The maximum inductance corresponds to the minimum reluctance pole-aligned position.
最大感应性对应于极小的勉强杆被排列的位置。
An output pixel is generated using such motion vectors, but it is possible (indeed, likely) that the output pixel is not exactly spatially aligned with a required pixel position in the output image.
利用这种运动矢量生成输出像素，但是该输出像素有可能(实际上是很可能)与输出图像中的所需像素位置未精确地空间对准。
These two subs are not properly aligned, as you can see from this position.
这两个接头不同心，你可以从这个位置上看出来来。
Adjust windshield glass position until it is aligned with the flanges and adhesive.
调整挡风玻璃位置直至与凸缘和粘结剂对准。
NOTE: the valve is shipped in the closed position. The indicator on the plastic sleeve is aligned with the vertical scribed line on the stem.
注意：阀门装运时是处于关闭位置。塑料套筒上的指示器与阀杆上的垂直刻线对齐。
When the cam has been set at the desired free resting position, "either closed or open" the top of the affixed components will be aligned.
如果在所需的停止位置设置凸轮，则无论是开还是关，所配置的隔间顶部都要对齐。
Before they reach the cleaning and filling station, a scanner checks that the tubes are aligned correctly so that the printing is in the correct position when the base is sealed later.
在它们到达清洁和填装站之前，使用一台扫描仪检查是否已经正确对齐，这样在后期密封基部时印刷的位置正确无误。
The rafters and the posts are regular and aligned but the position of the collar beams is progressively shifted — to sustain the various stresses: triangulation or cantilever beam.
椽和柱为规律的直线排列，但是系梁的位置却逐渐偏移，或采用三角梁或采用悬臂梁的形式，以承受不同的应力。
Using an industry standard Size 15 modular mounting pattern, the index mark on the disc hub can be coarse aligned to the index sensor position on the housing.
使用业界标准尺寸15模块化安装模式，光盘上的枢纽指数标记可以粗对齐房屋价格指数上的传感器的位置。
Alignment: Typographic term to indicate the position of each type is perfectly aligned across a base line. The term in full is base alignment.
基线对齐：印刷字体学的术语。指每个字母都沿着它的基线对齐位置。
The rotor is aligned to a certain position specified in DC excitation mode for the period of (a), during which the IP pin voltage decreases from VREF to VREF/2 level.
在IP引脚电压从VREF降低至 VREF / 2期间，在阶段（a）转子在直流励磁模式下对准某一指定的位置。
The partition plates of the components must be aligned in operating position.
部件隔板必须对准操作位置。
The pivoting, hinged shroud automatically stays aligned with the camera position, yet easily swings away for positioning.
旋转，带铰链的护罩能自动与相机位置保持一致，也能轻易地偏离定位。
His recommendation is to position the Primary action (OK) aligned to the left part of the form and the Secondary action (Cancel) to the right.
他建议把首要动作“确定”放置在表单的左侧，次要动作“退出”放置在表单右侧。
His recommendation is to position the Primary action (OK) aligned to the left part of the form and the Secondary action (Cancel) to the right.
他建议把首要动作“确定”放置在表单的左侧，次要动作“退出”放置在表单右侧。
应用推荐