A method for calculating the effective ratio is proposed in the paper.
在此基础上确定了抗倾有效比的计算方法。
Objective To find a method for calculating the scatter dose of irregular fields.
目的寻找一种可用于计算放射治疗不规则野的散射剂量的可靠方法。
Finally, a method for calculating the efficiency of practical packed column is given.
本文提供了一种计算真实填料塔效率的方法。
A method for calculating the rotating inertia of vibration structure was recommendation.
本文介绍了一种自动计算振动结构的转动惯量的方法。
A method for calculating the initial fields of WAPE by using the Green function is presented.
提出了计算宽角抛物方程初始场的格林函数法。
A method for calculating combination's damage and floatation stability is studied in the paper.
探讨了计算组合体破损浮态及稳性的一种方法。
A method for calculating the heat transfer coefficient of steam turbine casings is being presented.
提出了汽轮机汽缸传热系数的计算方法。
This paper puts forward a method for calculating shrink fit to replace the traditional empirical method.
本文给出一种组合活塞配合间隙(过盈)值的计算方法，可以替代以往单凭经验估算的传统方法。
A method for calculating the self inductance and distributed capacitance of the spiral inductor is described.
提出了一种计算圆形螺旋线圈自感和分布电容的方法。
In this paper, a method for calculating seismic vulnerability matrix of brick masonry structure is put forward.
本文提出一种计算砖砌体结构地震易损性矩阵的方法。
But neither can give a method for calculating the molecular energy levels and charge density of liquid crystals.
但是还没有关于液晶分子能级和电荷密度的计算方法。
This paper describes a method for calculating reverse recovery current parameters of the thyristor turnoff model.
本文论述了计算晶闸管关断模型反向恢复电流参数的一种方法。
A method for calculating circulation efficiency of ideal gas is provided, and it is used for ellipse circulation.
给出了一种计算理想气体循环效率的方法，并对椭圆循环效率做了具体计算。
A method for calculating the axial feed of expanding rod is also advanced through the analysis of expander's motion.
文中通过对胀管器的运动分析，导出胀杆的轴向进量计算方法。
Base on the experimental study, a method for calculating the base stress of the opened bottom cylinder structure is.
在此基础上，提出了沉入式无底圆筒结构基底压力的计算方法。
A method for calculating the interlobe sealing line with ordered corresponding points and a recurrence formula are proposed.
提出了对应点序列法与递推公式来求齿面密封线长度。
Using an empirical cumulative plastic strain formula, a method for calculating the traffic load induced deformation was proposed.
针对交通荷载作用下软土地基的变形问题，采用累积应变的经验公式计算其累积沉降。
The paper presents a method for calculating mass flow distribution and pressure losses in HP, IP and LP steam turbine extractions.
介绍汽轮机高、中和低压缸抽汽流道的流量分布和压损的计算方法。
This paper presents a method for calculating travel time of diffracted wave from velocity model and for making diffraction migration.
本文提出一种按速度模型计算绕射波射线旅行时和进行绕射归位的方法。
This paper presents a method for calculating magnetic torque of permanent magnet synchronous machine, which is called as flus method.
介绍了一种计算永磁同步电机电磁转矩的新方法，即磁通法。
A method for calculating torsional vibration when only part of the cylinders of the diesel engine are in operation has been developed.
本文对于内燃动力装置发动机在部分气缸运行下扭转振动的计算方法，系统地进行了分析和推导。
It constructs a method for calculating formation pressure using earlier well test data according to long shut-in pressure restore data.
并依据长关井压力恢复资料建立了利用早期试井资料计算地层压力的实用方法。
This paper describes a method for calculating the voltage distribution in EHV transformer windings during switching impulse withstand test.
本文阐述了一个计算超高压变压器在操作波耐压试验条件下线圈中电压分布的方法。
This paper presents a method for calculating the modal logarithmic decay ratio of the shaft set torsional vibration in a turbogenerator unit.
本文给出了一种汽轮发电机组轴系扭转振动模态对数衰减率的计算方法。
The paper introduces a method for calculating the heating load of initial station or heating station of hot oil pipeline, and gives proof to it.
为此，介绍了一种热油管道首站或加热站加热负荷的计算方法，以合理确定管道首站和中间站的热负荷。
This paper introduces a method for calculating the temperature rise of rotor bars and end rings of squirrel cage induction motor during starting.
本文介绍鼠笼型异步电动机转子笼条和端环起动温升的计算方法。
In this paper, a method for calculating track purity is proposed in order to realize the correlation between fusion tracks and true target tracks.
提出一种计算航迹纯度的方法，解决了融合航迹与目标真实轨迹的关联这一关键技术难题。
This paper provides a method for calculating the influence of parametric deviation of crank gear on balancing quality of internal combustion engines.
本文提出一种计算曲柄连杆机构参数偏差对内燃机平衡性能影响的方法。
This paper introduces a method for calculating the steady turning diameter of inland-water ships by using the nonlinear equations of steering motions.
本文采用非线性操纵运动方程，导出了一种计算内河船稳定回转直径的方法。
This paper presents a method for calculating heat conduction and thermo-elastic deformation of double-disk supported thrust bearing by means of ANSYS program.
介绍了ANSYS软件用于水轮发电机双托盘支撑推力轴承的热传导和热弹变形计算的方法。
应用推荐