在测量一个器件，如电容器上的电荷时，重要之点是要首先关闭静电计的零点检查功能，然后再将电容器连到高阻抗输入端。
When measuring the charge on a device such as a capacitor, it's important to disable the zero check of the electrometer first, and then connect the capacitor to the high impedance input terminal.
如果输入端的短路点具有很低的热电动势，用这种方法就可以验证输入噪声和零点随时间的漂移。
If the short circuit has a very low thermoelectric EMF, this can be used to verify input noise and zero drift with time.
在目前这个设计中，阶跃输入信号限制在零点几毫伏以下。
In the present design, step inputs are restricted to a few tenths of millivolt.
输入整形技术采用频域的零点配置方法设计多峰鲁棒输入整形器用来进一步减小负载的瞬时振荡，保障安全作业；
The transient vibration is reduced further for safety problems by the input shaping technique which utilizes zero placement method in the frequency domain to design multi-hump robust input shapers.
借此模型，克服零点漂移及增益漂移对检测精度的影响，补偿信号输入通道的非线性，实现了数据的规范化处理。
Based on this model both zero and gain drifts of the input channel can be corrected and its nonlinearity can be offset. Furthermore, the data normalization can also be done.
采用左右对称的输入输出耦合结构便于调整滤波器的传输零点，从而改善带外特性。
Tapped coupling can be used to change the transmission zeros so that the performance of filter is improved.
对于单输入-单输出系统，它的零点取决于系统的输出函数。
For single input single output linear system, its zeros were determined by the output function of system.
对于单输入-单输出系统，它的零点取决于系统的输出函数。
For single input single output linear system, its zeros were determined by the output function of system.
应用推荐