And then, the design of software in PC and communication protocol between PC and temperature logger are introduced.
然后，介绍了上位机软件设计以及上位机与温度记录仪之间的通信协议设计。
Cipher Card can offer cryptogram service to PC system and network security device to realize safe storage for files and secure communication for information on network.
加密卡可以为个人计算机系统、网络安全设备提供密码服务，以实现数据的安全存储和网络信息的保密通信。
With the use of KingView communication with single-chip, this design measures the analog signal and finally displays vivid image in PC.
利用组态王和单片机通信进行模拟量的测量，在PC上应用生动形象的画面进行显示；
Through the CAN interface and PC-CAN adapter, we realize communication between the CAN node and the PC.
通过CAN接口与PC - CAN适配卡实现了现场测控点与工控机间的通讯。
It focuses on Heat Sink, hi-tech communication connectors, PC connectors and Cable assembly.
公司主要生产散热器、通讯连接器、电脑连接器与线束装配等高级电子配件。
The serial communication between DSP and PC based on GPRS has the advantages of simpleness, good practicability and high dependability.
基于GPRS的DSP与PC机串行通信技术具有简单、实用性好、可靠性高等优点。
The method carries out the wireless communication between the PC and active lap, by the conjugation of bluetooth module controlled by MCU via HCI and bluetooth module connected with PC via RS232.
该方法利用单片机控制蓝牙模块，采用基于HCI层的单片机对蓝牙模块控制的方法及PC机端通过RS232接口连接蓝牙模块互相配合，实现PC机与能动磨盘之间的通信。
The problem in the communication between DSP and PC based on RS-485 is presented, and the solution of common-mode disturbance and EMI which are generated by incorrect ground connection is stated.
DSP与PC机的通讯以RS-485为基础，分析了RS-485总线在组网过程中因地线的不正确连接引发的共模干扰和EMI问题，并提出了解决方法。
This paper presents the realization on serial communication of AT89C52 SCM and PC, including hardware structure and software design.
本文介绍了AT 89 C52单片机与PC机之间串行通讯实现，包括硬件结构及软件设计。
In hardware handling, realize the communication of PC and external hardware with serial communication.
在硬件处理中，用串行通信实现PC机与外部硬件的通信。
Faint signal detection system communication between DSP processing system and PC managing system are described in the detail in back of this article.
本文后半部分就小信号检测系统的随机共振算法以及DSP系统与PC机间的通信进行了详细的描述。
The hardware is constructed with embedded PC, communication card and field bus data acquisition module.
系统硬件采用了嵌入式PC、通讯接口卡和现场总线数据采集模块。
Hardware is designed based on portable industrial PC, data communication card and data acquisition card. Software is developed with virtual instrument development platform.
硬件采用便携式工控机、通信接口卡和数据采集接口卡，软件基于虚拟仪器开发平台开发。
An intelligent inducing ventilating control system of underground garage was composed of many inducing ventilating controllers, RS-485 communication network and PC monitor modules.
地下车库的智能型诱导通风控制系统由多个诱导风机控制器、RS- 485通信网络及PC监控模块组成。
Realizing the data processing and analysis of the modern voltage transformer characteristic must solve the serial communication problems of the PC and DSP.
要实现对现代变压器特性试验仪的数据处理和分析，必须解决PC机和DSP的串行通信问题。
The design of the software includes three parts as following: the network communication between PC and controller, NAT9914 firmware and DLL (dynamic link library) program.
软件部分的设计共包括三大部分：PC机与控制器间的网络通信机制，NAT9914固件程序以及动态链接库程序。
Its hardware is composed of DSP controlling board and motor driving board. There are two choices for the serial communication between the DSP board and the PC.
控制系统硬件部分由DS P控制板和电机驱动板组成，DS P控制板与上位机之间的串口通讯有无线和有线两种方式可以选择。
IBM PC and single chip microcomputer communication hardware circuit, software interface and measure to improve reliability of communication.
IBMPC机与单片机通讯的硬件电路、软件接口以及提高通讯可靠性的措施。
And in the communication module, the system answers for communication between PC and CNC through the port communication and CNC equipment.
通讯模块通过串口通讯与数控设备通讯，负责上位机与数控器之间的通信。
A serial communication between the PC and MCU are designed.
设计了PC机与单片机之间的串口通信电路。
Transmitting and receiving circuits and serial communication and control interface between PC and microcontroller are described in detail.
详细介绍了光发送、光接收电路和单片机与微机的串行通信控制接口。
The core of data transmitter is MSP430F149 SCM, which can realizes the data communication between PC and electric meter reader by three communication methods.
数据转发器以MSP430F149单片机为核心，它能通过三种通信方式实现主机与电表抄表器的数据通信。
PC and DSP can exchange data each other through RS-232C serial communication.
上下位机之间通过RS-232C串行通讯交换数据。
It consists of a decoding microcontroller and a PC, and applies to meteorological sounding and other Morse code communication equipments.
它由译码单片机和PC机组成，适用于气象探空及其他莫尔斯码通信设备。
The methods and program of communication between PC and PLC are presented in this paper.
介绍了如何实现系统中PC与PLC之间通讯的方法，并给出实例程序。
It is analyzed that the usual problem in multi computer serial communication protocol between PC and single chip microcomputer, put forward that a kind of communication protocol strategy.
通过对PC机与单片机多机串行通信协议中常见问题进行分析，提出了一种通信协议的制定策略。
The principle and protocol of the multicomputer communication between the PC master and the different slaves are discussed, and it solves the address identification between different slaves.
讨论了PC主机与多台不同类型的从机进行多机通信的通信原理以及通信协议，解决了不同类型从机的地址识别问题。
This paper achieves the synchronous serial communication between DSP and PC based on TL16C750, thus improving systems'power of controlling communication interfaces.
文中通过扩展异步通信芯片TL16C750 实现DSP和PC 机之间的异步串行通信，从而增强系统的通信接口控制能力。
This paper achieves the synchronous serial communication between DSP and PC based on TL16C750, thus improving systems'power of controlling communication interfaces.
文中通过扩展异步通信芯片TL16C750 实现DSP和PC 机之间的异步串行通信，从而增强系统的通信接口控制能力。
应用推荐