Use a 5v external power supply.
使用一个5V外部电源。
Connect 5v power supply to the HDMI 1x4 Splitter.
把5v的电源和分配器连接起来。
There are two TVS diodes on this PCB for 5v and 12v protection.
有两台电视在这个电路板二极管为5V和12v的保护。
When battery voltage is less than 5V, voltage range switch should be set to 5V.
电池电压低于5V时，电压量程按钮开关应打在5V档上。
With low safe voltage USB joint, it only need 5v, 1w input, no noise and low consume?
使用超低安全电压usb接口，输入仅需直流5V、1w无噪音低耗量。
The 5v DC voltage can charge for MP3, MP4 mobile phones, and game through USB interface.
并配置了USB接口，对5V直流电压使用的MP 3、MP 4、手机、游戏机等进行充电。
A resistor is connected between each line and + 5v, so the idle state of the bus is high.
在+5V和每根线之间连接着一个电阻，所以总线的空闲状态是高电平。
The power module changes 5v input power into 3.3v and 1.8v, for supply the system energy.
电源模块的作用是将5v的输入电压转化为3.3 V和1.8 V输出，为系统供电。
The laser power can be adjusted by entering either 0 to 5v analog signals or PWM signals.
激光功率调节既可以输入0到5V的模拟信号，也可以输入PWM信号用以控制激光功率的大小。
At the moment, the 5v motor is being used in my helicopter which is still in very good condition.
目前，5v的马达是被用来在我的直升机目前还处于非常良好的条件。
The COM port 9-pin could not be set to VCC (5V power supply). Please check your cable or connected equipment.
不能将COM端口的第9 针脚色或者为VCC （5V电源）。请检查该COM接口的连接电缆及与之连接的设备。然后复位该设备或确认在工程的脚本设置中设置了5V电源。
Outputs are designed to be compatible with most 5v TTL circuits with options for higher voltage 12 and 15 VDC.
输出的设计与大多数5v的更高的电压为12和15伏直流选择ttl电路兼容。
U1A compares an adjustable sample of the present battery voltage to a 5V reference from a highly stable source.
一个5V参考比较目前电池电压可调的样品从一个高度稳定的收入来源。
A 5v line driver with complementary outputs is available for longer cable runs and higher electrical noise immunity.
带有互补输出5V的线路驱动器可用于较长的电缆运行和更高的电噪声免疫力。
If I can find a readily available Low Drop Out (LDO) 6 volt regulator I will use it but for now I have gone back to 5v.
如果我能找到一个现成的低压降(LDO的)6电压调节器，我会使用它，但现在我已经回到5V的。
The chip ensures the regulated 5v voltage output, in condition of no load, in the range from 2.8 to 5v of input voltage.
本芯片能够保证在2.8 ~5V的输入范围内，实现在空载条件下的稳定5v电压输出。
Moreover it installed a USB interface for MP3, MP4, and cell phone charging and for 5v DC battery and internal batteries recharge.
并配置了USB接口，也可对MP 3、MP 4、及手机充电或对使用5V直流电其机内电池进行充电。
The incremental encoders outputs are designed to be compatible with most 5v TTL circuits with options for higher voltage 12 and 15 VDC.
增量编码器的设计产出与大多数5v的更高的电压为12和15伏直流选择ttl电路兼容。
Moreover they are installed a USB interface for MP3, MP4, and cell phone charging and for 5V DC battery and internal batteries recharge.
并配置了USB接口，也可对MP3、MP4，及手机充电或对使用5V直流电其机内电池进行充电。
Using microcontroller MSP430F449 as the operation core, a low noise wideband amplifier provided with 5v single power supply is designed.
以单片机MSP430F 449为控制核心，设计了一个5V单电源供电的低噪声宽带放大器。
After simple liquid level sensor signals can be voltage signal, transforming the voltage signal is 0 ~ 5v, back to the transducer of the VR1-side.
经过简单液位传感器信号的转换，便可得到电压信号，转化的电压信号为0 ~5V，反馈给变频器的VR1端。
When charging the lithium battery, connect the camera with the USB interface of your computer or or use the 5v charger to charge the battery directly.
将机器连接到电脑usb接口或连接到DC5V充电器即可对内置锂电池进行充电。
The ramp voltage less than 0. 5v will be displayed after amplification. The circuit can be used as display unit for various electrochemical instruments.
小于0.5伏的三角波电压经放大后再显示，该电路可作为各种电化学仪器的显示单元。
The system's digital voltmeter circuit is simple, can measure the voltage 0 ~ 5v, and the four turns on the LED digital display or a single select Show.
该系统的数字电压表电路简单，可以测量0 ~5V的电压值，并在四位LED数码管上轮流显示或单路选择显示。
The LTC3633 operates from an input voltage of 3.6V to 15V, making it ideal for dual-cell Li-Ion applications as well as 5V and 12V intermediate bus systems.
LTC3633 在 3.6V至 15V的输入电压范围内工作，从而非常适用于两节锂离子电池应用以及5V和12V中间总线系统。
The camera USES 12v voltage supply, is no longer limited by the voltage drop of 5v power supply, then the distance is not afraid of the voltage is not enough.
摄像机采用12v电压供电，不再受5 V供电的压降限制，再远的距离不怕电压不足。
Transformation between 5v logical and RS-232 Many micro-controllers have asynchronous serial ports, but their input and output rather to use 5v logic than to RS-232 voltage.
在5V逻辑和RS- 232之间转换很多微控制器有异步串口，但是它们的输出和输入使用5 V逻辑而不是使用RS - 232电压。
With a supply current of just 8.5ma and the ability to run from a single supply voltage from 5v to 12v, these amplifiers offer very high performance for little power consumption.
随着供应公正八点五毫安，并能够从单电源电压从5V至12 V运行电流，这些放大器提供了非常高的小功率消耗。
With a supply current of just 8.5ma and the ability to run from a single supply voltage from 5v to 12v, these amplifiers offer very high performance for little power consumption.
随着供应公正八点五毫安，并能够从单电源电压从5V至12 V运行电流，这些放大器提供了非常高的小功率消耗。
应用推荐