Additionally, since it is based on a serial interface, SAS allows for increased device support.
因为它基于串行接口，所以SAS允许增加设备支持。
At the same time I also expanded in this design, joined an one-chip computer, a serial interface, a USB interface.
同时在该设计里还进行了扩展，加入了一块单片机，一个串行接口，一个USB接口。
Examples of devices at this layer include the SLIP driver over a serial interface or an Ethernet driver over an Ethernet device.
例如，包串口使用的SLIP驱动程序以及以太网设备使用的以太网驱动程序都是这一层的设备。
Texas Instruments TLC5615 for U. S. products introduced in 1999, is a serial interface of the DAC, the output voltage type, maximum output voltage is twice the reference voltage value.
TLC5615为美国德州仪器公司1999年推出的产品，是具有串行接口的数模转换器，其输出为电压型，最大输出电压是基准电压值的两倍。
It monitors the health of a particular service (or services) through either a serial line or Ethernet interface or both.
它通过串行线、以太网接口或者同时使用二者来监测特定服务(或多个服务)的健康状况。
For example, if we want to provide an interface to a serial port using JNI, we could come up with two different interfaces. One version is in Listing 6.
举例来说，如果我们希望使用JNI为某个串行端口提供接口，则可以构造两种不同的接口。
ESATA External Serial ATA is a branch off of the Serial ATA interface that connects your hard drive to your computer if it was put together in the last couple of years.
eSATA外部串行ata是串行ata接口的一个分支，用来连接硬盘到电脑，如果是最近几年的推出的新硬盘的话。
The simplest way of getting the data from the Arduino is with the unit connected directly to a host computer Universal Serial Bus (USB) interface, reading the data as if it were a serial connection.
从Arduino获得数据最简单的方式是让此单元直接连接到主机计算机的UniversalSerialBus (USB)接口，像串行连接那样读取数据。
The most obvious issue is that the interface in Listing 6 requires a JNI call for each bit set or retrieved, as well as a JNI call to read a byte from, or write a byte to, the serial port.
最显著的一个问题就是，清单6中的接口在设置或检索每个位，以及从串行端口读取字节或者向串行端口写入字节都需要一个JNI调用。
The article introduces a design method of a general serial interface clock chip.
介绍了一种通用串行接口时钟芯片的设计方法。
A single microcontroller controls the entire stack of battery monitors via the SPI-compatible serial interface, and it also is the gateway to the main CAN bus.
单个微控制器通过spi兼容的串行接口控制整组电池监视器，该微控制器也是至主CAN总线的网关。
If the instruments have a GPIB or serial interface, you can control them with a computer equipped with a similar interface.
如果设备具有通用接口总线或串行接口，你可以通过一个带有相似界面的计算机来控制。
The AD7656 has both a high speed parallel and serial interface allowing the devices to interface with microprocessors or DSPs.
AD 7656同时具有一个高速并行接口和一个高速串行接口，为器件与微处理器或DSP进行接口创造了条件。
In apparatus having a standard serial communication RS-232C interface, can be realized with the computer or computer communication.
仪器具有标准串行通讯RS- 232c接口，可实现与电脑或计算机的通讯。
This paper introduces the application of a virtual instrument based on serial communication interface on medical device aiming for monitoring the fetus heart electric signal.
本文介绍了一个基于串行通信接口的虚拟仪器在医疗仪器方面的应用，本系统主要用于胎儿心电信号监测。
Since most serial interface configurations are already predefined, it is extremely seldom that there is a need to modify the communication functions listed below.
由于大多数串行接口配置已经预先确定的，这是极为少见，有必要修改的通信功能列在了下面。
USB(Universal Serial Bus) interface is a newly bus interface standard. It has flexible power supply mode, very high transfer rate and plug and play virtue.
接口是一种新兴的总线接口标准，它具有灵活的供电方式、较高的传输速率和即插即用等优点。
USB (Universal Serial bus) is a mainstream bus standard of PC peripheral interface, which extends its applications to industrial automatic instruments.
通用串行总线(usb)是目前PC外设接口的主流总线标准，并迅速在工业自动化仪器仪表中得到应用。
USB, namely Universal Serial Bus, is a novel interface connecting computer and peripheral equipments and is a great innovation in the connecting techniques of the peripheral equipments of computers.
通用串行总线是外围设备与计算机进行连接的新型接口，是计算机外设连接技术的重大变革。
This mixed mode interface combines the traditional analog sensor signal with a low cost serial digital link to access a transducer electronic data sheet (TEDS) embedded in the sensor.
这个混合模式的接口把传统的模拟传感器信号与低成本的串行数字连接结合在一起，以访问传感器的内嵌的传感器电子数据表（TEDS）。
Command line is in all simplicity a user interface which is based on lines of commands. You can say that it is a textual direct serial processor.
简单的说，命令行就是基于成行的命令的用户界面。您也可称其为一个文本化指令序列处理器。
The SDI-12 communication standard, a kind of serial data communication interface protocol, is widely used in environment monitoring in Euro-American countries.
本文推荐的SDI— 12通讯标准是近五年来欧美国家在环境监测中广泛使用的一种串行数据通讯接口协议。
The function of serial communication port in protocol tester was analyzed and a programmable multi-protocol serial communication interface circuit was designed.
分析了网络协议测试仪的串行通信接口功能，设计了一种可编程多协议串行接口电路。
ICS1523 is a high performance programmable line-lock clock generator with the I2C serial bus interface. User can use it to generate desired line-locked clock by programming it.
ICS1523是一种高性能可编程行同步信号发生器，它带有一个I2C串行总线接口，可以方便地对内部寄存器进行配置，能产生用户需要的同步信号。
When in Serial interface mode the AD7656 has a Daisy Chain feature allowing multiple ADCs to connect to a single serial interface.
在串行接口模式下，AD7656允许多个ADC以菊花链形式连接至单个串行接口。
Taking W77E58 and MAX3100 as example, the paper introduces a method of using I/O interface of singlechip to simulate Serial Peripheral Interface (SPI) at first.
以W77E58和MAX3100芯片为例，首先介绍了一种利用单片机I/O接口软件模拟串行外设接口（SPI）的方法。
This paper designs a simple and practical interface between serial AD/DA converter and DSP.
从软件和硬件两个方面设计了一种简单、实用的DSP与串行AD/DA转换器的接口电路。
SIM reads the card and the handset data interface is based on the PC machine serial port, USES a piece of 74hc14 chip to realize the interface function.
SIM读卡器和手机数据接口是基于PC机串行通信口，利用一片74hc14芯片实现接口功能。
Mode of serial port pair: synchronous clock device through the serial port read per second pair a serial output time information, serial port and RS232 interface and RS422 interface.
串行口对时方式：装置通过串行口读取同步时钟每秒一次的串行输出的时间信息对时，串行口又分为rs232接口和RS422接口方式。
Mode of serial port pair: synchronous clock device through the serial port read per second pair a serial output time information, serial port and RS232 interface and RS422 interface.
串行口对时方式：装置通过串行口读取同步时钟每秒一次的串行输出的时间信息对时，串行口又分为rs232接口和RS422接口方式。
应用推荐