In this paper, a numerical analysis of curved p.
本文提出了预应力曲线连续梁桥的数值分析方法。
A numerical analysis of the shortest length of headlight's filament is made in the paper.
根据设计规范的要求对线光源的最短长度进行了数值分析。
A numerical analysis of radiation and scattering of microstrip printed antenna is presented.
本文给出了一种分析微带印刷天线辐射与散射的数值方法。
Based on the results of the experiment, a numerical analysis by means of FEM was implemented.
用试验结果和断裂力学分析校正了有限元分析程序。
And a numerical analysis example was given, which verified the new approach's validity and correctness.
并设计给出了一个数值分析实例,对文中方法的正确性和有效性进行了验证。
A numerical analysis of dovetail joints is made, and the results are compared with that of laser-speckles measuring.
将边界元分析应用于航空发动机轮盘榫槽与叶片样头联接的计算,并与激光散斑法的实测结果进行比较;
Moreover, by using the technology of computer, this paper makes a numerical analysis for the morphology of lotus pollen.
同时利用计算机技术对白莲花粉形态进行了量化分析。
This paper presents a numerical analysis of inviscid equilibrium and nonequilibrium hypersonic flow past blunt-nosed slender cones.
本文给出钝头细长锥无粘、平衡和非平衡高超声速绕流流场的数值分析。
Based on the theory of commutation in DC machines, this paper describes a numerical analysis method for analysis of the commutation spark.
本文根据直流电机换向理论,给出了一种分析直流电机换向火花的方法。
Based on the theory of stability, a numerical analysis method of the membrane wrinkle is established, and the results are certified by experiments.
基于稳定性理论建立了薄膜褶皱的数值分析方法,通过实验的方法对分析结果进行了验证。
A numerical analysis method was presented to study the behavior of the laterally loaded pile considering the characteristic of the contact interface.
采用数值方法研究了桩土接触面特性对水平受荷桩受力特性的影响,并通过对工程实例的分析验证了计算方法的有效性。
The relationship between the press effect of clay by explosion and cylinder charge is discussed by a numerical analysis and calculation in this paper.
文中通过数值分析和计算,讨论了粘土爆炸压实效果与柱形装药之间的关系。
A numerical analysis to THC specimen by discontinuous displacement method is carried out. The tested results and numerically calculated ones are approximate each other.
用不连续位移法对该说件进行了数值分析,试验和数值分析计算结果相近。
A numerical analysis of a small network shows that the proposed model can reflect the real behavior of travelers in route choice from a stochastic transportation network.
最后在一个小型测试网络上对模型分配结果进行了测试,测试结果符合实际情况,表明模型能够较好地反映出行者的路径选择行为。
A mathematical model of multi-stage semi-conductor thermoelectric refrigeration in the transient state is presented and a numerical analysis is made of the two-stage types.
本文建立了多级半导体温差电冷台瞬态分析的数学模型。
Based on an axisymmetric unsteady conduction model by FEM, a numerical analysis model of unsteady heat transfer for the piston-liner coupling system of combustion chamber in an I.
本文在轴对称不稳定热传导有限元分析模型的基础上,提出了一个内燃机燃烧室的活塞与缸套偶合系统的不稳定传热数值分析模型。
This paper introduces a numerical analysis of semi-conductor devices by using the finite-element method combining with the coupled approach and the design of a corresponding modelling program.
本文采用有限元分析与耦合法相结合的方法对半导体器件进行数值分析,设计了相应的模拟程序;
A numerical analysis of the heat and mass transfer in a heat pipe type falling film absorber was carried out, in which solution absorption and removal of absorption heat happened through heat pipe.
对热管式降膜吸收器溶液吸收传热传质并通过热管移出吸收热的过程进行了数值研究。
A numerical analysis method is presented to simulate the shrinkage porosity formation in steel castings on the basis of heat flow, interdendritic fluid flow and possible evolution of dissolved gases.
提出了预测铸钢件中缩松缺陷的数值方法,考虑了传热、枝晶间液相流动和气体析出等因素。
Each factor was given a numerical value in the researchers' analysis.
在研究中,每个因素对应一个数值。
This is a important attempt for the numerical analysis methods of PDEs.
这将是对偏微分方程数值分析方法的新的重要尝试。
A numerical model based on the finite element method incorporating an arc-length algorithm for nonlinear full-range analysis of UPC beams was developed.
建立了基于有限元方法并结合一种弧长算法的适用于UPC梁非线性全过程分析的数值模型。
Numerical analysis and simulations show that this algorithm reduces the computational complexity significantly for the estimation of large frequency offset while maintains a good performance.
理论分析和仿真表明该算法在保证估计精度的同时,可显著降低大频偏估计的计算复杂度。
In the heat transfer analysis, combining temperature on tire side tested by drum test, a numerical inverse method is described for determining the heat convection boundary on tire side.
热传导分析中,依据实测的轮胎胎侧温度场,提出了一种基于实验的数值反演方法来确定胎侧的对流热边界条件。
Therefore, a new and functional numerical method and quantitative analysis method are provided.
因此对该类问题的研究提供了新的实用的数值解法和数值分析方法。
A numerical example shows that the structural analysis and optimization design model and method in this paper are valid and feasible.
算例表明:文中提出的随机结构分析和优化模型与设计方法是合理、可行和有效的。
A numerical model for steady state analysis and analytical expressions for the AM and FM modulation responses of DFB lasers are presented.
给出了适于分析DF B激光器稳态特性的数值模型和分析振幅及频率调制响应特性的解析模型。
A numerical model for steady state analysis and analytical expressions for the AM and FM modulation responses of DFB lasers are presented.
给出了适于分析DF B激光器稳态特性的数值模型和分析振幅及频率调制响应特性的解析模型。
应用推荐