Influence of Storage Methods on Microtensile Bond Strength of Dentin Adhesive System.
离体牙储存方式对牙本质粘结系统微拉伸强度的影响。
So, use the proper adhesive system to make the rubber and metal bonding is considered to be the most effective method at present.
因此，使用适当的胶粘剂系统来实现橡胶与金属粘合被认为是当前最有效的方法。
The self-adhesive resin cement and self-etching adhesive system may gain higher bonding strength than total-etching adhesive system.
结论：三种粘结系统对纤维桩的粘结强度差异显著，自粘结组和自酸蚀组优于全酸蚀组。
The aperance and the mechanic properties of epoxy resin and low molecular polyamide adhesive system would be affected by the addition of mannich amide.
在低分子聚酰胺树脂固化环氧树脂的体系中 ，通过添加一定量的酚醛胺固化剂 ，直接影响该体系的表观及固化物力学性能。
Test results showed that when the two curing agents were added into the adhesive system within a proper ratio, the strength of the adhesive woule increase.
实验证明，酚醛胺固化剂与低分子聚酰胺的协同效应在一定范围内对固化物强度有较大提高，但酚醛胺的加量并非越多越好。
Objective:To compare the effect of FL-Bond adhesive system with that of total etching adhesive system, that in treating wedge-shaped defect with light cured composite resin.
结论表明自酸蚀粘接系统的复合树脂修复牙体楔状缺损与全酸蚀粘接系统相比，具有固位性好、边缘封闭性强、对牙髓刺激小、成功率高等优点。
In the hydraulic system USES the accumulator, may the absorption line shock maximum limit, reduce to the variation of load to the adhesive tape the impact, enhances adhesive tape's service life.
液压系统中采用蓄能器，可以最大限度的吸收液压冲击，减小对负载变化对胶带的冲击，提高胶带的使用寿命。
Test results show that the single layer glass, the lined adhesive glass ribs and the point-supported glass curtain system are of enough earthquake safety.
试验结果表明：单层及夹胶玻璃肋以及整个点支式建筑幕墙系统均有足够的抗震安全性。
Micro adhesive bonding technology shows great potential in the assembly of micro-electro-mechanical system (MEMS) products.
微胶接技术非常适用于微机电系统产品的自动化装配过程。
There is great difference in the performance among the different epoxy curing system, the kinds and the contents of the modified components have influence on the performance of the adhesive.
不同的环氧固化体系的性能存在较大差异，改性材料的种类和用量对结构胶的性能也存在不同程度的影响。
The influences of surface treatments, the pressures during bonding process and the thickness of adhesive layer on shearing strength were investigated with epoxy resin-DDS curing system as adhesive.
采用环氧树脂-DDS固化体系作为胶接剂，探讨了各种金属表面处理方法、胶接时对胶接面施加的压力、胶层厚度等因素对胶接剪切强度的影响。
This paper gives the adhesive principle between wheel and rail and puts forward the design methods of a locomotive's anti slip system.
在阐述轮轨间的粘着和空转产生机理的基础上，提出了机车防空转系统的设计原则。
The modified polyester hot melt adhesive has lower viscosity and cost of system in the condition that the adhesive properties are ensued.
该热熔胶在保证粘接性能的前提下，降低了体系的黏度和成本。
The results of the experiments indicate that carbolated styrene-butadiene latex system can endue the pretreatment with adhesive performance at the same time reduce the cost of pretreatment greatly.
一是采用了国产价廉的羧基丁苯胶乳代替进口价高的丁吡胶乳，实验结果表明，羧基丁苯胶乳体系可使预处理获得一定的粘合性能，同时可以大大降低预处理成本；
The stress-strain curves of a copper wire and a structure adhesive film tested with the system are given.
最后采用该系统对金属铜丝和一种结构胶粘剂薄膜进行了拉伸测试。
A system and method for rupturing an encapsulated adhesive in a, sheet media (12) USES an activator unit (24).
一种使封装在片形介质(12)中的粘合剂破裂的系统和方法使用了激活装置(24)。
This paper reviewed the pre - sent state, research goal and the method of latent system curing at moderated temperature, which was used as the curing agent of structural adhesive.
本文综述了结构胶粘剂的潜伏性中温固化体系的现状、研究方向和方法。
The curing system of a middle-low temperature curable epoxy film adhesive SY-70 was determined by the choices of proper accelerator and its content.
通过选择合适的促进剂及其用量，确定了中低温固化环氧胶膜sy- 70的固化体系。
Highly effective composite pipeline reinforcement system containing fast-curing adhesive , composite wrap materials and process was investigated in this thesis .
研究了含缺陷输油管道的复合材料修复技术，制备了复合材料修复技术用室温固化胶粘剂和复合材料卷材。
The development, production process, features of raw materials and the influence of the amount of powder adhesive on the performance of multi-layer coating system are introduced.
介绍了复层建筑涂料的研制、生产、原材料特点以及胶粉不同掺量对复层涂料性能的影响；讨论了施工过程中的注意事项。
Epoxy system and spout adhesive approach to international level.
环氧胶系列和喷胶已达到国际领先水平。
The adhesive of low temperature heat conduction and insulation is utilized to the seal end and bend to install the surface temperature sensor of the hydrogen oxygen engine system.
一种低温导热绝缘胶粘剂用于氢氧发动机系统表面温度传感器的端封和胶接安装。
The fatigue performance of the elastic steel plate and the adhesive layer of the weigh-in-motion system is studied as key point.
通过疲劳试验，重点研究了基于光纤光栅的弯板式动态称重系统弹性钢板和光纤光栅胶层的疲劳性能。
Thus, new technology of XPS plate insulation system bonded by adhesive polystyrene granule is suggested, and its key matching materials and technologies are introduced.
提出胶粉聚苯颗粒贴砌挤塑板外墙外保温系统，并介绍了该系统的关键配套材料和技术。
The invention relates to the field of building materials, in particular to a flexible tile adhesive used for an external thermal insulation system, and a construction technology.
本发明涉及建材领域，具体涉及外保温系统用柔性瓷砖粘结剂及其施工工艺。
The paper designs a computer_based automatic testing system of molding compress of non-adhesive agricultural straw.
采用模拟压缩的方法 ，研究了低密度秸秆碎料凸向模压成型的流变特性及主要影响因素。
The paper designs a computer_based automatic testing system of molding compress of non-adhesive agricultural straw.
采用模拟压缩的方法 ，研究了低密度秸秆碎料凸向模压成型的流变特性及主要影响因素。
应用推荐