel mismatch, jamming power and output SINR of adaptive array is given.
本文分析了通过失配对自适应阵列性能的影响，给出了通道失配、干扰功率与自适应阵列输出信干噪比之间的关系。
In order to increase the output power of incoherent fiber laser combination, the optimized methods are put forward, mainly concentrating on the fiber laser array.
为了增加光纤激光非相干组束的输出功率，针对光纤激光器阵列提出了优化的方法。
The multiple pump sources are used to increase the output power of single fiber laser, and the two dimensions arrange of fiber laser array increases the number of combining fibers.
利用多泵浦源提高单根光纤激光器的输出功率，利用二维光纤激光阵列排列增加参与组束的光纤数目。
With an array of characters and an array of storage, respectively, and the names of scores of students, and then sort sorting algorithm, and finally by the lower power output.
用一个数组和一个字符数组分别储存学生的分数和姓名，然后用排序算法进行排序，最后按降幂输出结果。
We show how to optimize a spatially smoothing adaptive array such that the white noise power in the array output, or the sidelobe levels of the adaptive array beam pattern are reduced.
我们指出如何优化空间平滑自适应阵列使得白噪声功率或者阵列的副瓣尽量降低。
On the basis of this model, PV-array simulation model with any power output has been built by equivalent conversion of circuit according to the relation between PV cell and PV array.
在此基础上，通过分析光伏阵列和光伏电池的关系及电路等效变换，建立任意功率级的PV仿真模型。
The sensing output is also transmitted in a contactless way, so there is no-cable connection for signal readout and power supply to the array or between the elements in the array.
传感器单元间，输入和输出均采用非接触的无线方式，无需电线连接。
The sensing output is also transmitted in a contactless way, so there is no-cable connection for signal readout and power supply to the array or between the elements in the array.
传感器单元间，输入和输出均采用非接触的无线方式，无需电线连接。
应用推荐