The edges of the grooves after etching are plane and smooth. The depth and width of the grooves can solve the interference problem induced by the injection current between the adjacent pixels.
腐蚀后的上隔离沟槽边缘平整，其深度和宽度可以解决注入电流在相邻像素之间产生的干扰问题。
Objective:To investigate the appearance of enamel on the cross section of tooth after etched with 37% phosphoric acid for different etching time .
目的：观察用37%磷酸凝胶以不同酸蚀时间处理后的牙釉质在牙齿横断面上的形态改变。
Photoluminescence (PL) measurements show that, the photoluminescence intensity of the quantum Wells is enhanced about 3 times after dry etching.
通过光致发光(PL)特性表征发现，干法刻蚀后量子阱光致发光强度较未刻蚀量子阱光致发光强度提高了近3倍。
According to the process condition and surface appearance of aluminium alloy after alkaline etching, etching solution was maintained. The common failure and trouble shooting were presented.
根据铝合金碱蚀工艺条件和铝材碱蚀后的表面状况，对碱蚀槽的槽液进行维护，提出了碱蚀常见故障和排除方法。
The shape, distribution and density of etch pits on the (101) face was observed by metalloscope after chemical etching.
单晶，通过化学腐蚀和金相显微镜研究了（101）晶面蚀坑的形貌、分布特征及其密度的大小。
The surfaces of the sample are decontaminated effectively first by chemical etching and then by heating directly in a stream of oxygen after placing sample on loading arm.
先经化学腐蚀再在试样臂上用纯氧加热可以有效地消除试样的表面沾污。
Plenty of oxidation etching pits are found on the surface of the specimen after the thermal fatigue test, and the surface principal crack is prone to propagate through these etching pits.
实验结果发现，试样表面出现大量的氧化腐蚀坑，表面主裂纹优先通过这些腐蚀坑扩展。
Methods: To treat teeth with fluoride treatments before or after etching.
方法：在酸蚀前后分别用氟化泡沫对牙釉质进行氟化处理。
The distribution of residual stress along depth gained through layer-by-layer measuring method after chemical etching is in line with that measured by multi-wavelength method.
化学蚀刻后逐层测试所得应力沿深度分布与用多波长法测试结果趋势一致，大小略有差异。
Objective: To prevent enamel opaque spot after orthodontic etching.
目的：预防口腔固定正畸酸蚀牙釉白斑的发生。
A method to study the sacrificial layer etching in nanometer is proposed after lots of experiments.
通过大量的实验研究，建立了一套纳米量级牺牲层腐蚀行为的实验研究方法。
Conclusion: Fluoride treatments can reduce the incidence rate of enamel opaque spot after orthodontic etching.
结论：氟化处理可降低口腔固定正畸患者釉白斑的发生率。
Surface damage caused by cutting on Si, InSb, HgCdTe has been studied by Reflection High Energy Electron Diffraction (RHEED) after step-etching the samples.
利用高能反射电子衍射技术（RHEED），研究了硅、锑化铟、碲镉汞样品逐次化学腐蚀后的切割表面损伤。
The crystallinity and crystal grains reduced slightly after ultrasonic etching.
这种处理会使纤维的结晶度和晶粒尺寸均小幅下降；
In 1978, I used my first wood-cutting knife in Hangzhou, China. In 2002, my last etching plate was accidentally discarded after two trial impressions in Portland, Oregon.
1978年在中国杭州第一次拿到木刻刀，2002年在美国波特兰丢了仅仅打了样的最后一块铜版，做了二十五年版画。
In 1978, I used my first wood-cutting knife in Hangzhou, China. In 2002, my last etching plate was accidentally discarded after two trial impressions in Portland, Oregon.
1978年在中国杭州第一次拿到木刻刀，2002年在美国波特兰丢了仅仅打了样的最后一块铜版，做了二十五年版画。
应用推荐