Two power amplifier output stage using PMOS and NMOS transistors by the special design.
两个功率放大器的输出级均采用PMOS和NMOS晶体管特殊设计而成。
Compensation: This pin is the Error Amplifier output and is made available for loop compensation.
该引脚是误差放大器的输出，并提供环路补偿。
Second, a push-pull class A amplifier output stage will have inherent rejection of power supply ripple and noise.
第二，推挽A级放大器输出阶段将拥有固有拒绝电源纹波和噪声。
After start-up, the low amplifier output impedance reduces reference current variations due to the current through R1.
完成启动后，放大器很低的输出阻抗将会降低因流经R1的电流不足以影响稳压管上的电压稳定性。
There is provided an amplifier for combining outputs of a plurality of amplifying circuits to generate an amplifier output.
提供一种放大器，用于组合多个放大电路的输出以产生放大器输出。
Third, rail-to-rail AMPLIFIER OUTPUT stages exhibit load-dependent gain which affects AMPLIFIER open-loop gain, and hence closed-loop gain accuracy.
第三，轨到轨放大器的输出状态表现出影响开环增益从而影响闭环增益精度的负载增益效应。
Negative feedback makes the amp sound "tighter", particularly in the low end, where the speaker resonant hump has the most effect on amplifier output.
负反馈使放大器声音“更严格”，尤其是在低端，那里的一位发言者谐振驼峰拥有最影响放大器输出。
AT89S52 as a display module to control the core of achieving power amplifier output power, DC power supply of power and machine efficiency, for display.
AT 89s52作为显示模块的控制核心，实现功率放大器输出功率、直流电源的供给功率和整机效率功能的显示。
Third, rail - to - rail amplifier output stages exhibit load - dependent gain which affects amplifier open - loop gain, and hence closed - loop gain accuracy.
第三，轨到轨放大器输出级增益与负载有关，这将影响放大器的开环增益，当然也影响了闭环增益的准确性。
As improved, input buffer circuitry comprises a pull up stage to pull up the voltage of the differential amplifier output slightly higher during an output low condition.
作为改进，输入缓冲电路组成的阶段拉一拉期间的输出低的条件差分放大器的输出电压略高。
Contour modulation is a technique in which a phase-modulated signal waveform and amplifier output impedance work together to maintain higher efficiency over a sizable output power back-off.
轮廓调制结合了一种相位调制信号的波形和放大器的输出阻抗，可在某个较大型输出电源关闭后保持更高的效率。
If the efficiency of servo amplifier is considered, it is practicable that the power supply voltage is about 3 times as large as the servo amplifier output voltage corresponding to rated current.
若考虑伺服放大器效率及电源功率等因素，伺服放大器电源电压应取额定输出电流所对应的伺服放大器输出电压的3倍左右为宜。
The theory research results of one cycle controlled switching power amplifier show that the output signal follow the input signal linearly, and the control performance is decided by output filter.
理论分析结果表明，单周控制开关功率放大器的输出信号与输入信号成线性变化关系，其控制性能由输出滤波器决定。
Upon reception of a burst detection start trigger signal, a gain control signal is output to an automatic gain control amplifier (201) so as to perform amplification with a maximum value.
当接收到短脉冲检测开始触发信号时，向自动增益控制放大器(201)输出一个增益控制信号，以便用最大值进行放大。
The term "efficiency" refers to the ability of a speaker system to convert electrical energy (power from the amplifier) into acoustic output.
术语“效率”是指扬声器系统将电能（功放的推力）转化为声音输出的能力。
A pulse to gate the output of a core memory sense amplifier into a trigger in a register.
将磁心存储器读出放大器的输出选通到寄存器的触发器中的一种脉冲。
It is only when the correct voltages are applied to the A/C amplifier from the key inputs that the primary output (the A/C compressor relay) will be energised.
只有A/C扩大器上的电压是来自输入端的正确电压时，初级输出（即A/C压缩机继电器）才会被激活开启。
This limiting amplifier composed of an input buffer, amplifier cells, output cells, and offset cancellation circuit.
此限幅放大器由输入缓冲、主放大单元、输出缓冲、偏置补偿电路四部分组成。
No matter what the output impedance of the amplifier is!
这和放大器的输出阻抗究竟是多少无关。
Purpose: TV vertical output, audio output driver and general purpose amplifier applications.
用途：用于电视场输出，音频放大驱动级及一般放大。
B, no noise tracking method: input power amplifier (RCA), released the CD signal output, check whether there is noise.
没有噪音的跟踪方法：将功放的输入(rca)恢复，解除CD机的讯号输出，检查是否有噪音。
Negative feedback occurs when a portion of the output signal of an amplifier is fed back and subtracted from the input signal, causing a reduction in the effective input signal.
所谓负反馈是指输出信号的一部分被送回输入端，与输入信号相减，从而削弱了有效输入信号。
The simulation results show the open-loop and closed-loop frequency responses, output saturation, and the slew-rate of operational amplifier are truly reflected by this model.
仿真结果显示，运放开环与闭环时的频率响应、输出饱和、转换速率等特性得到了真实的反映。
This method suits for pumping the fiber laser and amplifier of several watts output power.
该方法适用于输出功率为数瓦的光纤激光器和放大器的侧面抽运。
Output from the inverting oscillator amplifier.
内部反向振荡放大器的输出。
The coupling efficiency of the amplifier and the factors affecting the output power improvement are investigated.
研究光纤放大器的耦合效率以及影响输出功率的因素。
The coupling efficiency of the amplifier and the factors affecting the output power improvement are investigated.
研究光纤放大器的耦合效率以及影响输出功率的因素。
应用推荐