线路驱动器输出。
高功率免费线路驱动器输出保证清洁，多长的电缆长度清晰的信号。
High power complimentary line driver outputs assure clean, crisp signals over long cable lengths.
高功率，互补，线路驱动器输出保证干净，长电缆长度超过清晰的信号。
A high power, complementary, line driver output assures clean, crisp signals over long cable lengths.
高功率，互补，线路驱动器输出，保证廉洁，在长距离电缆长度清晰的信号。
High power, complementary, line driver outputs assure clean, crisp signals over long cable lengths.
在回送模式中，驱动器输出在内部与接收器输入相连，建立一个内部信号通路以方便诊断测试。
While in loopback mode, driver outputs are internally connected to receiver inputs creating an internal signal path convenient for diagnostic testing.
本文就利用栅极电荷特性的考虑，介绍了一些计算用于开关igbt的驱动器输出性能的方法。
This article takes gate charge characteristics into account and then introduces some methods for calculating output performance of drivers used for switching IGBTs.
水平起始掩蔽信号使开关截止，直到供应从源极驱动器输出的与液晶面板的图像数据对应的信号为止。
The horizontal start masking signal turns off the switches until signals output from the source driver, which correspond to image data of the liquid crystal panel, are supplied.
在点对点应用中(每驱动器输出对一个接收器输入)，设计DOC电路驱动原本为容性的CMOS输入的器件。
DOC circuitry is designed to drive CMOS input devices, which are capacitive in nature, in point-to-point applications (one receiver input per driver output).
图2展示安装路径已经更改为一个拥有足够空间、可以处理将被比较的所有输出的驱动器。
Image 2 shows that the installation path has been changed to a drive that has sufficient space on it to handle all the outputs that will be compared.
建议将LifecycleManager安装在拥有足够磁盘空间的驱动器上，以便存储Lifecycle Manager将检索的所有输出。
It is recommended that Lifecycle Manager be installed on a drive that has sufficient disk space to store all the output that will be retrieved by Lifecycle Manager.
设备驱动器是专门的方案，允许特定输入或输出设备进行通信与计算机系统的其余部分。
Device drives are specialized programs that allow particular input or output devices to communicate with rest of the computer system.
步进马达驱动器在输出设备中排在首位。
有低的差动输出阻抗绝大多数的线路驱动器，同时也固有地有低的共模输出阻抗，这样，低阻抗桥臂几乎无一例外地位于驱动器一侧。
Most line drivers with low differential output impedance will also have inherently low common-mode output impedances, so the low impedance arms of the bridge are almost always at the driver.
输出表的名称是输出表的名称（和驱动器的路径），将创建一个包含空间统计。
Output Table Name is the name (and drive path) of the output table that will be created containing the spatial statistics.
通过使用串行数据输出，驱动器可级联需要附加驱动线路的接口应用。
By using the serial data output, drivers can be cascaded for interface applications requiring additional drive lines.
但是由于受到其它非线性效应的限制，SBS激光系统的输出能量都还不能满足运用到ICF激光驱动器中的要求。
However, because of limits of other non-liner effect, SBS laser system's energy output can not satisfy the request of applying on ICF laser drivers.
每个器件都有一个八位CMOS移位寄存器和CMOS控制电路，八个CMOS数据锁存，八个双极电流吸收达林顿输出驱动器。
Each device has an eight-bit CMOS shift register and CMOS control circuitry, eight CMOS data latches, and eight bipolar current-sinking Darlington output drivers.
电磁型微马达以其输出力矩大、运行寿命长、易于实用化的优点成为微机电系统、微型机器人和微型可动部件理想的驱动器。
Electromagnetic micromotor is an ideal micro actuator for MEMS, micro robot and micro movable elements, because of it's large output torque, long lifetime and easy in practical applications.
实验系统由计算机、激光传感器、A／D转换器及输出功率驱动器等实验装置组成；
The control system are consisted of computer, laser sensor, A/D converter and the power driver of output etc.
步进马达驱动器在输出设备中排在首位。
功率放大器的输出误差、压电陶瓷的洄滞及蠕变误差、驱动器之间的耦合误差等是影响机器人运动精度的关键因素。
Output errors of power amplifiers, hysteresis and creep error of PZTs and coupling error among the actuators are the critical factors affecting the motion accuracy of micromanipulator.
在实验的基础上分析了该驱动器的输出性能。
The output performance of this linear actuator is analyzed based on experiments.
报导了用于机器人多指灵巧手的精密微型直线驱动器，它体积小、输出力大。
A miniature linear actuator for the multifingered dexterous robot hand was reported, it is small, but takes on great output force.
超磁致伸缩材料的热变形严重影响驱动器的输出精度。
The thermal-deformation of the magnetostrictive material will influence the output accuracy of the actuator seriously.
带有互补输出5V的线路驱动器可用于较长的电缆运行和更高的电噪声免疫力。
A 5v line driver with complementary outputs is available for longer cable runs and higher electrical noise immunity.
在机构的弹性杆件上贴上压电陶瓷片作为驱动器，通过测量弹性杆上输出点的动态应变，确定机构动力系统的状态，实时地进行最优反馈控制。
The state of the dynamic system is determined by measuring the dynamic strains of the output points at the flexible links, and the real time optimal feedback control in operated.
此LED驱动器包括可周期性地输出调变周期的时脉源。
The LED driver includes a clock supply to periodically output a modulation period.
压电陶瓷迟滞特性是影响压电陶瓷驱动器位移输出精度的主要因素。
Hysteresis characteristic is the main factor affecting the accuracy of PZT's output displacement.
压电陶瓷迟滞特性是影响压电陶瓷驱动器位移输出精度的主要因素。
Hysteresis characteristic is the main factor affecting the accuracy of PZT's output displacement.
应用推荐