这是一只电阻器。
Function as a resistor in normal operation condition.
正常情况下具电阻功能。
A resistor network in single inline package is developed.
研制了一种高精度、低温度系数单列直插式电阻网络。
This supply current can be set using a resistor on the I ADJ pin.
这电源电流可设定使用一个电阻的i调节脚。
Note 3: Connect a resistor, if necessary, to prevent malfunction due to noise.
注3：如有必要刻意串联一个电阻，以防杂波引起故障。
Figure 1 shows a schematic for an ideal current source driving a resistor load.
图1显示了一个理想的电流源驱 动的电阻负载的原理图。
A resistor is any device that, when you pass current through it, creates a voltage.
电阻是任何当电流通过时都能产生电压的元件。
A resistor is connected between each line and + 5v, so the idle state of the bus is high.
在+5V和每根线之间连接着一个电阻，所以总线的空闲状态是高电平。
He placed a resistor in parallel with the other only to make the current become greater.
把一个电阻与另一个并联，反而使电流变得更大了。
The converter uses a resistor to sense current signal instead of Hall sensor in addition.
另外，采用电阻替代霍尔传感器检测电流信号。
As the inventor pulled together the various components of the device, he needed a resistor.
由于发明人拉在一起的各种该设备的组成部分，他需要一个电阻器。
Using an FET current source instead of a resistor can speed things up, but this adds complexity.
若使用FET电流源来代替电阻器则可能使之加速，但这又增加了复杂性。
It used a transistor, a resistor, and a capacitor in the same configuration that Kearns had designed.
该雨刷的晶体管、电阻器和电容器的配置与卡恩斯的设计完全相同。
Circuit designers usually compensate for this by including a resistor known as a "tempco" in the circuit.
电路设计者通常会在电路中加入一个名为“温度系数(tempco)”的电阻器来进行补偿。
A resistor made of semiconductors having resistance that varies rapidly and predictably with temperature.
半导体制成的电阻，随温度可迅速变化，并可预测。
The invention provides to a rotary variable resistor and a method of adjusting a resistor value of the same.
本发明提供一种旋转型可变电阻器及其电阻值调节方法。
In the circuit shown in Figure 5-1, the gate of the SCR is connected through a resistor and diode directly to its anode.
在图5 - 1中所示的电路中，可控硅的栅极通过一个电阻器和二极管直接将其阳极连接。
CMOS bandgap reference (BGR) without a resistor, with a high power supply rejection ratio and output below 1v is proposed.
提出一种输出低于1V的、无电阻高电源抑制比的CMOS带隙基准源(BGR)。
Figure 2-39 shows an electrometer connected to a current source that consists of a voltage source in series with a resistor.
图2 - 39所示为静电计和由电压源及电阻器串联组成的电流源相连接。
YBCO samples, in parallel with a resistor, are connected in series with a transformer whose current is controlled by thyristors.
YBCO涂层导体与电阻并联，再与变压器串接，电流冲击由晶闸管控制导通和关断。
In fact, Chua calculated, it would behave like a resistor that could "remember" what current had flowed through it before (see diagram).
事实上，Chua已经计算出它会像一个能记忆之前经过的电流一样的电阻那样运作。
Many clock circuits also work with a resistor and capacitor as low-cost timing components or can be driven from an external source.
许多时钟电路也与电阻器和电容器一起使用作为低成本的时间组分或驱动外部输入。
Figure 2-24 shows a protection circuit for an electrometer ammeter or picoammeter, consisting of a resistor and two diodes (1n3595).
图2 - 24示出静电计或皮安计的过载保护电路，其中包括一个电阻器和两个二极管(1n3595)。
A popular design of quartz crystal oscillator USES a resistor, one or more logic gates, a quartz crystal and a couple of capacitors.
常见的晶体振荡电路一般由一只电阻、一个或多个逻辑门、一个晶体和两个电容器组成。
When we model a circuit, either informally or with a program such as SPICE, we generally assume that a resistor is a simple resistant.
在分析电路的时候，不论是粗略分析还是借助于SPICE这样的软件，通常都会视电阻器为纯电阻。
The system applied two sensor elements: NTC type high precision temperature sensor and a resistor type relative humidity sensor from Japan.
改系统适用于两个传感器要素：ntc型高精度温度传感器和电阻式相对湿度传感器来自日本。
It helps in analysis to scribble on the schematic a resistor in series with the inductor or transformer whose value is the winding resistance.
如果我们在绘制电路草图的时候就添加一个电阻和电感串联在一起，会是一个好办法。
In the theoretical analysis the load is supposed as a resistor to void the calculating error while the load is treated as a constant current source.
理论分析将负载作为电阻考虑，避免了将负载看作恒流源时给计算带来的误差。
In the theoretical analysis the load is supposed as a resistor to void the calculating error while the load is treated as a constant current source.
理论分析将负载作为电阻考虑，避免了将负载看作恒流源时给计算带来的误差。
应用推荐