But the argon plasma arc voltage, low enthalpy is not high, cutting ability is limited, and cut the air than the thickness of the cut about 25% lower.
但氩气等离子弧的电压较低，焓值不高，切割能力有限，与空气切割相比其切割的厚度大约会降低25%。
It was shown that the main technological parameter affecting the performance of the coating was arc current, and then the thickness of the coating.
电弧电流和涂层厚度之间有一定的交互作用。涂层孔隙率是影响涂层性能的主要原因。
The properties of charge distributions and the effect of inner conductor thickness arc also discussed.
本文还对高次幂电荷分布特征和内导体厚度效应作了讨论。
The thickness of uie elliptical heads at the both ends of the reaction tank was seriously reduced in the transition area of the small arc by improper processing.
一台反应釜两端所采用的椭圆封头因加工工艺不当，封头壁厚在小圆弧的过渡段出现严重减薄。
Minimal film thickness and central film thickness of arc cylindrical worm drive were calculated under different rotation Angle.
计算了圆弧圆柱蜗杆传动在不同的蜗杆转角下的中心膜厚和最小膜厚。
Diamond film wafers with different thickness were prepared by high power DC arc plasma jet CVD method.
采用高功率直流电弧等离子体cvd工艺制备了不同厚度的无裂纹自支撑金刚石厚膜。
Welding hot staring arc adjustable, applicable for starting arc of different thickness of work piece. Thrust current can be regulated, suitable for various welding process requirement.
焊接热引弧可调，适用于不同板厚工件的焊接引弧。推力电流可调，适用于各种焊接工艺要求。
The plasma arc welding have a high energy density, thick welding thickness that can weld for single time.
等离子弧焊具有能量密度高，一次性可焊厚度大等优点。
Using commercial sodium silicate as electrolyte, aluminum surface was treated with plasma micro-arc oxidation under alternate current, film thickness increased with the increase of voltage.
以工业级硅酸钠为电解液，铝材在交流电压作用下进行等离子微弧氧化反应，电压升高，膜厚增大。
The distribution of large-sized inclusions was non-homogeneous along thickness direction of slab, which contents of inner arc slab were obviously higher than those of outer arc slab.
铸坯中的大型夹杂物在厚度方向分布不均匀，内弧含量要明显高于外弧含量。
The formulas to compute the charred thickness are derived based on its ablation mechanism and the methods to determine its design thickness arc given based on thermal protection for the chamber case.
根据内绝热层的烧蚀机理，推导出内绝热层炭优厚度计算公式；根据燃烧室壳体对热防护的要求，给出了确定内绝热层设计厚度的方法。
The mapping model of film thickness of micro-arc oxidation(MAO) on magnesium alloys is built on BP neural network with three layer structure.
选择三层结构的BP神经网络，建立镁合金微弧氧化膜厚的映射模型。
Its very important to control the thickness of the film in the process of the pulsed vacuum arc deposition (PVAD).
在脉冲真空电弧离子镀膜过程中，膜层厚度的控制至关重要。
The effects of oxidation time on the density, thickness and corrosion resistance of the micro-arc oxidation coatings of MB8 magnesium alloy were investigated.
研究氧化时间对MB8镁合金氧化膜致密度、厚度和耐蚀性的影响，分析不同氧化时间膜层表面微观形貌、成分和结构的变化。
Magnetic working substance area is circular arc with certain radial thickness, and has certain gap with stator permanent magnetism block.
磁工质区域为圆弧形，有一定的径向厚度，与定子永磁块间留有一定的间隙。
In the finality of this article an experiment study about plasma arc cutting variable-thickness plate is introduced.
本文的最后部分对等离子体弧切割变厚度板材进行实验研究。
The saw cutting direction directly affects the pressed wall thickness, the contacting arc length between saw disc and pipe has direct ratio to the cutting circumference force through analysis.
分析认为，锯切方向直接影响着管壁的受力状态，锯片与管子的接触弧长和锯切圆周力成正比关系。
The saw cutting direction directly affects the pressed wall thickness, the contacting arc length between saw disc and pipe has direct ratio to the cutting circumference force through analysis.
分析认为，锯切方向直接影响着管壁的受力状态，锯片与管子的接触弧长和锯切圆周力成正比关系。
应用推荐