This current also has an AC component.
该电流还有一个交流分量。
Magnitude of AC component can be specified.
可指定交流分量的大小。
These pulsations are known as the ac component of the rectifier output.
但是整流器的输出并不是纯粹的直流，而是脉动直流。
DC current or voltage source. Magnitude of AC component can be specified.
直流电流源或电压源。可指定交流分量的大小。
But there's a secondary field impressed on these magnets using an AC component.
但有一个次要领域的深刻的印象就这些磁体使用的是交流复合组件。
Meanwhile, a slight AC component was added to excitation current to decoupling speed estimation and rotor resistance.
同时，为了使转速估计和转子电阻的辨识解耦，在励磁电流处叠加了小幅交流分量。
As the frequency of the AC component increases, the DC meter response decreases, until at some frequency only the average input voltage will be displayed.
当交流分量的频率增加时，直流仪表的响应就会变得不够快，直到在某一频率时，仪表只能显示出输入电压的平均值。
The DC signals after demodulation still contain AC component of one or several frequencies respectively for multiplication or diode methods, but no AC component for multiplication-Division one.
对静态位移的测量，二极管检波或乘法检波后分别得到的是一含多频或单频交流成分的脉动直流信号，而乘除法检波后信号不含交流成分。
This paper analyzed AC servo heavy cutting feed system component parts and their actions, and built model about mechanical transmission equipment section.
分析了强力切削交流伺服进给系统各组成环节及作用，对机械传动装置部分建立了模型。
It can also be used to measure the AC voltage signal with superimposed DC component.
能测量含有直流分量的交流电压信号。
In this paper, a comprehensive method combined by DC component method, AC superposition method and loss current measurement method are described at first.
首先介绍了由“直流分量法”、“交流叠加法”和“损耗电流测量法”三者结合起来的综合判断方法，然后重点论述了交流叠加法的具体实现方案。
The design method about machine drive component and high - power ac motor is discussed. A engineering application case of 1000kn CNC brake - press is given.
提出了机械传动部件和大功率交流伺服电机的设计方法，并实际应用于1000kN数控折弯机中。
The design method about machine drive component and high - power ac motor is discussed. A engineering application case of 1000kn CNC brake - press is given.
提出了机械传动部件和大功率交流伺服电机的设计方法，并实际应用于1000kN数控折弯机中。
应用推荐