齿面常见的失效形式有齿面点蚀、齿面磨损、齿面胶合和齿面塑性变形等。
Failure mode of tooth surface is varied such as teeth surface pitting, teeth wear, teeth bonding and teeth plastic deformations and so on.
以往点蚀监测只能采用离线的监测手段根据对齿面磨损颗粒的分析做出结论。
It is monitored previously only with off-line methods which are based on the analysis of debris weared.
给出了超环面行星蜗杆传动啮合效率、齿面磨损量和弹流油膜厚度的分布规律及其随传动参数的变化规律。
The distribution of engaging efficiency, EHD oil film thickness and tooth face wear and their changes along with transmission parameters are presented.
矿山机械设备中大模数直齿圆柱形齿轮使用较多，当齿面磨损一定程度后就要报废，现介绍几种修整翻新复用技术。
Spur gears were used more in mine machinery equipment, they would be abandoned if wore out. Kinds of technology were introduced here.
汽化程度与齿面温度及磨损状态有关。
The evaporation is affected by temperature and wearing condition of gear tooth flank.
这就意味着，由于一支齿轮上的每一个齿面将与另一个齿轮的齿面接触相同的次数，因此磨损面均匀的分布于齿轮的每一个齿上。
This means that wear is evenly distributed over the gears since each tooth on one gear touches on the other gear the same number of times.
磨合试验中还发现了因齿面副两表面磨损率差形成的负电阻现象。
The negative oil film resistance is also found in the running-in, which results from the wear rate difference of the pair.
对硬齿面齿轮在不同的磨损阶段的磨损特性进行了定性和定量分析。
The characteristics of gears in each wear stage were analysed qualitatively and quantitatively.
进一步关系研究发现，齿面发生故障时，相比磨损故障变化，振动信号反映故障的变化更敏感。
Further study on the correlation was provided that the changes of vibration signal were more sensitive than the changes of wear when the tooth surfaces of the gear broke down.
具有极佳的抗磨损、抗腐蚀、抗高温、抗重载性能，在低速高扭矩和高速冲击负荷的苛刻条件下有效保护齿面。
With excellent abrasion resistance, anti-corrosion, anti-high temperature, anti-heavy-duty performance, high torque at low load and high-speed impact of effective protection under harsh tooth.
燃油泵(卸油泵，高粘度泵，沥青泵)齿轮的磨损部位主要是齿的啮合、渐开线工作面和齿轮两端平面。
Fuel pump (unloading pump, high viscosity pump, asphalt pump) gear wear and tear parts mainly is the tooth meshing, involute face and gear ends plane.
燃油泵(卸油泵，高粘度泵，沥青泵)齿轮的磨损部位主要是齿的啮合、渐开线工作面和齿轮两端平面。
Fuel pump (unloading pump, high viscosity pump, asphalt pump) gear wear and tear parts mainly is the tooth meshing, involute face and gear ends plane.
应用推荐